Black & Decker V1250 H1, V1250N H1, V4800 H1, V4810 H1, V4820 H1 User Manual

1

www.blackanddecker.co.uk

UK

Ireland

Australia

New Zealand

1

2

3

2

4

1

2

3

5

6

7

8

9

V9650

1

2

3

B

D

F

A

C

E

3

10

11

12

G

H

4

Intended use

Your Black & Decker Dustbuster® hand
held vacuum cleaner has been designed
for light dry vacuum cleaning purposes.
This product is intended for household
use only.

Safety instructions

u Warning! When using battery-

powered appliances, basic safety
precautions, including the following,
should always be followed to reduce

the risk of re, leaking batteries,

personal injury and material damage.

u Read this manual carefully before

using the appliance.

u The intended use is described in this

manual. The use of any accessory or
attachment or the performance of
any operation with this appliance
other than those recommended in
this instruction manual may present a
risk of personal injury.

u Retain this manual for future

reference.

Using your appliance

u Do not use the appliance to pick up

liquids or any materials that could

catch re.

u Do not use the appliance near water.

Do not immerse the appliance in
water.

u Never pull the charger lead to

disconnect the charger from the
socket. Keep the charger lead away
from heat, oil and sharp edges.

Safety of others

u This appliance is not intended for use

by persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience
and knowledge, unless they have
been given supervision or instruction
concerning use of the appliance by a
person responsible for their safety.

u Children should be supervised to

ensure that they do not play with the
appliance.

After use

u Unplug the charger before cleaning

the charger or charging base.

u When not in use, the appliance

should be stored in a dry place.
Children should not have access to
stored appliances.

Inspection and repairs

u Before use, check the appliance for

damaged or defective parts. Check
for breakage of parts, damage to
switches and any other conditions
that may affect its operation.

u Do not use the appliance if any part

is damaged or defective.

u Have any damaged or defective parts

repaired or replaced by an authorised
repair agent.

u Regularly check the charger lead for

damage. Replace the charger if the
lead is damaged or defective.

u Never attempt to remove or replace

any parts other than those specied

in this manual.

Additional safety instructions for
batteries and chargers

Batteries

u Never attempt to open for any reason.
u Do not expose the battery to water.
u Do not expose the battery to heat.
u Do not store in locations where the

temperature may exceed 40 °C.

u Charge only at ambient temperatures

between 10 °C and 40 °C.

u Charge only using the charger

provided with the appliance/tool.

u When disposing of batteries, follow

the instructions given in the section
"Protecting the environment".

u Do not damage/deform the battery

pack either by puncture or impact, as

this may create a risk of injury and re.

u Do not charge damaged batteries.
u Under extreme conditions, battery

leakage may occur. When you notice
liquid on the batteries, proceed as
follows:

u Carefully wipe the liquid off using a

cloth. Avoid skin contact.

5

u In case of skin or eye contact, follow

the instructions below.

Warning! The battery uid may cause

personal injury or damage to property. In
case of skin contact, immediately rinse
with water. If redness, pain or irritation
occurs seek medical attention. In case of
eye contact, rinse immediately with clean
water and seek medical attention.

Chargers

Your charger has been designed for a

specic voltage. Always check that the

mains voltage corresponds to the voltage
on the rating plate.

Warning! Never attempt to replace the
charger unit with a regular mains plug.

u Use your Black & Decker charger only

to charge the battery in the appliance/
tool with which it was supplied. Other
batteries could burst, causing personal
injury and damage.

u Never attempt to charge non-

rechargeable batteries.

u If the supply cord is damaged, it must

be replaced by the manufacturer or an
authorised Black & Decker Service
Centre in order to avoid a hazard.

u Do not expose the charger to water.
u Do not open the charger.
u Do not probe the charger.
u The appliance/tool/battery must be

placed in a well ventilated area when
charging.

Electrical safety

Your charger has been designed for a

specic mains voltage. Always check that

the mains voltage corresponds to the
voltage on the rating plate.

#

Your charger is double

insulated.

