BMR Suspension BK009 User Manual

Front Lower Control Arm Bushings

BK009

Required Tools:

• Hydraulic jack and 2 stands (lift optional but

recommended)

• Wrenches – 18mm

• Sockets – 18mm, 21mm

• Pry-bar

• Brass hammer

Installation:

1. Lift vehicle and support with stands under

the rocker jack points or K-member.

2. Remove both front wheels/tires.

3. Using an 18mm socket and wrench, remove the inner

mounting bolt on the lower control arm.

4. Using a 21mm socket, remove the outer ball joint nut.

5. Knock the ball joint loose from the spindle using a

brass hammer or equivalent.

6. Remove the control arm.

7. Using a bushing removal tool or hydraulic press,

remove the OE rubber bushing from the control arm.

8. Insert the BMR polyurethane bushings into the radius

rod. Lube the inside of the bushing and insert the
center sleeve.

9. Re-install the control arm duplicating the above steps.

Tighten the inner mounting bolt to 85 ft/lbs.

10. Install wheels/tires. Lower vehicle.

WWW.BMRFABRICATION.COM

This product is an aftermarket accessory and not designed by the vehicles manufacturer for use on this vehicle. As

such, buyer assumes all risk of any damage caused to the vehicle/person during installation or use of this product.

1