USB Wireless LAN Card User Manual
SMOOTH YIELD CORPORATION LIMITED
ROOM1602, 16/F, KOWLOONBUIDING,
555NATHANROAD, MONGKOK, KOWLOON, HONGKONG
1
Product Feature
Rated Voltage: DC 5V
RF Output Power Max. 12.85dBm (Conducted)
Antenna Gain: Max. 0.9 dBi for chain A, 3.0 dBi for chain B
Frequency range: 2412-2462MHz for 11b/g/n(HT20)
Number of channels: 11 for 11b/g/n(HT20), 8 for 11n(HT40)
Channel Separation: 5MHz
Type of Antenna: Integral Antenna
2422-2452MHz for 11n(HT40)
System Requirements
● One available USB 1.1/2.0 port
● Operating System: Windows ME/2000/XP/Vista/win7
● Minimum Disk Space: 2MB
Software Installation
You must have the following information available before installing your Products
.
1. Wireless Network Name (SSID) and,
2. Encryption/Network Key (if applicable)
2
Note: Screen-shot images provided below is based on Windows Vista. You may
see different screen on other operating systems but procedures are the same.
CAUTION: Products should NOT be inserted at this time. You will be asked to insert after the
software is completely installed.
A. Power on your computer and allow Windows 2000/ME/XP/Vista/Win7
to load fully.
B. Install and run “Setup.exe” program. – InstallShield Wizard” will appear on
your screen, select “I accept the terms of the license agreement” then
click “Next.”.
3
C. Click “Install” to begin the installation and it will copy all necessary files to
your hard disk automatically.
D. Click “Finish” when you see “InstallShield Wizard Complete” to finish the
installation.
4
You will see “Configuration & Monitor Utility” icon appears on your
system tray when the installation is completed successfully. If you
don’t see the icon, we highly recommended you to restart the computer.
However, if you still don’t see the icon appears, please uninstall and
reinstall the software again.
FCC WARNING
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to pr ovi de r easo na ble pro tec tion against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receive r .
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
5
Loading...