Features

1. On/off switch

2. Release button

3. Dust bowl

Fig. A

4. Charging base

5. Charger

Installation

Fitting the charging base to the wall

The charging base can be tted to the

wall to provide a convenient storage and
charging point for the appliance.

Before rst use

Before rst use, the battery must be

charged for at least 16 hours.

Use

Charging the battery (g. D)

u Make sure that the appliance is

switched off. The battery will not be
charged with the on/off switch in
the on position.

u Place the appliance on the charging

base as shown.

u Plug in the charger.
u Switch on at the mains.
u Leave the appliance to charge for

at least 16 hours.

Whilst charging, the charger may
become warm. This is normal and does
not indicate a problem. The appliance
can be left connected to the charger

indenitely.

Important! Place the appliance on the
charging base whenever it is not in use.
Do not charge the battery at ambient
temperatures below 10 °C or above 40 °C.

Operating the appliance (g. E)

u To switch on, slide the on/off switch

(1) forward.

u To switch off, slide the on/off switch

back.

Accessories (g. B & C)

V1250/V4810/V4820/V7210/V9650

These models are supplied with the
following accessories:

u a hard brush (6) for furniture and

stairs (not for V4820)

u a crevice tool (7) for conned spaces
u a soft brush (8) for keyboards and

lamp shades (V4820)

6

V1250/V9650

Two additional accessories are stored in a
portable caddy located in the charging base:

u a soft brush (8) for keyboards and

lamp shades

u an extendable crevice tool (9) for

longer reach in conned spaces

V1250N

This model is not supplied with accessories.

To t an accessory, proceed as follows:

u Take the accessories from the

appliance.

u Insert the appropriate accessory into

the front of the appliance.

Cleaning and maintenance

Warning! Regularly clean the lters.

Cleaning the dust bowl and lters
(g. F & G)

The lters are re-usable and should be

cleaned regularly.

u Press the release button (2) and

remove the dust bowl (3).

u Empty the dust bowl.
u Remove the lters (10) by twisting

them clockwise.

u Brush any loose dust off the lters.
u Wash the lters in warm, soapy

water. The bowl can also be washed
if necessary. Do not immerse the
appliance in water.

u Make sure the dust bowl and lters

are dry.

u Ret the lters (10) onto the appliance,

twisting them counterclockwise until
they lock into place.

u Ret the dust bowl onto the

appliance. Make sure the dust bowl
clicks into place.

Warning! Never use the appliance

without the lters. Optimum dust

collection will only be achieved with clean

lters and an empty dust bowl.

Replacing the lters

The lters should be replaced every 6 to

9 months and whenever worn or

damaged. Replacement lters are

available from your Black & Decker
dealer (cat. no. VF20).

u Remove the old lters as described

above.

u Fit the new lters as described above.

Maintenance

Your tool has been designed to operate
over a long period of time with a
minimum of maintenance. Continuous
satisfactory operation depends upon
proper tool care and regular cleaning.

Warning! Before performing any
maintenance, switch off and unplug the tool.

u Switch off and unplug the

appliance/tool.

u Or switch off and remove the battery

from the appliance/tool if the appliance/
tool has a separate battery pack.

u Or run the battery down completely if

it is integral and then switch off.

u Unplug the charger before cleaning it.

Your charger does not require any
maintenance apart from regular
cleaning.

u Regularly clean the ventilation slots in

your tool using a soft brush or dry cloth.

u Regularly clean the motor housing

using a damp cloth. Do not use any
abrasive or solvent-based cleaner.

u Regularly open the chuck and tap it

to remove any dust from the interior

(when tted).

Protecting the environment

Z

Separate collection. This

product must not be disposed of
with normal household waste.

Should you nd one day that your
Black & Decker product needs replacement,
or if it is of no further use to you, do not
dispose of it with household waste. Make
this product available for separate collection.

z

Separate collection of used

products and packaging allows
materials to be recycled and
used again. Re-use of recycled
materials helps prevent
environmental pollution and
reduces the demand for raw
materials.

7

Local regulations may provide for separate
collection of electrical products from the
household, at municipal waste sites or by the
retailer when you purchase a new product.

