BMR Suspension BK039 User Manual

Delrin Upper Control Arm Bushings

BK039

Required Tools:

Hydraulic jack and 2 stands (lift optional but recommended)
Wrenches – 18mm, 21mm
Sockets – 10mm, 13mm, 18mm, 21mm
Pry-bar

Installation:

1. Lift vehicle and support with stands under the rocker jack points as shown in

Image 1 below.

2. Remove both rear wheels.

3. Using a 15mm socket, remove the driveshaft tunnel brace. See Image 2.

4. Using a 15mm socket, loosen the

exhaust clamps at the front of the
exhaust.

5. Using a helper, slide the rear muffler

mounts off the mounting dowels
(Image 3) and then pull the entire
exhaust assembly rearward and out of
the car.

Continued

Delrin Upper Control Arm Bushings

BK039 (Continued)

6. Using a 10mm socket, remove the front driveshaft

tunnel exhaust shield. See Image 4. This will
prevent the driveshaft from damaging the shield
when lowering the rear cradle.

7. Un-plug the fuel pump wiring harness located on

the passenger side of the car next to the front cradle
bushing. See Image 5.

8. Support the cradle with a hydraulic jack or

adjustable frame stands.

9. Twist the emergency brake cable while pulling up

to “release” it from the bracket attached to the

upper control arm on each side. Image 6.