4
EN
CAUTION: All instructions and warnings must be
followed exactly. Mishandling of Li-Po batteries can
result in a fi re, personal injury and/or property damage.
• By handling, charging or using the included Li-Po battery,
you assume all risks associated with lithium batteries.
• If at any time the battery begins to balloon or swell,
discontinue use immediately. If charging or discharging,
discontinue and disconnect. Continuing to use, charge or
discharge a battery that is ballooning or swelling can result
in fi re.
• Always store the battery at room temperature in a dry area
for best results.
• Always transport or temporarily store the battery in a
temperature range of 40–120º F (5–49° C). Do not store the
battery or model in a car or direct sunlight. If stored in a hot
car, the battery can be damaged or even catch fi re.
• Always charge batteries away from fl ammable materials.
• Always inspect the battery before charging.
• Always disconnect the battery after charging, and let the
charger cool between charges.
• Always constantly monitor the temperature of the battery
pack while charging.
• ONLY USE A CHARGER SPECIFICALLY DESIGNED TO
CHARGE LI-PO BATTERIES. Failure to charge the battery
with a compatible charger may cause a fi re resulting in
personal injury and/or property damage.
• Never discharge Li-Po cells to below 3V under load.
• Never cover warning labels with hook and loop strips.
• Never leave charging batteries unattended.
• Never charge batteries outside recommended levels.
• Never charge damaged batteries.
• Never attempt to dismantle or alter the charger.
• Never allow minors to charge battery packs.
• Never charge batteries in extremely hot or cold places
(recommended between 40–120° F (5–49° C)) or place in
direct sunlight.
Charging Warnings
Battery Charging
Choose a charger designed to balance charge 3S Li-Po
batteries. We recommend the Dynamite Prophet Sport Li-Po
35W AC Charger (DYNC2005). Refer to your charger manual
for charging instructions.
Transmitter Setup
Program your transmitter before attempting to bind or
fl y the helicopter. Transmitter programming values are
shown below for the Spektrum DX6i, DX7/DX7se, DX6, DX7s,
DX8, DX9 and DX18. The fi les for models using SpektrumTM
transmitters with AirWare™ software are also available for
download online in the Spektrum Community.
DX6i
SETUP LIST
Model Type
HELI
Reverse
THRO N
AILE N
ELEV N
RUDD N
GYRO N
PITC R
Swash Type
1 Servo 90
Timer
3:00
ADJUST LIST
Thro Curve
NORM 0% 25% 25% 25% 25%
STUNT 100% 100% 100% 100% 100%
HOLD 0% 0% 0% 0% 0%
Pitc Curve
NORM 30% 40% 50% 75% 100%
STUNT 0% 25% 50% 75% 100%
HOLD 0% 25% 50% 75% 100%
Travel Adj
THRO Low: 125% Hi: 100%
AILE 100%
ELEV 100%
RUDD 100%
GYRO 100%
PITC 100%
Gyro
Rate SW-F. Mode
NORM 50%
STUNT 50%
First Flight Preparation
• Remove and inspect contents
• Begin charging the fl ight battery
• Install the fl ight battery in the helicopter
(once it has been fully charged)
• Program your computer transmitter
• Bind your transmitter
• Familiarize yourself with the controls
• Find a suitable area for fl ying
Flying Checklist
❏ Always turn the transmitter on fi rst
❏ Plug the fl ight battery into the lead from the ESC
❏ Allow the receiver and ESC to initialize and arm
properly
❏ Fly the model
❏ Land the model
❏ Unplug the fl ight battery from the ESC
❏ Always turn the transmitter off last