Blitz BZCAPT20 User Manual

SPECIFICATIONS

MODEL: BZCAPT20

2 FARAD POWERFUL TRIANGLE CAPACITOR.

Capacitance------------------------------------ 2,000,000 micro farad (2 farad)
Working Voltage------------------------------ 21 DC
Surge Voltage---------------------------------- 24 DC
E.S.R. (Equivalent Series Resistance)------ 0.0015 ohm @120hz/ 25°C
Capacitance Tolerance------------------------ ± 10%

INSTALLATION AND MOUNTING:

You must first attach the mounting tabs to the Stiffening Capacitor before
mounting it. Use the supplied hardware shown in the picture to the right. Notice
the small mounting screw hole in the capacitor chassis.

FEATURES:

Detail function:

a) 4-digit hi-end red light display DC voltage meter that can measure 0.01 DCV

range. And PCB working status Flash blue LEDS (4pcs).

b) Electronic Polarity Protection Circuit. If the capacitor is connected incorrectly

by reversing the positive and negative wires during the installation process, the
PCB will issue a 45 seconds noise to warn you.

c) Over-voltage Protection Circuit. When the install system voltage over 17.5

DCV or LESS 10 DCV limit, the buzz on the PCB will issue an audible noise
warning.

d) Lowest E. S. R. 24 DCV foil with maximum moment discharge power in

lowest E. S. R..

1

CHARGING THE CAPACITOR AND WIRING:

The capacitor must be charged before connecting the Power and Ground cables
to the capacitor. Failure to charge the capacitor will result in a large spark
generated from the rapid inflow of current.

CHARGING

BULB

)(

)(

+

--

BATTERY

To Charge the capacitor:

1. Make Capacitor positive terminal connections with amplifier and tighten
the bolt. Do not over-tighten the bolts!

Caution: Stripped terminals are not covered under the capacitor’s

warranty.

2