Bloomfield HT-327 Installation Instructions Manual

ELECTRICAL

MODEL VOLTS WATTS AMPS PHASE WIRING

HT-327
HT-327 240

208 3700

5000

17.9

20.6 SINGLE

SINGLE 10 AWG Cu 90°C

FIELD

GAUGE

TEMP.

RATING

90°C10 AWG Cu

PRODUCT DIMENSIONSCUTOUT DETAILS

3 7/8

(98)

INSTALLATION INSTRUCTIONS

DROP-IN BAIN MARIE STYLE HEATED TANK

MODEL HT-327

INCHES

(MM)

29 1/2

(749)

42 1/2
(1080)

3 1/8

(79)

4 7/8
(124)

5

(127)

4 1/8
(105)

INSTALLATION INSTRUCTIONS

INSTALLER MUST MEET CONDITIONS OF ACCEPTABILITY
OUTLINED BELOW UPON INSTALLATION:

1. Required installation clearances:
Wooden and Metal Installation: DO NOT install closer than
4 1/8 inches to front wall, 1 inch to back and side walls,
and 10 3/4 inches to surface below the unit.

2. Unit shall be accessible for servicing from the bottom.

3. If storage is to be used underneath the unit, it is
recommended that a baffle be placed 12 inches below
the unit to avoid contact with elevated temperatures.

TO FABRICATE:

1. Lay out "cutout" dimensions on countertop and front
apron.

2. Lay out and fabricate control panel holes in counter
apron using the control box as a template.

3. Cut out holes.

TO INSTALL:

IMPORTANT - DO NOT disconnect lead wires from the
Master Control Panel when making installation.

1. Tilt and pass Control Panel and electrical box through
the countertop cutout, then through the apron cutout.
Lower modular section into countertop cutout and
position.
RECOMMENDATION: Before final seating of modular section
to countertop, apply a bead of silicone adhesive/sealant
to the underside of gasket supplied on the mounting
flange.

2. From underneath, insert screwdriver into slots in
Wellslock frame and twist ears outward (clockwise) as
required to secure flange tightly to countertop.

3. Mount Control Box to apron cutout as shown in drawing.

4. Mount Control Panel onto electrical box using the
screws supplied.

WELLS/BLOOMFIELD * VERDI, NV

TO PLUMB:

1. A drain with valve is supplied on all units. Location of the
valve handle is at the discretion of the fabricator (see drawing).

2. Connect 1" drain connection to a suitable drain line.

TO WIRE:

1. Final connection is accomplished by bringing proper power
supply leads (see 'WIRING REQUIREMENTS' label) through
conduit knockout to wire leads supplied within the Master
Control Panel. Check nameplates for voltage and phase.

NOTES:
BAIN MARIE STYLE HEATED TANKS ARE DESIGNED FOR WET

OPERATION ONLY.
THIS EQUIPMENT IS TO BE INSTALLED TO COMPLY WITH

APPLICABLE FEDERAL, STATE AND LOCAL PLUMBING AND
ELECTRICAL CODES.

39 3/4
(1010)

43 1/2
(1105)

5 7/8
(149)

WARMER FLANGE

GASKET

SCREWDRIVER

COUNTERTOP

26 7/8

(683)

6 1/4
(159)

CONTROL PANEL WITH
FLEXIBLE CONDUIT

MINIMUM CLEARANCE REQUIRED

FROM UNIT TO THE NEAREST SURFACE

(25)

MASTER CONTROL PANEL

WELLSLOK

30 5/8

(778)

11

302964-2 REV (-)

9 3/4

(248)

1 INCH NPT DRAIN
WITH BALL VALVE

CLEARANCES

FRONTBOTTOMSIDEBACK

10 3/4

(273)(25)

4 1/8

(105)