Page 1
4
The most friendly carkit !
WELCOME
Thank you for purchasing the Bluetrek carkit.
Before using this product, please charge your carkit
for 2 hours and read the safety and quick start guide
carefully.
GET ASSISTANT
Consumer Care and Technical Support
US & Canada : care@bluetrek.com
Toll free number for US only : 1-888-927-BLUE
(Operation hours : Central Time Zone 8:00am- 5.30pm)
Others : support@bluetrek.com
ABOUT SPEAKY
LED
indicator
Volume
Up (VOL+)
TALK button
Volume
Down (VOL-)
MicroUSB
charging socket
Speaker
ON/OFF
switch button
3.5mm
audio-in socketMicrophone
CHARGING
When you hear the voice prompt “please charge me
up!”, your SPEAKY needs to be recharged. SPEAKY can
be charged by the USB cable or with the Car Charger
provided in the pack, or by any standard MicroUSB plug.
NOTE:
SPEAKY is using Universal MicroUSB socket, hence can be used
˙
other share cable from other manufacturer.
To avoid any system conflict we recommend SPEAKY switched off
˙
before charging when battery is extremely low.
1 2
SWITCHING ON/OFF
1
ON/OFF switch button
ON
Slide the Mechanical ON/OFF button
to the right. The blue indicator will
begin to flash and the voice prompt
“Hi what’s up?” will be heard.
OFF
Slide the Mechanical ON/OFF button to left. The red
indicator light will flash once and voice prompt “Bye
bye” will be heard.
AUTOMATIC ON/OFF
SPEAKY enters sleep mode automatically when it loses
connection with your mobile phone for more than 5
minutes. It switches on automatically when the build-in
motion sensor is triggered, e.g. when you open the door
of your car. The automatic power on function can be
de-activated by switching off the carkit mechanically.
1
ONOFF
VOICE PROMPT
The following is a comprehensive list of the available
voice prompts.
Voice Prompts Carkit Operation
Hi, What's up?
I am ready to pair!
Now you can use your phone!
Where is your phone?
Ready to speak!
I lost your phone!
Calling last number
Call over
Please charge me up!
Bye bye!
Power On
Enter Pairing Mode
Pairing Successful
Pairing Failed
Connected
Disconnected
Last Number Redial
End Of Call
Low Battery
Power Off
PAIRING
1
Place the SPEAKY and your mobile phone within 0.3
meter (1 foot) from each other.
3
2
Switch on your phone and
select Bluetooth® discover
mode (refer to your mobile
phone user manual).
3
Switch on SPEAKY, press and hold
the TALK button for about 3
seconds until the indicator light
flashes Red & Blue alternately and
the paring voice prompt (“I am
ready to pair!”) can be heard from
the speaker.
If SPEAKY is switched on for the first
time, it will go to pairing mode automatically.
Once your mobile phone detects the SPEAKY, a
“BLUETREK SPEAKY” message will be displayed on
the screen.
4
5
Follow the phone instructions to accept the pairing.
The PIN code (or passkey) is 0000. If your phone
supports Secure Simple Pairing (SSP), there is no
need to enter a PIN code.
4 5 6
BLUETREK SPEAKY
BLUETREK SPEAKY
BLUETREK SPEAKY
For some phones, you may need to select “Connect”
after paired (refer to your mobile phone user manual).
NOTE: If pairing is not completed within 5 minutes, the carkit
will be switched off automatically. You must then power on
your SPEAKY and start the pairing again.
5
Page 2
RE-CONNECTION
The carkit attempts to reconnect for 3 minutes if your
mobile is out of range.
If you move back in range, you can
manually reconnect by pressing the
TALK button or Switch ON again.
BASE FOR SPEAKY
2 sets of Velcro base are
provided in the pack.
Stick one side under the
Speaky and the other
side (the base) within an
arm’s length from you at
driving position
* .
Attach SPEAKY to the
base with it’s feet
pointing at you.
* approximate 60-70cm
Stick
Velcro
base
Micro
phone
6
LISTENING TO MUSIC
If your mobile phone supports A2DP profile, you can
use the SPEAKY carkit to listen to the music stored in
your phone when the two devices are connected.
Also SPEAKY can be your mini-portable speaker when
connected to an audio device at the 3.5mm jack
located at the back.
RESET
If the SPEAKY fails to function normally, please reset it
by switching on your car kit, then press the TALK
button together with VOL + and Vol - button for about
5 seconds.
*Reset the headset will delete all pairing set ups, you
will need to pair the devices again.
MORE INFORMATION & SUPPORT
Please contact us at support@bluetrek.com for any
question, we will help you through any difficulty you
may have.
9 10 11
MAKING CALLS
Dial the number on the phone’s keypad or use voice
recognition if your phone is equipped with this
function.
