Blizzard Lighting PixelStorm User Manual
PIPELINE
DMX DISTRIBUTOR
Congratulations on purchasing your new Pipeline DMX distributor. The unit has two inputs and
eight outputs. It features absolute electrical isolation between input and outputs, and between all
of the outputs. There are two types of DMX connectors (3-pin) for each individual channel. Each
DMX output features an independent driver. We strongly recommend that you take time to read this
manual fully before you attempt to use the DMX distributor.
Features:
• Fully compliant to DMX-512 (1990)
• 3pin & 5pin DMX Input and DMX Thru
• 100% electrical isolation between in/output
• 100% electronic isolation between output/output
• Signal & power LED indicator for each output
• Termintor resistor switch for end of a DMX chain
• Power input via IEC connector on rear panel
• Removable rack wings for Rack mount or wall mount
• Anodized aluminum front panel
Technical Specications:
• Power input: AC120V 50Hz/60Hz
• Consumption: 10W
• Dimensions: 482 x 130 x 44mm
• Weight: 2.6KG
Operating Instructions:
• DMX Output: Connect to the DMX receiving device.
• DMX Input: From the DMX transmitting device.
Connector pin designation should be as follows:
Pin 1: Signal common (shield)
Pin 2: Dimmer drive complement (data 1-)
Pin 3: Dimmer drive true (data 1+)
Pin 4: Option second data link complement (not used)
Pin 5: Option second data link complement (not used)
Do not exceed 32 units per one output channel and use a terminator on the last receiver.
Caution:
• This item must be earthed (grounded).
• Do not apply power source before completely nishing the installation.
• Always disconnect from mains before replacing the fuse.
• To reduce risk of re or electrical shock, do not expose to rain or moisture.
• Do not remove screws or covers. There are no user serviceable parts inside this unit.
Enjoy your product!
Our sincerest thanks for your purchase!
--The team @ Blizzard Lighting
Copyright (c) 2011 Blizzard Lighting, LLC
Loading...