Blue Wave Pools NB2615 Instruction Manual

ASS E MBLE Top Seat, V ertical an d Co ver
7 FRAM E

a ) PRE-ASSEM BLING VERTICALS

Put Resin Upper Joi nt as shown in the
Figure,tighten up #12 Sheet M etal
Screws.

3/4

P.No.0341

#12 Sheet Metal Screw

P.No.0341

#12 Sheet Metal Screw

b ) INSTALLING VERTICA LS

Hook Assembled Resin Upper Joint
over the top rail. Secure t he bot tm of
vertical to Resin Lower Joint by #12
Sheet Meal Screws, Continue installing
vertical s i n this manner
All ar ound t he pool.

c ) INSTALLI NG TOP SEATS

Place each of the top seat over the upper joints and
secure with #12 Sheet Metal Screws.

Install all of top seat in this way around entire pool.
Top seat are installed between v er ticals.
Each end of t op seat r est on upper joint and
attached to it.
It may be necessary to move the complete verticals
slightly to left or right to accommodate the top seat.
Do this carefully as not disturb the earth mound,
Check all screws to be sure they are tight.

ALL THESE POOLS ARE DESIGNED FOR SWIMMING ONLY.

THEY MUST NOT BE US E D F OR J UMPING OR DIVING.

DO NOT

JUMP

DO NOT

DIV E

PERMANET INJURY OR DEATH CAN RESULT.

P.No.0341

#12 Sheet Metal Screw

d ) INSTALLING SEAT COVERS

3/4

P.No.0341

#12 Sheet Metal Screw

Put smaller cover to inside of joint, vartical.
Put #12 Sheet Met al Screw then ti ghten up.
Put larger c over t o outside of joint, vert ical and
slide into small er c over.
Put #12 Sheet Met al Screw to Lower hole of
side of vertical as shown. do the same on the
other side of vertical s.

Note: left side of Top seat on the figure not
shown for easy understanding, but ac tually top
seat should be attached before this procedure.

FOR OVAL POOL ONLY

e ) INSTALLI NG OVAL SIDE TOP SEAT AND
SIDE SEAT COVERS

Use #12 Sheet Metal Screw to Install oval si de top
seats on top of Resin side upper joint P. No.3177.
Cut two prong of inside of side seat cover as shown
in the figure, then attach side seat cover by placing
it from inside of pool in right position as shown in
the figure.
Put #12 Sheet Met al Screw to side seat cover and
tighten it up. Put seat cover cap on top of side seat
cover.

P.No.0341

#12 Sheet Metal Screw