BMR Suspension DSL015 User Manual

DRIVESHAFT SAFETY LOOP INSTALLATION

DSL015– 2010 Camaro Automatic

RECOMMENDED TOOLS:

(2) 9/16” wrenches, (1) 19mm socket
15mm, 19mm socket
3/8” drive ratchet or impact
Hydraulic jack and jack stands or Hydraulic service lift
Drill with 3/8” drill-bit

INSTALLATION:

1. Lift vehicle and support safely under frame rails.

2. Support the transmission using a jack stand or jack.

3. Using a 15mm socket, remove the (2) transmission mount nuts.

4. Usi

5. Position the

6. Once positioned correctly, clamp or bolt

7. Mark the cross-member for drilling using

8. Remove the BMR mounting bracket and

9. Using the supplied 3/8” x 1” bolts,

10. Position the assembly up into place on the transmission and

11

12. Slide the BMR “loop” up and over the driveshaft and line the

13. Insert the supplied 3/8” x 1” bolts and nuts into the mounting

14. Lower vehicle.

ng the same socket, remove the (4) transmission cross-member

bolts then remove the cross-member.

main BMR mounting

bracket onto the factory cross-member as
shown in Image 1. Make sure that the
BMR bracket sits flush on the top
surface and make sure the holes in the
BMR bracket line up with the holes on
the OE cross-member.

the bracket into place.

the 3/8”mounting holes as a guide.

drill the two holes into the factory cross­member as shown in Image 2.

washers and nuts, bolt the BMR
mounting bracket to the OE
crossmember but do not tighten. Insert
and tighten the provided 14mm bolts and
nuts into the top holes. Tighten to 90 ft/lbs. Now tighten the 3/8” bolts to 45 ft/lbs.

thread the (2) mounting nuts onto the transmission mount studs to
hold the assembly in place. (Image 3)

. Install the 4 factory bolts into the cross-member and tighten them

to 42 ft/lbs. Tighten transmission mount nuts to 42 ft/lbs as well.

mounting holes up with the mounting b racket holes.

holes and tighten with (2) 9/16” wrenches. (Image 4)

WWW.BMRFABRICATION.COM

This product is an aftermarket accessory and not designed by the vehicles manufacturer for use on this vehicle. As such, buyer assumes all risk of

any damage caused to vehicle/person during installation or use of this product.

1