BMR Suspension DSL014 User Manual

DRIVESHAFT SAFETY LOOP INSTALLATION

DSL014– 2010 Camaro M6

RECOMMENDED TOOLS:

(2) 9/16” wrenches
15mm socket
3/8” drive ratchet or impact
Hydraulic jack and jack stands or Hydraulic service lift
Drill with 3/8” drill-bit

INSTALLATION:

1. Lift vehicle and support safely under frame rails.

2. Support the transmission using a jack stand or jack.

3. Using a 15mm socket, remove the (2) transmission mount nuts.

4. Using the same socket, remove the (4) transmission cross-

member bolts then remove the cross-member.

5. Position the main BMR mounting bracket onto the factory cross-

member as shown in Image 1. Make sure that the BMR bracket sits flush on
the transmission mount surface and make sure the holes in the BMR bracket
line up with the holes on the OE cross-member. Once positioned correctly, it

may be easier to
proceed if the
bracket is
clamped to the
cross-member.

6. Turn the cross-

member/bracket
assembly upside
down and mark
the cross­member for
drilling using
the mounting
holes as a guide.
See Image 2.

7. Remove the BMR mounting bracket and drill the two holes into the factory

cross-member as shown in Image 3.

8. Using the supplied 3/8” x 1” bolts, washers and nuts, bolt the BMR

mounting bracket to the OE crossmember as shown in Image 4.

1

DRIVESHAFT SAFETY LOOP INSTALLATION (Cont.)

DSL014– 2010 Camaro M6

9. Position the assembly up into place on the transmission and thread the (2) mounting nuts onto the transmission mount studs

to hold the assembly in place. (Image 5)

10. Slide the provided spacers under the cross-member mounts as shown in Image 6 then install the 4 factory bolts into the cross-

member. Tighten the (4) mounting bolts to 42 ft/lbs. Tighten transmission mount nuts to 42 ft/lbs also.

11. Slide the BMR “loop” up and over the driveshaft and line the mounting holes up with the mounting bracket holes.

12. Insert the supplied 3/8” x 1” bolts and nuts into the mounting holes and tighten with (2) 9/16” wrenches. (Image 7)

13. Lower vehicle.

WWW.BMRFABRICATION.COM

This product is an aftermarket accessory and not designed by the vehicles manufacturer for use on this vehicle. As such, buyer assumes all risk of

any damage caused to vehicle/person during installation or use of this product.

2