Blue Rhino 60000, 70000 User Manual
Cleaning emitter
®
and burner
Series:
60000-66000
70000-91000
LP Gas
®
Cleaning emitter and burner. Series 6000-93000 LP Gas 405121 3
®
For assistance call 1.800.762.1142.
Tools needed:
• #2 Phillips screw driver
• 7/16 wrench
• Needle-nose pliers
• Non-abrasive scouring pad
• Bottle brush
• Pipe cleaners
• Air hose or can of compressed air
• Rubber gloves
For assistance call 1.800.762.1142.
DANGERS and Cautions
1. Installation and repair should be done by a qualified service person.
2. Use only Blue Rhino Global Sourcing, LLC. factory authorized parts. The use of any
part that is not factory authorized can be dangerous. This will also void your warranty.
Contact 1.800.762.1142.
3. Do not use flammable solutions or material to clean heater or heater parts. Use only
warm soapy water to clean outside of heater.
4. Do not submerge control valve in water.
Cleaning emitter and burner. Series 6000-93000 LP Gas 405121 2
®
1. Remove propane cylinder.
2. Remove dome.
3. Remove wire guard.
For assistance call 1.800.762.1142.
Steps 1-3
Cleaning emitter and burner. Series 6000-93000 LP Gas 405121 3
®
For assistance call 1.800.762.1142.
Cleaning emitter and burner. Series 6000-93000 LP Gas 405121 5
®
For assistance call 1.800.762.1142.
Step 4
Using a #2 Phillips screwdriver, remove the 4 screws that secures the emitter to the emitter bottom.
Cleaning emitter and burner. Series 6000-93000 LP Gas 405121 4
®
For assistance call 1.800.762.1142.
Step 5
1. Using a non-abrasive scouring pad, clean the outside and inside of the emitter.
2. Finish up by blowing any loose soot off the emitter with air or a can of compressed air.
Cleaning emitter and burner. Series 6000-93000 LP Gas 405121 5
Loading...