Before starting, it is essential that you read carefully right
through the installation and operation instruction booklet
before plugging in to the mains socket. The following
instructions should prevent the risk of personal injury
and/or damages to the machine.
Please keep these documents for later reference in a
safe place.
This operating manual has been written for different
machines and some of the features mentioned here may
not apply to your specific machine.
The packaging and some parts of your machine are made
from recyclable materials. These materials are marked
up with recycling symbol and material type information
(PE, PS, POM).
Remove the packaging material and dispose of it in
accordance with regulations prior to taking the machine
into operation.
Warning
Packaging materials may be dangerous to children.
Reusable substances may be dropped off at the local
disposal facilities. You may obtain further information
from the authorities and disposal facilities.
Disposal of your old machine
Dispose of your old machine in accordance with the
disposal guidelines which are in effect at the location
where you reside. To avoid dangers, please make the
machine unusable until the time of transport.
Pull out the mains plug and cut the power cable.
Render the door lock unusable.
2
Safety Instructions
21
min 4cm
3/4
min 10
AQUASAFE+
18
max 110 cm
12cm
min 50 cm
AQUASAFE+ (depends on the model)
The Aquasafe+- system protects you from water damage
which may be caused at the water inlet hose.
Do not immerse the systems valve box into water; it
contains electrical components.
In case of damage, pull out the power supply plug.
Do not shorten or lengthen the hose insert, since it
contains electrical cables and components.
Water drainage
Connecting the drainage hose.
Take care to ensure that the water intake hose is not bent
or squeezed.
Check that the drainage hose is firmly seated in place.
Extension hoses
If a hose extension is required, a drainage hose of equal
quality must be used
The maximum length must not exceed 4m. Otherwise,
the machines cleaning process is negatively influenced.
Siphon connection
The drainage height must be between 50 and 100 cm
above the floor.
Use hose clamps to fasten the drainage hose to the
siphon.
Before installation
Check the machine for transport damages. Never install
and use damaged machines. If in doubt, contact your
supplier.
Before first use
See Notes for Installation on page 22.
Have the grounding system installed by a qualified
electrician.
The manufacturer cannot be hold liable for any
damages that are due to operating the machine without
proper grounding.
Before operating the system, please check that the
data given on the type plate are in accordance with
the data of your power supply.
The dishwasher must be separated from the mains
during installation.
3
01020 30 40 50 60 70 80 90 100 110
Electrical connection
Please refer to the type plate for information on current
type, mains voltage, and fuse protection.
The type plate is located on the inside of the door.
The mains plug must be freely accessible after installation.
Power cables and insulated cables must not be accessible
after installation.
24
3/4
3/4
3/4
min 10
1/2
CH
DK
S
N
SF
Installing your dishwasher
Choose a suitable location for your dishwasher. Take
care to ensure that the machine is standing safely and
levelly.
Unevenness in the floor can be equalised by adjusting
the screw feet. When the machine is standing correctly,
the door can be closed without difficulties.
Water inlet and drainage hoses must be placed so
that they can move freely in order to avoid bending or
squeezing them.
The machine may not be hooked up in rooms with a
temperature below 0° Celsius.
Water connection
The dishwasher may be connected to cold and warm
water to a max. temperature of 60° Celsius.
The dishwasher may not be connected to open warm
water devices and flow-through water heaters.
Permissible water pressure:
Lowest permissible water
pressure:
0,3 bar = 3 N/cm² = 30 kPa
Highest permissible water
pressure:
10 bar = 100N/cm² = 1MPa
Connect water inlet hose
Take care to ensure that the water inlet hose is not bent
or squeezed. Do not install a used hose set.
Use a screw-on hose connector to connect the water
inlet hose to a water tap with an external thread with a
measurement of 3/4 inches.
If required, use a filter inset to filter deposits from the
pipes.
Check that the connection does not leak.
Attention
For safety reasons, close the tap after every rinse
process.
When the water pressure is
below 1 bar, please contact your
technician.
When the water pressure is above
10 bar, a pressure reduction valve
must be installed (available in trade
supply stores).
The connection of the machine to the mains may not
be made by using an extension cable. Extension
cables do not provide the necessary safety (e.g. danger
of overheating).
Always use the original plug delivered with the machine.
The plug must be freely accessible after the machine
has been installed.
Childrens safety
Do not allow children to play with the machine.
Dishwasher detergents may have caustic effects in
the areas of the eyes, mouth and throat. Please note
the safety notes provided by the manufacturers of the
detergents.
Never leave children unsupervised while the machine
is open. Leftovers of the detergents may still be
contained in the machine.
The water in the dishwasher is not drinking water.
Danger of caustic injuries.
Always place long and sharp/pointed objects (e.g.
serving fork, bread knife) into the cutlery basket with
the pointed end down or flat on the upper basket to
avoid possible injuries.
For daily operation
Use your machine only in the household, for the
following uses: Washing household dishes.
Do not use chemical solvents in the machine; there
is a danger of explosion.
Do not sit or stand on the opened door or place other
things on it. The machine may tip over.
Do not open the door while the machine is in operation.
Hot water or steam may escape.
Do not leave the door open an open door can be
a hazard.
In the case of problems
Repairs and changes to the machine may only be
carried out by qualified customer service personnel.
In the event of problems or repairs, disconnect the
machine from the mains supply:
- disconnect the machine by pulling the mains plug
- shut off the fuse.
Do not pull on the cable pull on the plug. Turn off
the water supply tap.
23
4
Loading...
+ 9 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.