Black & Decker Svj520bfs Instruction Manual

www.blackanddecker.co.uk

SVJ520BFS

1 1413

2

8a

3

4

5

5A

6

7

8

10

9

12

11

2

3a

1

3

A

C

B

4

3

6

6

17

D

8

8

E

3

3

8

H

F

5

6

11

12

G

109

I

J

4

7

K L

14

13

M

N

5

14

O

6

10

P

16

Q

6

R

ENGLISH

(Original instructions)

Intended use

Your BLACK+DECKER SVJ520BFS Dustbuster® hand-held
vacuum cleaners have been designed for vacuum cleaning
purposes. These appliances are intended for household use
only.

Read all of this manual carefully
before operating the appliance.

Safety instructions

Warning! Read all safety

@

warnings and all instructions

Failure to follow the warnings
and instructions listed below may

result in electric shock, re and/or

serious injury.

u The intended use is described in this

manual. The use of any accessory
or attachment or the performance
of any operation with this appliance
other than those recommended in this
instruction manual may present a risk
of personal injury.

u Retain this manual for future

reference.

.

if they have been given supervision
or instruction concerning use of
the appliance in a safe way and
understand the hazards involved.
Children shall not play with the
appliance. Cleaning and user
maintenance shall not be made by
children without supervision.

Inspection and repairs

Before use, check the appliance for
damaged or defective parts. Check for
breakage of parts, damage to switches
and any other conditions that may affect
its operation.

u Do not use the appliance if any part is

damaged or defective.

u Have any damaged or defective parts

repaired or replaced by an authorized
repair agent.

u Regularly check the charger lead for

damage. Replace the charger if the
lead is damaged or defective.

u Never attempt to remove or replace

any parts other than those specied in

this manual.

Using your appliance

u Do not use the appliance to pick up

liquids or any materials that could

catch re.

u Do not use the appliance near water.
u Do not immerse the appliance in water.
u Never pull the charger lead to

disconnect the charger from the
socket. Keep the charger lead away
from heat, oil and sharp edges.

u This appliance can be used by

children aged from 8 years and above
and persons with reduced physical,
sensory or mental capabilities or
lack of experience and knowledge

Additional safety instructions

After use

u Unplug the charger before cleaning the

charger or charging base.

u When not in use, the appliance should

be stored in a dry place.

u Children should not have access to

stored appliances.

Residual risks

Additional residual risks may arise when
using the tool which may not be included
in the enclosed safety warnings. These
risks can arise from misuse, prolonged
use etc.

7

ENGLISH

(Original instructions)

Even with the application of the relevant
safety regulations and the implementa­tion of safety devices, certain residual
risks can not be avoided. These include:

u Injuries caused by touching any

rotating/moving parts.

u Injuries caused when changing any

parts, blades or accessories.

u Injuries caused by prolonged use

of a tool. When using any tool for
prolonged periods ensure you take
regular breaks.

u Impairment of hearing.
u Health hazards caused by breathing

dust developed when using your
tool (example:- working with wood,
especially oak, beech and MDF.)

Chargers

Your charger has been designed for a

specic voltage. Always check that the

mains voltage corresponds to the voltage
on the rating plate.
Warning! Never attempt to replace the
charger unit with a regular mains plug.

u Use your BLACK+DECKER charger

only to charge the battery in the
appliance with which it was supplied.
Other batteries could burst, causing
personal injury and damage.

u Never attempt to charge non-

rechargeable batteries.

u If the supply cord is damaged, it must

be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.

u Do not expose the charger to water.
u Do not open the charger.
u Do not probe the charger.
u The appliance/battery must be

placed in a well ventilated area when
charging.

Electrical safety

Symbols on the charger

Read all of this manual carefully before using the

appliance.

This tool is double insulated; therefore no earth wire

is required. Always check that the power supply

#

corresponds to the voltage on the rating plate.

Short circuit proof safety isolating transformer. The

mains supply is electrically separated from the

w

transformer output.

