1. Do not remove shrink wrap from shade until unit is installed.
Note: Shade should be positioned with the fabric going over
the top and down the back of the shade.
2. Install mounting brackets at desired balance. Clear plastic
button is front of the bracket. Clip back of head rail on to
mounting brackets and snap into place.
Sidemark – limits are pre-set at factory.
3. Controls:
Right side = Positioning Device. The Positioning Device
controls the upper limits (stopping point). To make an
adjustment, turn dial clockwise (right side end view) to lower
the limit.
Left side = Tensioning Device. Tensioning Device controls
the upward speed.
To make an adjustment, turn dial clockwise (left side end
view) to increase speed.
Loading...