Blueair 600, 500 User Manual
Blueair
500/600 Series
User Manual 2
Manual del usuario 8
Guide d’utilisation 14
Blueair 500/600 Series/Serie/Série
Contents
2 Welcome
3 Getting started
5 Getting the most from your Blueair system
6 Changing the filters
English English
Getting started
General safety instructions
The Blueair 500/600 Series air purier is an electrical appliance. Please
read the safety instructions before use and take the necessary precautions
to reduce the risk of re, electric shock or injury. The Blueair Limited
Warranty applies only if the unit is used according to these instructions.
7 Filters
Welcome
Thank you for choosing Blueair. Before you start using your Blueair air
purier, take a few minutes to become familiar with the basics.
Filter replacement
Be sure to change your Blueair lters according to the recommended
lter replacement schedule. This helps keep your Blueair air purier
running in top condition. See page 6.
Extend your warranty
Complete and send your warranty card to Blueair today to extend your
limited warranty.
Help keep the planet healthy, too
Blueair air puriers provide maximum improvement of indoor air quality
with minimum impact on the environment. The entire unit can be
recycled.
• Use the grounded power cable provided with your Blueair unit. The
plug ts into a grounded outlet. Do not alter the plug in any way.
• Use the cable provided to plug the Blueair unit directly into an
appropriate electrical outlet (please refer to the voltage label on
your unit). The cable is packaged beneath the unit.
This appliance is not intended for use by children or other persons
whose physical, sensory or mental capabilities or lack of experience
and knowledge prevents them from using the appliance safely unless
properly supervised.
Children should not be allowed to tamper with the controls or play with
the appliance.
Placement
Place the unit in a location that allows air to circulate freely in, out and
around the unit. The minimum acceptable distance from another object
is 4˝ or 10 cm. Use only genuine Blueair lters. Do not place the unit:
Directly on or against soft furnishings, such as bedding or curtains.
Near sources of heat, such as radiators, fireplaces or ovens.
Near wet areas, such as bathrooms or laundry rooms, where it may come into
contact with water.
Outdoors.
2 Blueair 500/600 Series Blueair 500/600 Series 3
English English
Settings*
Plug the cable into a grounded wall outlet and turn on your Blueair unit.
The blue light-emitting diode indicates that the unit is working. Set the
control knob to maximum speed, which is recommended for fast initial
cleaning, daytime use, or very polluted air. After a few minutes, adjust the
control to the desired speed. Minimum speed is generally recommended
for nighttime use.
Care and maintenance
Blueair air puriers feature high quality design, materials and workmanship. To keep your unit in top condition, we recommend routine cleaning.
• Vacuum the air intake grille from the inside when you remove
the lters to replace them.
• Vacuum the small inlets with a soft brush attachment.
• Wipe the exterior of the unit with a soft, clean, damp cloth.
• Never clean with gasoline, chemical solvents or corrosive material
also as these agents may damage the surface.
• Do not allow foreign objects to enter the ventilation or exhaust
openings. This may cause electric shock or damage the unit.
• Do not try to repair or adjust any of the electrical or mechanical
functions on your Blueair unit yourself. Contact your local
dealer or Blueair for warranty information.
How it works
Air passes through an ion chamber
where airborne particles are
charged with negative ions.
Charged particles are drawn to the
HEPASilent™ lter surface. Puried
air, which is virtually contaminantfree is re-circulated into the room.
Getting the most from
your Blueair system
The Blueair system is easy to use. Make sure your unit is the right size
for your room, and change the lters according to recommended lter
replacement schedule. Remember that, just as air conditioners and
heaters have limits to the volume of air they can cool or heat, every air
purication system has limits to the volume of air it can clean. Follow
these common-sense guidelines.
Close your windows
You wouldn’t throw open your windows on a hot summer day and
expect your air conditioner to work efciently, because you can feel the
hot air coming in and the cool air going out. Even though you can’t see
the contaminated air coming in and the clean air going out, the same
logic applies to your air purier.
Close your doors, too
Just as you might seal off part of your house on a cold winter night to
keep your heater working more efciently, seal off the room in which
your system is working for best results. This is especially important
for people using a Blueair system to ease nighttime asthma or allergy
attacks.
Run your system 24 hours per day
For best results, run your Blueair unit 24 hours a day, 7 days a week.
Round-the-clock operation ensures that a continuous supply of clean,
ltered air constantly circulates throughout the room. Blueair systems
are designed for phenomenally low power usage. In fact, it costs about
the same to power a Blueair air purier as it does to power a single light
bulb, depending on the unit and the operating speed.
* For Blueair E Series units (250E, 450E, 550E, 650E), please refer to the separate sheet included with your unit for instructions on settings.
Blueair 500/600 Series 54 Blueair 500/600 Series
English English
Changing the filters
Step 1
Unplug the unit and
lift the lid from the
top of the unit.
Step 3
Remove the filters
on each side.
Vacuum the grille
from the inside.
Step 5
Place the third filter
on top of the unit
and ensure that the
side with the words
“facing out” is
facing upwards.
Step 2
Remove the filter
on top.
Step 4
Guide the first and
second replacement filters into the
side slots. Ensure
that the side with
the words “facing
out” is turned
toward the outer
wall of the unit.
Step 6
Snap the lid back
into place.
Filters
Patented HEPASilent™ technology makes the Blueair 500/600 Series
incredibly quiet. The unit comes with a complete set of three HEPASilent™
lters already installed.
Particle Filter Kit. Includes three particle lters that remove dust, pollen,
bacteria, pet dander, mold spores and other airborne particles. The
particle lter is made of polypropylene, which help mechanically lter
out airborne particles. To maximize lter effectiveness, particles are
negatively charged by the Blueair unit before reaching the lters.
Smokestop™ Filter Kit. Includes three lters with enhanced active
carbon to remove gaseous pollutants such as cigarette and cigar smoke
or other VOCs (volatile organic compounds, including household paints
and other chemicals). You may notice a slight odor from the enhanced
active carbon when the lter is rst used; this will quickly dissipate.
For optimal performance, Blueair recommends that you replace
filters every six (6) months.
We offer a convenient Filter Subscription Program in some countries.
Contact your local dealer or Blueair to nd out whether the program is
available to you.
IMPORTANT! Use only genuine Blueair lters to ensure proper function
of your unit and to qualify for full warranty coverage.
Customer’s record
The model number and serial number of this product can be found on the bottom of the unit.
Please note them in the space provided below and keep for future reference.
Model number Dealer’s name
Serial number Dealer’s address
Date of purchase Telephone number
6 Blueair 500/600 Series Blueair 500/600 Series 7
Loading...