BMR Suspension BK018 User Manual

FRONT LOWER CONTROL ARM BUSHINGS (BK018)

Required Tools:

• Hydraulic jack and 2 stands (lift optional but recommended)

• Wrenches – 18mm

• Sockets – 18mm, 21mm

• Pry-bar

• Brass hammer

Installation:

1. Lift vehicle and support with

stands under the rocker jack points
or K-member.

2. Remove both front wheels/tires.

3. Using an 18mm socket and

wrench, remove the inner
mounting bolt on the lower control
arm. See Image 1 to the right.

4. Using a 21mm socket, remove the outer ball

joint nut. See Image 2 to the right.

5. Knock the ball joint loose from the spindle

using a brass hammer.

6. Remove the control arm.

Continued

1

FRONT LOWER CONTROL ARM BUSHINGS (Cont.)

7. Using a bushing removal tool or hydraulic press, remove the OE rubber bushing

from the control arm.

8. Insert the BMR polyurethane

bushings into the control arm with
the machined surface of the bushing
facing towards the front of the car
(See image to the right). Lube the
inside of the bushing and insert the
center sleeve.

9. Re-install the control arm,

duplicating the above steps.
Tighten the inner mounting bolt to
85 ft/lbs.

10. Install wheels/tires and lower

vehicle.

WWW.BMRSUSPENSION.COM

This product is an aftermarket accessory and not designed by the vehicles manufacturer for use on this vehicle. As

such, buyer assumes all risk of any damage caused to the vehicle/person during installation or use of this product.

2