Do not use the tablet in situations where it might cause danger.
Transportation Safety
Please observe all transportation laws and regulations.
4
Please drive with both hands on the wheel.
Hospital Safety
Please follow hospital rules and limitations.
Please turn off your tablet when near medical instruments.
Airport Safety
Remember to follow all airport and flight safety regulations.
Please do not use your tablet during flight.
Chemical Warning
Do not use your tablet around fuels or chemicals.
Temperature Warning
Do not subject your tablet to extreme temperature conditions.
Water Hazard
Your tablet is not waterproof. Keep your tablet away from water or liquid to avoid damage.
Emergency Calls
Make sure your tablet is switched on and in a service area. In home screen, tap the dial key and dial the
emergency number.
PLEASE DRIVE RESPONSIBLY - DO NOT TEXT AND DRIVE
5
Accessories and Batteries
Use only Blu authorized batteries and accessories.
Information Backup
Remember to keep a written record of all important information.
Battery Safety and Precautions
- For better performance and longer battery life, it is recommended that you charge the battery fully before
using the tablet for the first time.
- The optimum performance of a new battery is typically achieved after two or three complete charge
cycles. Note: Keep in mind that continuous overcharging will affect long term battery life.
- While charging, keep the tablet out the reach of children.
- Store the battery in a cool and dry place away from direct sunlight and water.
- Do not expose batteries to extreme temperatures (below -8°C (18°F) or above 43°C (110°F).
- Immediately stop using the battery if it produces an odor, cracks and leaks, overheats, distorts or has any
other type of physical damage.
- Avoid using the charger near or around liquids. If the charger comes in contact with water or any liquids,
immediately unplug it from the outlet to reduce the risk of overheating, charger malfunction, electric shock
or fire.
6
Warning: Please be careful with the disposal of used batteries. Do not throw away batteries with daily
waste. Please follow local environmental laws and guidelines for proper waste disposal.
Cleaning and Maintenance
- Avoid using the tablet and accessories in excessively moist areas to avoid malfunction.
- Use a soft, dry cloth to clean the tablet, battery and charger.
- Do not use alcohol, thinner, benzene or any other solvent to clean the tablet.
FCC Regulations
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This device has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiated radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation If this equipment does cause harmful interference to radio or television reception, which can be
7
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user‘s authority to operate the equipment.
RF Exposure Information (SAR)
This device is designed and manufactured not to exceed the emission limits for exposure to radio
frequency (RF) energy set by the Federal Communications Commission of the United States.
During SAR testing, this device was set to transmit at its highest certified power level in all tested
frequency bands, and placed in positions that simulate RF exposure in usage against the head with no
separation, and near the body with no separation. Although the SAR is determined at the highest certified
power level, the actual SAR level of the device while operating can be well below the maximum
8
value. This is because the device is designed to operate at multiple power levels so as to use only the
power required to reach the network. In general, the closer you are to a wireless base station antenna,
the lower the power output.
The exposure standard for wireless devices employing a unit of measurement is known as the Specific
Absorption Rate, or SAR.
The SAR limit set by the FCC is 1.6W/kg.
This device is complied with SAR for general population /uncontrolled exposure limits in ANSI/IEEE
C95.1-1992 and had been tested in accordance with the measurement methods and procedures specified
in IEEE1528. This device has been tested and meets the FCC RF exposure guidelines when tested with
the device directly contacted to the body.
The FCC has granted an Equipment Authorization for this model device with all reported SAR levels
evaluated as in compliance with the FCC RF exposure guidelines. SAR information on this model device is
on file with the FCC and can be found under the Display Grant section of www.fcc.gov/oet/ea/fccid after
searching on FCC ID: YHLBLUTBG7.
For this device, the highest reported SAR value for usage against the head is 0.89 W/kg, for usage near
the body is 1.18 W/kg.
While there may be differences between the SAR levels of various devices and at various positions, they
all meet the government requirements.
9
IC Notice
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the
following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of
the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
IC: 11492A-TBG7
10
IC Radiation Exposure Statement
This EUT is compliance with SAR for general population/uncontrolled exposure limits in IC RSS-102 and
had been tested in accordance with the measurement methods and procedures specified in IEEE 1528
and IEC 62209. This device and its antenna(s) must not be co-located or operating in conjunction with any
other antenna or transmitter.
Cet appareil est conforme aux limites d'exposition DAS incontrôlée pour la population générale de la
norme CNR-102 d'Industrie Canada et a été testé en conformité avec les méthodes de mesure et
procédures spécifiées dans IEEE 1528 et IEC 62209.Cet appareil et sa ou ses antennes ne doivent pas
être co-localisés ou fonctionner en conjonction avec tout autre antenne ou transmetteur.
11
Power
Volume
Front Camera
Appearance and Key Functions
12
Rear Camera
13
Speakers
Speakers
Introduction
Installation of the SIM Card
Please keep the SIM card out of the reach of children. The SIM card and its contact are easily damaged
due to scratching or bending. Please be cautious when carrying, installing or taking out the SIM card.
Note:Please contact your cellular tablet service provider directly to obtain the SIM card.
To insert SIM card:
1. Power off tablet (if powered on) and insert the SIM card.
2. Insert an SD card.
(For additional storage capacity)
14
SIM Slot
Memory Card
3. Power on the tablet.
Power On, Power Off and Unlock
On - Please ensure the SIM card has been properly inserted into the tablet. Long press the Power key to
switch on the tablet.
Off - In standby mode, long press on Power key until an options menu appears. Select Power Off in the
menu to switch off the tablet.
Unlock-In standby mode, swipe the screen up to unlock.
Security
You may set a security lock feature as a security measure for the tablet. For further information regarding
password locks, password revision and other functions please enter into the security option in system
settings.
15
Loading...
+ 34 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.