The charger automatically shuts off if the ambient

temperature becomes too high. As a consequence

x

the charger will be inoperable. The charging base
must be disconnected from the mains supply and
taken to an authorised service centre for repair.

The charging base is intended for indoor use only.

$

Labels on appliance

The following symbols appear on this appliance along with the
date code

Read all of this manual carefully before

+

S010Q 23

Features

This tool includes some or all of the following features.

1. On/off power switch

2. Nozzle

3. Pull out crevice tool

4. Push in brush

5. Handle On/off power switch

5A. Brush control

6. Handle

7. Charging base

8. Chassis
8a. Chassis release button

Use

Switching on and off (Fig. A)

u To switch on, press the on/off switch (1) located on the

handle of the Dustbuster®, or alternatively on the chassis
handle (5).

u Press the button again (1 or 5), and the unit goes to a

BOOST mode.

u To switch off, press the on/off switch (1) or (5).

using the appliance

Only use with charger S010Q 23

8

ENGLISH

(Original instructions)

Using the pull out crevice tool (Fig. B,C)

u Extend the crevice tool (3) as shown in gure C, until

it clicks in place. The push in brush (4) can be tted if

required for dusting and upholstery cleaning.

u To retract the crevice tool (3) press the crevice tool release

button (3a) allowing it to return to its normal position
(Fig. B).

Multi LED Display

A

Fitting the handle to the main chassis
(Fig. D, E)

u Slide the handle (6) into the main chassis (8) as shown in

gure D.

u Secure with retaining screw (17) as shown in gure E.

Fitting the Dustbuster® to the Chassis
(Fig. F, G, H)

u Slide the Dustbuster

until an audible ‘click’ is heard as shown in gure F.

u To release the Dustbuster

chassis release button (8a) and lift clear.

u The appliance can now be operated via the on/off button

(5) on the handle (6) along with the ‘BOOST’ mode as

shown in gure H. This also allows you to utilise the beater

bars via the ‘brush on’ control (5A).

®

, nozzle rst, into the chassis (8)

®

from the chassis press the

Removing and clearing the beater bars
(Fig. I, J)

u To remove the beater bar unit (9) from the oor head (10)

Depress the release button (11) as shown in gure I.

u The beater bar (12) can now be removed. The end pieces

are also removable allowing you to clear the brushes from
any hair or other debris that may have accumulated (Fig.
J).

Charging (Fig. K, L)

u Place the appliance into the charging base (7) as shown in

gure K .

u Plug the charging port (7) into an electrical outlet.
u Switch the electrical outlet on. The LED charging indicator

(B) will Illuminate (Fig. L).

B

C

A. Filter sensor

Whenever a lter is Blocked and needs cleaning, the red

lter LED (A) in the handle will illuminate.

Clean ne dust from lter (See section on ‘cleaning lters’

in this manual).

B. LED Charging display

Battery icon (B) will illuminate when appliance requires

charging. Led display indicates state of charge (See LED
pattern chart in this manual).

C. BOOST mode

Illuminates when the appliance is in BOOST mode

allowing you to operate at higher power.

LED Patterns

Charging

Battery Fault

Charger Fault

Battery Hot

9

ENGLISH

(Original instructions)

Cleaning the lters (Fig. M, N, O, P, Q,

R )

u Press the dust bowl release button (13) (Fig. M)
u Eject the dust bowl (14) (Fig.N)
u Lift the lter assembly (15) from the dust bowl (14) (Fig.O).

u Empty the dust bowl by lightly shaking over a dustbin

(Fig. P).

Note: The pre filter is impregnated with a fragrance allowing
for a pleasing odour to be released when the appliance is in
use.

u The lter (16) can now be removed from the pre lter (15)

Figure Q.

u Empty any remaining dust from the dust bowl.
u Rinse out the dust-bowl with warm soapy water.
u Wash the lters with warm soapy water (Fig. R).
u Make sure the lters are dry
u Ret the lters onto the appliance.
u Close the dust-bowl. Make sure the release latch (13)

clicks into place.

