BMR Suspension BK002 User Manual

Rear Cradle Bushings

BK002

Required Tools:

Hydraulic jack and 2 stands (lift optional but recommended)
Wrenches – 18mm, 21mm
Sockets – 10mm, 13mm, 18mm, 21mm
Pry-bar

Installation:

1. Lift vehicle and support with stands under the rocker jack points shown in Image 1.

2. Remove both rear wheels.

3. Using a 15mm socket, remove the driveshaft tunnel

brace. Image 2.

4. Unplug the rear O2 sensors as shown in Image 3.

5. Using a 13mm socket, remove the two bolts

that hold the rear two muffler brackets in
place. Remove 4 bolts total, 2 per side. See Image 4.

1

Rear Cradle Bushings

BK002 (Continued)

6. Using a 15mm socket, remove the 4 front flange bolts on the exhaust (2 per side). See Image 5 on
previous page.

7. Remove center 15mm exhaust hanger bolt in rear. See Image 6.

8. Using a helper, remove the entire exhaust assembly.

9. Un-plug the fuel pump wiring harness located on the passenger side of the car next to the front cradle
bushing. See Image 7 above.

10. Support the cradle with a hydraulic jack or adjustable frame stands.

11. Using a 21mm socket, remove the (4) cradle mounting bolts as shown in Image 8.

2