Blue Air BSF23 Installation Manual

Reach ins, Freeezers & Refrigerators

Installation & Operation Manual

BSR23
BSF23

IMPORTANT SAFETY INSTRUCTIONS (SAVE THESE INSTRUCTIONS)

BSR49
BSF49

Visit us on the web at www.blueairinc.com

BSR72
BSF72

CONTENTS

Contents

ƃ Specifications .............................................................................. 3

ƃ Serial Number .............................................................................. 3

ƃ Installation .................................................................................... 4

ƃ Cleaning ........................................................................................ 5

ƃ Caution .......................................................................................... 5

ƃ Operation

Refrigerator ................................................................................ 6

Freezer ......................................................................................... 8

ƃ Trouble-Shooting ....................................................................... 10

Service Contact

Blue Air Refrigeration has a Nationwide Service Network

to provide timely services to our customer’s needs.

Please call or fax us at the following numbers.

Blue Air Refrigeration Nationwide Service Network

TEL, [phone]

Fax, [phone]/0262

Toll Free, 1-866-677-8500

Specifications

ƃ Specifications and Designs are subject to change without notice for quality improvement.

Serial Number

ƃ The serial number is located on the rating label which is on the left interior wall.

Please retain the unit’s serial number for service purpose.

Installation

1. GOOD AIR CIRCULATION

- Make sure to avoid any object which will interrupt or block the air flow inside the unit.

- Make sure to leave enough space toward the interior rear wall to ensure good air circulation

- Make sure to keep 5 inch space between the back of the unit and the wall.

2. PLACE ON STRONG GROUND

- Place the unit on a floor strong enough to hold

3. DO NOT PLACE NEAR HEAT SOURCE

- Make sure to avoid hot corner or any location near stove, oven, or other heat source.

- High ambient temperature will cause cooling efficiency to drop.

4. INDOOR USAGE ONLY

- This equipment is intended for indoor use only.

5. STABILIZING

- Make sure the unit is installed in a stable condition with the front wheels locked while in use.

6. LEVELING

- Make sure that the unit is leveled well from front to back and side to side.

7. Unit should be connected to a dedicated electrical circuit.

- Do not use extension cords.

- Plug the unit to a dedicated electrical circuit & adequate capacity.

8. Install plastic condensate pan in the bottom of the unit.

- Make sure pads are installed upwards and drain hose is in pan.

9. Install the unit in a place where the air circulation is good.

- Maintain enough spaces around the unit since air
to ensure the best cooling performance

- If air circulation is obstructed, then cooling
performance will drop, thus consuming more electricity as a result.

over 7 inches

Reference

If a left-hinge door is needed, please contact the sales representative in your area.
A set of door hinge can be purchased separately to

convert between right -hinge door and left-hinge door.

over 1 ft

over 7 inches

Cleaning

WARNING - To reduce the risk of electric shock, unplug before

cleaning or servicing.

1. CLEANING THE INTERIOR AND EXTERIOR

- The interior and exterior of the unit can be cleaned using warm water with soap.

- Do not use an abrasive cleaner because it will scratch the surface.

2. CLEANING THE CONDENSER FINS

- To maintain proper refrigeration performance, the Condenser coil must be free of dust, dirt, and grease.

It will require to clean it periodically. Condenser fins should be cleaned, at least every
three months (90 days) or as needed.

3. CLEANING THE GASKET

- The door gasket should be cleaned frequently to maintain proper sealing.

Use warm water and a mild soap.

4. CLEANING THE EVAPORATOR

- If you need to clean the evaporator, please contact the qualified service technicians.

5. CHECK AFTER CLEANING

- Check the unit again for safety.

- Check if the unit is operating properly.

Caution

1. POWER CORD

- Make sure the power cord is connected to the proper voltage. (115V, 60Hz)

- Compressor warranties are void if compressor burns out due to a usage of improper voltage.

- A protected circuit of the correct voltage and amperage must be used for connection of the line cord.

- Turn ‘off ‘ the power switch before disconnecting the power cord whenever performing
maintenance service or cleaning the refrigerated cabinet.

- If the power cord of Refrigerator (Freezer) is damaged, it should be replaced by the
manufacturer or service agent or a similarly qualified person in order to avoid a hazard.

2. RE-STARTING

- If disconnected, wait 5 minutes before re-starting.