Navigator
QUICK START
AND REFERENCE
BEFORE YOU START
Check that the Navigator system contains the
following items...
l Navigator Console
l Navigator GPS float
l Rechargeable NiMH battery pack (8.4V, 2.2Ah)
l Battery charger (Universal AC supply, 3-stage
charging)
l USB connection lead
l PinPoint software CD (for Microsoft Windows)
l User documentation
Before using the Navigator system for the first
time, please read the full User Manual as this
contains important safety and operational
information.
FEATURES
Display & Keypad
Frame & Handles
Display
Area
Power USB /
GPS
Connectors
Battery Housing
Battery Pack
Battery Housing Cap
GPS Float & Cable
Application Icons...
Press
Status Bar Icons...
Battery
Logging
Data
Icon colour...
Green = Normal operation
Yellow = Warning
Red = Error / Alarm
Keypad...
F1 / Up
Power On /
F2 / Down
App
F4 / Right
F3 / Left
Navigation
Dive Profile
Compass
GPS
Settings
GPS
Immersion
Sensor
P/N: BP01039.1
l Do not rely on this product or its sensors as a
primary means of life-support during or after a
dive. Navigator is designed as a navigation aid
only, and not as an alternative or replacement
for dive-computers or similar apparatus.
l Do not submerge the console, unless all
connectors or suitable blanking plugs are fitted
in unused electrical connector sockets, and the
battery housing cap is secured.
l Do not use this product if any of the cabling, or
housings of its component parts appear to be
damaged or compromised for the ingress of
water (where required to be watertight).
When you have finished using your Navigator
system, you should…
l Remove any weed, or other detritus, that may
have been collected during its operation.
l Wash the system in fresh water, if it has been
used in salt-water, to prevent corrosion and
damage to rubber mouldings.
l Store in a well ventilated enclosure after use, to
allow any moisture on system components to
evaporate naturally.
Copyright © 2016, www.blueprintsubsea.com
UM-145-P01039-01
BATTERY CHARGING,
FITTING & CARE
To fit (or remove) the battery pack...
To charge the battery pack...
l With the charger turned off, plug the charging lead into the socket at the
end of the battery pack.
l Charging can take up to 4 hours, during which time the battery may
become warm as charging approaches completion.
l The charger status indicator colour shows current mode, completion or
error.
Please refer to the full list of safety notices, care and storage guidelines
in the user guide.
l Use only the supplied charger with the Navigator NiMH battery packs.
l Do not allow the charger or battery pack to be exposed to water.
l Charge batteries in a well ventilated location where ambient temperature is
between 10°C and 30°C.
l Avoid repeatedly re-charging the battery without allowing for a minimum 30
minute cooling period between charge cycles.
When storing batteries...
l When not in use, batteries should be disconnected from the charger and
stored in a fully charged state. Do not leave battery packs in the Navigator
battery housing for long periods of storage.
l The chemistry of the nickel metal hydride battery pack will self-discharge
approximately 1% of its charged capacity per day
l When storing batteries for more than one year, charge at least once a year to
prevent leakage and deterioration of performance due to selfdischarging.
Yellow = No battery / Initialising
Orange = Bulk Charge Mode
Green/Yellow = Top-off Charge Mode (fast flash)
Green = Trickle Charge / Complete
Orange/Green
= Error (slow flash)
Loading...