BMR Suspension BK024 User Manual

REAR SUBFRAME BUSHINGS

BK024

Required Tools:

Hydraulic jack and 2 stands (lift optional but recommended)
Wrenches – 18mm, 21mm
Sockets – 10mm, 13mm, 18mm, 21mm
Pry-bar
Sawzall w/long blade

Installation:

1. Lift vehicle and support with stands under the rocker jack points as shown in Image 1 below.

2. Remove both rear wheels.

3. Using a 15mm socket, remove the driveshaft tunnel brace. See Image 2.

4. Using a 15mm socket, loosen the exhaust clamps at the front of the exhaust.

5. Using a helper, slide the rear muffler mounts off the mounting dowels (Image 3) and then pull the

entire exhaust assembly rearward and out of the car.

Continued

Rear Subframe Bushings

BK024 (Continued)

6. Un-plug the fuel pump wiring harness located on the passenger side of the car next to the front cradle

bushing. See Image 4 on previous page.

7. Twist the rubber brake line while pulling up to “release” it from the bracket attached to the upper

control arm on each side. Image 5 below.

8. Using an 18mm socket or wrench, remove the (2) bolts that hold the caliper to the spindle (Image 6).

Remove the caliper and tie it up out of the way with a zip tie.

9. Using Image 7 above as a guide, locate and unplug the ABS plug located above the rear cradle.

10. Detach the emergency brake cables from the spindles. (Image 8)