Black & Decker provides a facility for the
collection and recycling of Black & Decker
products once they have reached the end
of their working life. To take advantage of
this service please return your product to
any authorised repair agent who will collect
them on our behalf.

You can check the location of your
nearest authorised repair agent by
contacting your local Black & Decker

ofce at the address indicated in this

manual. Alternatively, a list of authorised
Black & Decker repair agents and full
details of our after-sales service and
contacts are available on the Internet at:

www.2helpU.com

Battery (g. H)

'h/ Black & Decker batteries can

be recharged many times. At
the end of their useful life,
discard batteries with due care
for our environment.

If you want to dispose of the product
yourself, the battery must be removed as
described below and disposed of in
accordance with local regulations.

u Discharge the battery by operating

the appliance until the motor stops.
The battery is located under the back
end of the appliance.

u Remove the crevice tool from the

accessory holder.

u Push the slider (12) towards the front

of the product.

u Remove the accessory holder.
u Strike the product on a rm and

stable surface as shown in g. H to

dislodge the battery.

u Place the battery in suitable

packaging to ensure that the

terminals cannot be short-circuited.

u Take the battery to your service

agent or a local recycling station.

Warning! Once removed, the battery

cannot be retted.

Technical data
V1250 H1 V1250N H1

Voltage V 12.0 12.0
Weight kg 1.8 1.7

V4800 H1 V4810 H1

Voltage V 4.8 4.8
Weight kg 1.2 1.2

V4820 H1 V7210 H1

Voltage V 4.8 7.2
Weight kg 1.2 1.4

V9650 H1

Voltage V 9.6
Weight kg 1.6

Charger

Input voltage VAC 230
Approx. charging time h 16

LpA (sound pressure): 85 dB(A), hand/arm

weighted vibration 2,5 m/s

2

8

Guarantee

Black & Decker is condent of the quality

of its products and offers an outstanding
guarantee. This guarantee statement is
in addition to and in no way prejudices
your statutory rights. The guarantee is
valid within the territories of the Member
States of the European Union and the
European Free Trade Area.

If a Black & Decker product becomes
defective due to faulty materials,
workmanship or lack of conformity, within
24 months from the date of purchase,
Black & Decker guarantees to replace
defective parts, repair products subjected
to fair wear and tear or replace such
products to ensure minimum
inconvenience to the customer unless:

u The product has been used for trade,

professional or hire purposes;

u The product has been subjected to

misuse or neglect;

u The product has sustained damage

through foreign objects, substances

or accidents;

u Repairs have been attempted by

persons other than authorised repair

agents or Black & Decker service staff.
To claim on the guarantee, you will need
to submit proof of purchase to the seller
or an authorised repair agent. You can
check the location of your nearest
authorised repair agent by contacting

your local Black & Decker ofce at the

address indicated in this manual.
Alternatively, a list of authorised
Black & Decker repair agents and full
details of our after-sales service and
contacts are available on the Internet at:

www.2helpU.com

Please visit our website
www.blackanddecker.co.uk to
register your new Black & Decker
Product and to be kept up to date on new
products and special offers. Further
information on the Black & Decker brand
and our range of products is available at

www.blackanddecker.co.uk

9

TYP.

www.2helpU.com

17 - 07 - 09

E15778

H1

V1250N

103

104

180

110

120

130

140

160

150

170

102

101

109

10

11

ENGLISH

Do not forget to register your product!

www.blackanddecker.co.uk/productregistration

Register your product online at www.blackanddecker.co.uk/productregistration or

send your name, surname and product code to Black & Decker in your country.

90553301

T-07/09

Australia Black & Decker (Australia) Pty. Ltd. Tel. [phone]
20 Fletcher Road, Mooroolbark, Fax [phone]
Victoria, 3138

New Zealand Black & Decker Tel. [phone]
5 Te Apunga Place Fax [phone]
Mt Wellington
Auckland 1060

United Kingdom Black & Decker Tel. [phone]
210 Bath Road Fax [phone]
Slough, Berkshire SL1 3YD Helpline 01753 574277