Blizzard FZ40, GFZ40 Manual Of Instructions For Use And Installation

UPRIGHT REFRIGERATORS

MANUAL OF INSTRUCTIONS FOR USE AND INSTALLATION

Introduction

Model FZ40 with a solid insulated door or GFZ40 with a glass door.
Congratulations on your new freezer, we feel certain that it will
serve you well for many years ahead. To obtain maximum benefit
and efficiency from your freezer, please read the following
instructions carefully and act accordingly

INSTALLATION

1. Upon receiving the freezer, check for any damage that may
have occurred during transit. If there is, please contact your
dealer immediately

2. Place the freezer on an even flat surface and use the
adjustable feet for levelling.

3. Do not site the freezer close to heat sources such as cookers
or radiators and do not expose to strong sunlight. The glass
door freezer must never be placed in direct sunlight – Please
note that the effect of the Sun’s rays can affect goods stored
in the glass door freezer.

4. The freezer is equipped with a condenser on the rear side and
we recommend to have the condenser cleaned with a soft
brush each second month.

5. To minimize operating costs and maximise the life of the
compressor it is essential to allow good ventilation at the rear.
A clearance of 100mm is recommended

6. The cleaner has already been cleaned at the factory, but we
recommend you to clean it again using a solution of 1Tsp of
Sodium Bicarbonate to 0.5ltr of warm water. DO NOT CLEAN

THE GLASS DOOR WITH ABRASIVE CLEANERS OR
MATERIALS!

ELECTRICAL CONNECTION

This freezer is equipped with a fixed plug. If the plug does not fit
the socket, you must contact your supplier immediately or contact a
suitably qualified person to change it. The installation of a new plug
should only be carried out by someone qualified and carrying all
necessary safety certificates. If the power cord is damaged in any
way it should be replaced by the supplier to avoid a hazard.

WARNING!!

This Freezer Must Be Earthed!!

Plug the mains lead into a socket which will supply the voltage
230v/50Hz. Variations in the mains voltage of +/- 10% are
allowed, but major variations will reduce the lifetime of the
compressor.
If there is any doubt about the installation, we recommend a
qualified electrician should check it and confirm that it is operating
satisfactorily and has not been damaged in transit.

CONTROL PANEL

The control panel comprises of the following elements:

• Green mains supply light. This must always be on

• Thermometer which shows the temperature inside the freezer

• Thermostat knob to adjust the temperature in the freezer. To

decrease the temperature, turn the knob clockwise

• Freezers with an internal fan motor are equipped with a door
switch which cuts out the fan motor by opening the door
(standard for glass door model)

• Internal light will be equipped with an On/Off switch to turn
off the light during the night (Normally standard for glass door
model)

OPERATING

FZ40 can be used to freeze down fresh food as well as to store

The
frozen food, whereas the GFZ40 is a conservator which may only
be used for storing frozen food.

• Before use, the interior of the freezer should be cleaned by
using a solution of 1 tsp Sodium Bicarbonate to 0.5ltr water.
Do not clean the glass door with abrasive cleaning agents or
materials!

• If the freezer has been exposed to very low ambient
temperatures, do not switch on the freezer until the
compressor temperature is estimated to be at least +10˚C

• Always ensure that the contents do not impede the free air
circulation (for the fan assisted

GFZ40) as this may lead to

excessive differences between the upper and lower parts of
the freezer

• You are advised to adjust the thermostat according to the
ambient conditions of your freezer. (25˚C approx-Thermostat
pos. 4 and 30˚C approx-Thermostat pos. 5

• We always recommend that you always pack fresh food as
well as frozen in air tight plastic/plastic bags

• Fresh food should always be placed so that it has contact with
the freezing shelves

• If the freezing shelves are equipped with a wire cover, it can
be opened by lifting it and pulling towards you.

FROZEN FOOD STORAGE

Pre-packed commercially frozen food should be stored in
accordance with the manufacturers instructions for a 3 Star food
storage compartment. (Conservation temperature 18˚C). To
ensure that quality is maintained, the following should be
remembered: Place packets in freezer as soon as possible after
purchase, if there are instructions on the packet, follow these with
regard to storage times. The storage life of food varies and the
recommended storage times should not be exceeded.

IMPORTANT: If a substantial temperature rise occurs in the frozen
food, then storage life may be reduced and the storage time stated
may no longer apply. This may occur:

• During defrosting

• Due to non compliance with the manufacturers instructions

• Due to factors such as electric power failures or faults

DEFROSTING

As time goes on frost will build up on the freezing shelves in certain
areas. The amount of frost on the shelves will reduce the capacity
of the freezer and increase the internal temperature. This frost
should be scraped away periodically using a wooden or plastic
scraper or a stiff bristle brush. It is recommended this is done
when the thickness of the frost is approaching 5-10mm or a
minimum of 4 times per year so the inner body of the freezer can
be cleaned. Choose a time when stock in the freezer is low and
proceed as follows:

• Place the frozen goods at a cold place (in another freezer) or
wrap them in insulating material

• Take away the small white drain knob at the bottom of the
freezer

• Turn the black knob at the centre of the louvered plate
outwards and place a flat dish under the drain tube for
collection of defrosted water

• Turn the thermostat knob anticlockwise to position stop, open
the door and wait for the temperature to naturally adjust so
that the ice on the freezing shelves will melt loose.

NEVER USE METAL OR SHARP TOOLS AS A SCRAPER

TROUBLESHOOTING

In the case of operation disturbances, please check the following:

• Is the freezer connected to the mains?

• Is the mains supply intact? (blown fuse etc.)

• Has the freezer recently been filled with fresh food, or has the

door been opened for extended periods?

• Is the thermostat set correctly?

• Is the door properly closed and sealed?

• Is the frost layer on the shelves too thick? If Yes, unplug the

freezer and start a manual defrost

• Is the circulation of air unimpeded? For

GFZ40 – Is the

internal fan motor running?

LOADING OF FREEZER SHELVES

We recommend loading the freezing shelves as evenly as possible.
The maximum load per shelf is 30Kg approx.