Black & Decker SM229-SRVC User Manual

SM229-SRVC & CM929-SRVC Swivel Vent Universal Mobile Phone or PDA Mount

CM047-S2 (Dual T-tab) CM047-S (Single T-tab)

Flat side face up

(A)

Pedestal Assembly

Step 1.

Attach the vent mounting clips (A) to the back of the pedestal (B) with the vent clips positioned with the flat sides facing up.

SM229-SRVC

SM020-2 SM020

(B)

CM929-SRVC

CM047-S2 (Dual T-tab) CM047-S (Single T-tab)

(F)

(B)

(E)

(D)

Pedestal Adjustment & Device Cradle Installation

Step 1.

Adjust the swivel angle of the pedestal head by firmly holding the back of the pedestal (B), pulling out the pedestal head and twisting to the desired angle. Adjust the lateral angle of the pedestal head (E) by simply twisting the head on the pivot axis (D).

CM090-2 CM090

(C)

Insertion of Pedestal into the Air Vent

Step 1.

Pinch the vent mounting clips (A) so that the teeth open and gently insert vent pedestal into vent louvres until the mounting clips are attached to the fin/blade of the vent. Adjust the support leg (C) vertically until it rests firmly along the bottom of the vent or dash surface below the vent.

Pedestal Removal

Remove the device from the vent mount assembly.

Pinch the vent clips (A) so that the teeth open.

Step 3.

Step 1.

Step 2.

(A)

Carefully slide the pedestal from the vent/blade. Make sure the teeth of the vent clips are open enough so as not to damage the vent.

Use caution when adjusting the swivel movement to avoid damaging your air vents.

Step 2.

Attach the device cradle to the pedestal by inserting the dual TTabs of the pedestal (E) into the T-slots of the cradle (F).

(A)

(I)

(J)

Universal Cradle Instructions

Step 1.

Step 2.

Step 3.

If necessary, adjust the support legs (K) by sliding them laterally. These provide support for your device.

Place device on the support legs (K) and squeeze the side grip arms (I) until they fit securely to the device.

Push the release button (J) in order to release the device from the cradle.

(K)

Safety Precautions

Do not install Arkon products over an air bag cover or within the air bag deployment zone. Arkon Resources, Inc. assumes no responsibility of liability for injury or death as a result of car crashes and/or air bag deployment.

Arkon Resources, Inc. is not responsible for any damages caused to your air vent louvres, car, device or yourself as a result of the installation or use of this mount.

Consumer Hotline: (USA) (800) 841-0884 (INT'L) (626) 254-9005 Mon-Fri. 9am-5pm, PST

The Mobile Mounting Specialists

Arcadia, CA 91006 USA

www.arkon.com

Made in Taiwan