BMR Suspension BK027 User Manual

Delrin

Rear Subframe Bushings

BK027

Required Tools:

Hydraulic jack and 2 stands (lift optional but recommended)
Wrenches – 18mm, 21mm
Sockets – 10mm, 13mm, 18mm, 21mm
Pry-bar Rubber Mallet

Sawzall

Installation:

1. Lift vehicle and support with stands under the

rocker jack points as shown in Image 1
below.

2. Remove both rear wheels.

3. Using a 15mm socket, remove the driveshaft

tunnel brace. See Image 2.

4. Using a 15mm socket, loosen the exhaust

clamps at the front of the exhaust.

5. Using a helper, slide the rear muffler mounts

off the mounting dowels (Image 3) and then
pull the entire exhaust assembly rearward and
out of the car.

Continued

Delrin Rear Subframe Bushings

BK027 (Continued)

6. Un-plug the fuel pump wiring harness located

on the passenger side of the car next to the
front cradle bushing. See Image 4.

7. Twist the rubber brake line while pulling up

to “release” it from the bracket attached to the
upper control arm on each side. Image 5
below.

8. Using an 18mm socket or wrench, remove the

(2) bolts that hold the caliper to the spindle
(Image 6). Remove the caliper and tie it up
out of the way with a zip tie.

Continued