Bloomfield HT-300 Installation Instructions Manual

ELECTRICAL

MODEL VOLTS WATTS AMPS PHASE WIRING

HT-300
HT-300 240

208 2700

3600

42 1/2
(1080)

13.0

15.0 SINGLE

3 1/8

(79)

SINGLE 14 AWB CU 90°C

22 1/2

(572)

4 1/8
(105)

FIELD

GAUGE

3 7/8

(98)

TEMP.

RATING

90°C14 AWB CU

PRODUCT DIMENSIONSCUTOUT DETAILS

39 3/4

(1010)

43 1/2
(1105)

INCHES

(MM)

6 1/4

(159)

INSTALLATION INSTRUCTIONS

DROP-IN BAIN MARIE

STYLE HEATED TANK

MODEL HT-300

23 5/8

19 7/8

(600)

(505)

5

(127)

4 7/8
(124)

INSTALLATION INSTRUCTIONS

INSTALLER MUST MEET CONDITIONS OF ACCEPTABILITY
OUTLINED BELOW UPON INSTALLATION:

1. Required installation clearances:
Wooden and Metal Installation: DO NOT install closer than
4 1/8 inches to front wall, 1 inch to back and side walls,
and 6 3/4 inches to surface below the unit.

2. Unit shall be accessible for servicing from the bottom.

3. If storage is to be used underneath the unit, it is
recommended that a baffle be placed 8 1/2 inches below
the unit to avoid contact with elevated temperatures.

TO FABRICATE:

1. Lay out "cutout" dimensions on countertop and front
apron.

2. Lay out and fabricate control panel holes in counter
apron using the control box as a template.

3. Cut out holes.

TO INSTALL:
IMPORTANT - DO NOT disconnect lead wires from the
Master Control Panel when making installation.

1. Tilt and pass Control Panel and electrical box through
the countertop cutout, then through the apron cutout.
Lower modular section into countertop cutout and
position.
RECOMMENDATION: Before final seating of modular section
to countertop, apply a bead of silicone adhesive/sealant
to the underside of gasket supplied on the mounting
flange.

2. From underneath, insert screwdriver into slots in
Wellslock frame and twist ears outward (clockwise) as
required to secure flange tightly to countertop.

3. Mount Control Box to apron cutout as shown in drawing.

4. Mount Control Panel onto electrical box using the
screws supplied.

9 3/4
(248)

5 7/8

(149)

CONTROL PANEL WITH
FLEXIBLE CONDUIT

1 INCH NPT DRAIN
WITH BALL VALVE

CLEARANCES

MINIMUM CLEARANCE REQUIRED

UNIT TO THE NEAREST SURFACE

FRONTBOTTOMSIDEBACK

11

(25)

WARMER FLANGE

GASKET

WELLSLOK

SCREWDRIVER

COUNTERTOP

TO PLUMB:

1. A drain with valve is supplied on all units. Location of the
valve handle is at the discretion of the fabricator (see drawing).

2. Connect 1" drain connection to a suitable drain line.

TO WIRE:

1. Final connection is accomplished by bringing proper power
supply leads (see 'WIRING REQUIREMENTS' label) through
conduit knockout to wire leads supplied within the Master
Control Panel. Check nameplates for voltage and phase.

MASTER CONTROL PANEL

6 3/4

(171)(25)

NOTES:

BAIN MARIE STYLE HEATED TANKS ARE DESIGNED FOR WET
OPERATION ONLY.

INSTALLATION MUST MEED LOCAL PLUMBING AND ELECTRICAL
CODES.

4 1/8

(105)

WELLS/BLOOMFIELD * VERDI, NV

301765-2 REV (-)