Warning! Before performing any maintenance or cleaning on
the appliance, unplug the appliance.

From time to time wipe the appliance with a damp cloth.
Do not use any abrasive or solvent-based cleaner. Do not
immerse the appliance in water

Maintenance

Your BLACK+DECKER cordless appliance has been designed
to operate over a long period of time with a minimum of main­tenance. Continuous satisfactory operation depends upon
proper tool care and regular cleaning.
Warning! Before performing any maintenance on cordless
appliances:

u Run the battery down completely if it is integral and then

switch off.

u Unplug the charger before cleaning it. Your charger does

not require any maintenance apart from regular cleaning.

u Regularly clean the ventilation slots in your appliance/

charger using a soft brush or dry cloth.

u Regularly clean the motor housing using a damp cloth. Do

not use any abrasive or solvent-based cleaner.

Warning!

Cotton linen fragrance.

Wash face, hands and any exposed skin
thoroughly after handling. Wear protective

gloves/protective clothing/eye protection/

face protection. If in eyes: Rinse cautiously
with water for several minutes. Remove
contact lenses if present and easy to do.
Continue rinsing. If skin irritation occurs: Get

medical advice/attention. Avoid release into

the environment. Do not ingest.

u Remove the old lters as described above.
u Fit the new lters as described above.

Protecting the environment

Separate collection. Products and batteries
marked with this symbol must not be disposed of
with normal household waste.

Z

Products and batteries contain materials that can be recov­ered or recycled reducing the demand for raw materials.
Please recycle electrical products and batteries according to
local provisions. Further information is available at
www.2helpU.com

Technical Data

SVJ520BFS

Voltage 18V

Watt hours 40Wh

Weight 2.8Kg

Replacing the lters

The lters should be replaced every 6 to 9 months and
whenever worn or damaged. Replacement lters are available

from your BLACK+DECKER dealer (cat. no: VPF20). There

are also pre-scented lters available to be purchased (cat.
no: VSPF10LC). These t all units.When these lters reach

the end of their lifespan they must be disposed of at a local
recycling centre.

10

ENGLISH

(Original instructions)

Guarantee

Black & Decker is condent of the quality of its products and

offers an outstanding guarantee. This guarantee statement is
in addition to and in no way prejudices your statutory rights.
The guarantee is valid within the territories of the Member
States of the European Union and the European Free Trade
Area.

If a Black & Decker product becomes defective due to faulty
materials, workmanship or lack of conformity, within 24
months from the date of purchase, Black & Decker guarantees
to replace defective parts, repair products subjected to fair
wear and tear or replace such products to ensure minimum
inconvenience to the customer unless:

u The product has been used for trade, professional or hire

purposes;

u The product has been subjected to misuse or neglect;
u The product has sustained damage through foreign

objects, substances or accidents;

u Repairs have been attempted by persons other than

authorised repair agents or Black & Decker service staff.

To claim on the guarantee, you will need to submit proof of
purchase to the seller or an authorised repair agent. You can
check the location of your nearest authorised repair agent by
contacting your local Black & Decker ofce at the address indi­cated in this manual. Alternatively, a list of authorised Black &
Decker repair agents and full details of our after-sales service
and contacts are available on the Internet at: www.2helpU.
com

Please visit our website www.blackanddecker.co.uk to register
your new BLACK+DECKER product and to be kept up to
date on new products and special offers. Further information
on the BLACK+DECKER brand and our range of products is

available at www.blackanddecker.co.uk

11

90633712 REV-0

Australia Black & Decker (Australia) Pty. Ltd. Tel. [phone]
20 Fletcher Road, Mooroolbark, Fax [phone]
Victoria, 3138

New Zealand Black & Decker Tel. [phone]
5 Te Apunga Place Fax [phone]
Mt Wellington
Aukland 1060

United Kingdom & Black & Decker Tel. [phone]
Republic Of Ireland 210 Bath Road Fax [phone]

www.blackanddecker.co.uk Slough, Berkshire SL1 3YD
[e-mail]

12/2015