Bluesound PULSE SUB+ operation manual
QUICK SETUP GUIDE
PULSE SUB+
bluesound.com
WELCOME TO #LIVINGHIFI
The PULSE SUB+ is a network subwoofer that can be paired to any Bluesound
Player. It should be connected wired or wirelessly to your home network.
This Quick Setup Guide will guide you through the basic steps to get your
PULSE SUB+ positioned, plugged in, and on your network.
Most of the setup is done using the BluOS App on your phone or tablet. Make sure
you have the App downloaded and your phone or tablet nearby as you get started.
Go to bluesound.com/downloads to download the App.
The PULSE SUB+ online owners manual has even more in-depth information,
including troubleshooting tips and tricks. Please visit bluesound.com and go to the
PULSE SUB+ product page to download the latest manual.
If you have any questions during setup please visit our support site at
support.bluesound.com
ACCESSORIES
120V AC Power Cord Magnetic rubber feet x2
230V AC Power Cord Wall Mount Bracket
1. CHOOSE PLACEMENT
CHOOSE PLACEMENT
STANDING UPRIGHT
Attach the supplied magnetic rubber feet
to the magnetic area on the bottom of the
SUB+ to limit any unwanted vibrations.
LAYING FLAT
You can place the SUB+ on its back,even
under a sofa or table. The four rubber feet
on the back of the product will help limit
any unwanted vibrations.
WALL MOUNTED
The shaped groove in the circular feet on
the back of the SUB+ will help guide it
onto the supplied wall bracket.
CHOOSE PLACEMENT
WALL MOUNTING INSTRUCTIONS
The PULSE SUB+ design allows it to be wall mounted horizontally or vertically for wire
management. Ensure the selected locations for wall-mounting do not conceal electrical
wiring or plumbing. Using the supplied wall bracket, mark the location of the pilot
holes and pre-drill each hole for the mounting screws (not included) using the correct
mounting hardware for the specic wall material.
Once the wall mount bracket is attached to the wall, set the SUB+ feet onto the bracket’s
rubber connectors, then push down to secure.
Loading...