BASICS
A few simple tools are required:
Measuring tape
Power drill or Phillips head screwdriver
1/4” hex head or phillips driver bit
INST
ALL PLEATED SHADE
1. Attach brackets using the screws provided.
2. Attach the shade to the brackets
a. Unroll the shade making sure that the cords do not tangle
b. Snap the top rail of
the shade into the
brackets by placing the
back edge of the rail
into the brackets.
Rotate the front of the rail until it snaps into place.
c. Attach the lower rail into the brackets using the same
method.
Typical Obst ruct i on
Min. 1" mounting depth with
no obstructions required
1 ½”needed for flush mount
No more than 24”
between brackets
2” to 2 ½”
2” to 2 ½”
Shade Width
Up to 30”
>30”
Total # brackets
4 (2 top, 2 bottom)
6 (3 top, 3 bottom)
This side of
bracket
toward
room
This side of
bracket
toward
glass
TENSION ADJUSTMENT
The tension in these shades has been adjusted.
Re-adjustment should only be done if the shade is difficult
to operate (too much tension) or if the shade droops
excessively (too little tension).
a. Tighten or loosen the tension by resetting the ball chain
and coupler inside the lower rail.
b. Re-insert the ball chain and spring in the rail and check
adjustment. Repeat as necessary.
OPERA
TION
Insert the hook of the
operation pole into one
of the openings in the
handle. Slide the hook
over so that it grabs the
center wall of the handle.
Use the pole to move the
shade to the desired
position.
Coupler
Ball Chain
No Holes Pleated
Skylight Shading System
Installation Instructions
Stock # 152109 Rev.A 2/8/2011
Loading...