VOICE DIAL FROM BLUETREK SPEAKY
Make sure the voice recognition function on your
mobile is activated and your voice tags have been
recorded with the phone (refer to your mobile phone
user manual). Press once the VOL + and Vol - together
to activate the voice recognition function on your
phone.
*This function may not be available on some phones.
CALL WAITING
When you hear a call waiting alert while you are on a
call, press once the TALK button to accept the second
call and end the current call, or double press on the
TALK button to accept the second call and place the
current call on hold.
Important safety and operational information
Please read the following information before using the carkit. Additional warnings may be
present on the product, packaging or in the user manual.
• To reduce interference, it is best to place your mobile phone and carkit without any
obstacles in-between.
• For better performances, avoid covering or blocking the microphone and speaker area of
the carkit with any objects, whilst making sure the microphone is pointing toward the
user for best reception.
• For ease of use, securely place the carkit inside the car where it can be easily reached by
the user. We recommend within an arm length distance facing from you at driving
position.
Warnings
• Using Bluetooth carkit at high volume level and noisy background can potentially cause
hearing loose. If you experience ringing in your ears or muffled speech, consult your
doctor immediately and stop using the device.
• The volume level of the Bluetooth® carkit may vary, depending on your mobile phone.
Before using your carkit for the first time, adjust the carkit volume to the lowest, then
increase the volume gradually until you reach to an acceptable level.
• Check local laws regarding use of a mobile phone and carkit while driving. If you use the
carkit while driving ensure your attention and focus remain on driving safely.
• Observe all signs and instructions that require an electrical device or RF radio product to
be switched off in designated areas, such as gas/refueling stations, hospitals, blasting
areas, potentially explosive atmospheres, or aircraft.
Charge warnings
• For your first time use, please fully charge your carkit (refer to the manual).
• The lifetime of the battery will be significantly reduced if your device is left uncharged for
a long period. Bluetrek recommends that you fully recharge your device at least once a
month to keep the battery performance.
• To maximize battery life time, it is recommended to recharge your carkit to full capacity
only when the battery is low, since a battery has a life time of about 350 charging cycles.
• Do not over charge your carkit for more than 10 hours.
• The use of any other charger will automatically suspend the warranty. It is forbidden and
can be dangerous.
• Ensure that the voltage rating corresponds to the local mains or power supply you
intend to use.
• Optimal handling may not always be practical in real life. Deviations from the ideal are
acceptable but will lower the life expectancy of the battery to some degree.
7 8
To switch between an active call and on hold call,
double press the TALK button.
To end the active call and take the hold call, press
once on the TALK button. This function may not be
available on some phones.
OTHER CONTROL
Function Operation
Answer/End Call Press once the TALK Button
Reject Call Press the TALK Button for 2 seconds
Redial Double press the TALK Button
Call Transfer Double press the VOL + and VOL – button
Volume Adjust Press once the VOL + button for volume
Mute/Unmute the
microphone
Others warnings
• Do not drop or try to alter the shape of your carkit.
• Keep your carkit away from dust and dirt.
• Do not expose your headset to liquid, moisture, fire, open flames and extreme
temperatures. Operating and storage temperature is 0°C to +60°C (32°F to +140°F)
• Do not try to disassemble the product. Service and Maintenance can only be performed
by authorized dealers.
• Do not let children play with your carkit, since it contains small parts that could become
detached and create a choking hazard. Keep all products, cords, and cables away from
children. As with all corded products, there is a danger of strangulation if a cord should
become wrapped around your neck.
Certification and Safety approvals
This product is CE marked according to the provisions of the R&TTE Directive (99/5/EC). We
declare that this product is in compliance with the essential requirements and other
relevant provisions of Directive 1999/5/EC. For further information, please refer to website.
FCC/ Industry Canada Notice
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference. (2) This device must accept
any interference received, including interference that may cause undesired operation.
In compliance with Industry Canada regulations, technical specifications have been
provided in a declaration of conformity. This does not imply that Industry Canada approved
the equipment.
Caution: Changes or modifications to this Bluetooth® car kit not expressly approved by the
party responsible for compliance could void the user’s authority to operate it.
of their service lives to the public collecting points set up for this purpose or point of sale. Details to
this are defined by the national law of the respective country. This symbol on the product, the
instruction manual or the package indicates that a product is subject to these regulations. By
recycling, reusing the materials or other forms of utilizing old devices, you are making an
important contribution to protecting our environment.
Bluetooth® is a trademark owned by Bluetooth SIG, Inc. and is used by
the manufacturer under license.
Note on environmental protection:
After the implementation of the European Directive 2002/96/EU in the national legal system, the
following applies: Electrical and electronic devices may not be disposed of with domestic
waste. Consumers are obliged by law to return electrical and electronic devices at the end
up and VOL – button for volume down
Press and hold the VOL + button or VOL button for 2 seconds
For more information, please visit our website : www.bluetrek.com
702-00193-01
Loading...