Page 1
F150
English 02
www.blackanddecker.com
Page 2
ENGLISH
2
Parts Identification
1. Cord Set
2. Heel Rest
3. Temperature control dial
4. Indicator Lamp
5. Soleplate
6. Button Grooves
7. Spray Button
8. Release Bottom
7
8
3
4
1
6
5
2
Page 3
3
ENGLISH
Intended use
Read this entire manual carefully
before using the appliance.
F150
Spray Iron
Technical Data
Voltage 220 – 240
Supply 50/60
Power consumption 1000
Volts
Hz
W
Iron
F150
Your Black & Decker Iron has been designed to
iron clothing for household use only.
Safety instructions
When using electrical appliances, in order to
reduce the risk of fire, electric shock, and/or
injury to persons, basic safety precautions
should be followed, including the following:
Read all instructions carefully, even if you
are familiar with the appliance.
To protect against the risk of electric
shock, DO NOT IMMERSE the appliance,
cord set or plug in water or other liquids
To clean, wipe the exterior with a damp
cloth
Close supervision is necessary when any
appliance is used by or near children.
Never leave an appliance unattended
when in use
Switch off and remove the plug from the
power outlet when not in use before
assembling or disassembling parts, and pull
from power outlet. Never pull the cord.
Do not operate nay appliance with a
damaged cord or plug, or after the
appliance malfunctions, or is dropped or
damaged in any manner. Return the
complete appliance to your nearest
authorized service facility for examination,
electrical repair, mechanical repair or
adjustment.
The use of attachments or accessories not
recommended or sold by this appliance
manufacture may result in fire, electric
shock or personal injury.
Do not let the cord hang over the edge of a
table, counter, or touch hot surfaces.
Avoid touching hot surface, use handles
and knobs.
Do not operate or place any part of this
appliance on or near any hot surfaces (such
as gas or electric burner or in a heated
oven)
Do not abuse the cord. Never carry the
appliance by the cord or yank it to disconnect it from the outlet;instead,grasp the plug
and pull o disconnect.
When using an extension cord with your
appliance, make sure the extension cord is
correctly wired and rated for its use.
This product is intended for household use
only.
Do not attempt to pair the appliance
yourself;instead,take it to your Black &
Decker-Owned or Authorized Service
Centre for repair
This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or lack
Page 4
4
ENGLISH
of experience and knowledge, unless they
have been given supervision or instruction
concerning use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that
they do not play with the appliance.
the iron must be used and rested on a
stable surface
when placing the iron on its stand,
ensure that the surface on which the
stand is placed is stable
the iron is not to be used if it has been
dropped, if there are visible signs of
damage or if it is leaking
The iron must not be left unattended
while it is connected to the supply mains
the plug must be removed from the
socket-outlet before the water reservoir is
filled with water
the filling aperture must not be opened
during use. instructions for the safe
refilling of the water reservoir shall be
given
Mains Plug Replacement
If a new mains plug needs to be fitted:
Safely dispose of the old plug
Connect the brown lead to the live
terminal of the new plug
Connect the blue lead to the neutral
terminal
If the product is class I (earthed),connect
the green/yellow lead to the earth terminal
Warning! If your product is class II double
insulated(only 2 wires in the cord set),no
connection is to be made to the earth terminal.
Follow the fitting instruction supplied with
good quality plugs.
Any replacement fuse must be of the same
rating as the original fuse supplied with the
product.
Features
Temperature control dial for setting the
correct temperature for the fabric
Non stick coated(F150)soleplate for safe
and smooth ironing
Fine mist spray for sharper creases
Indicator lamp shows power status
Full length button grooves maker ironing
around buttons easier
Swivel cord for durability and ease of use
How to use your Spray Iron
This iron is designed to iron clothing for
household use only.
Before the first use, check if the voltage rating
on the base plate corresponds to the mains
voltage in you home. Route the cord properly to
avoid tripping. Connect the plug to a standard
domestic outlet. Stand the iron on its heel. Turn
the temperature dial to the correct fabric setting.
The thermostat light will glow indicating the iron
is heating up. When the light goes out, the
required the temperature has been reached.
Always test the temperature by first ironing a
hem or similar area. Remember, an iron heats
up faster than is cools down. So start with cool
fabric and work up to hotter setting. If you turn a
setting down, allow the temperature to adjust
before continuing ironing.
Unplug the iron from the electricity supply
immediately after use. Unplug the iron by
gripping the plug and pulling it from the outlet.
Never yank on the cord.
Page 5
5
ENGLISH
How to use the spray accessory
Always make sure that the iron is unplugged
and not hot while filling water into the spray
accessory. Press the Accessory release button
on top to releases the spray accessory. Pull the
water tank off the accessory from below .Fill the
water tank from a water source. Ensure that the
water is filled only till the max line. Press the
water tank back into position. Push the
accessory back into the slot till you hear the
click sound indicating that it is locked.
Press the plastic button on top to get a fine mist
spray. Fine mist spray can be used on clothes
whenever doing a crease or thicker material like
cotton and denim.
How to care for your Spray Iron
Wipe thoroughly with a damp cloth or sponge.
Never use abrasives, heavy duty cleansers,
vinegar or scouring pads.
Do not use metal scouring pad since they will
scratch the soleplate.
After the iron is cooled completely, wind the
cord around the storage wrap on the heel of the
iron. Do not wind too tightly as this can damage
the iron.
Suggestions before using the
iron for the first time
1. Certain parts of the iron have been lightly
greased therefore the iron could give off a
little smoke when plugged in for the first
time. This will cease after a short while.
2. Before using the iron for the first time,
remove the plastic protector from the base
(if it has one) clean the base with a soft
cloth.
3. Keep the base very smooth. Do not run it
over metal objects (such as against the
ironing board, buttons, zips, etc.)
4. Pure wool fibres (100% wool) can be
ironed with the appliance in the steam
position .by preference, select a high
steam position and use a dry ironing
cloth.
Selecting the temperature
1. Check the ironing instructions on the
garment to be ironed.
2. If the garment does not have any ironing
instructions but you know the kind of
fabric in question, use the chart below.
3. Fabrics that have some kind of finish
(polishing. wrinkles, contrasts….) can be
ironed at the lowest temperatures.
4. If the fabric contains several kinds of
fibres, always select the temperature
applicable, if an article contains 60%
polyester and 40% cotton, you must
always choose the temperature
corresponding to polyester and without
steam.
5. First classify the articles to be ironed
according to the most suitable ironing
temperature: wool with wool, cotton with
cotton, etc. as the iron heats up as fast
as it cools, start by ironing the articles
requiring the lowest temperature such as
those made of synthetic fibres. Progress
towards those that require the highest
temperatures.
Page 6
6
ENGLISH
Protecting the environment
Separate collection. This product must not
be disposed of with normal household
waste.
Should you find one day that your Black &
Decker product needs replacement, or if it is of
no further use to you, do not dispose of it with
household waste. Make this product available
for separate collection.
Separate collection of used products and
packaging allows materials to be recycled and
used again. Re-use of recycled materials helps
prevent environ-mental pollution and reduces
the demand for raw materials.
Local regulations may provide for separate
collection of electrical products from the
household, at municipal waste sites or by the
retailer when you purchase a new product.
Service Information
Black & Decker offers a full network of
company-owned and authorized service
locations throughout Asia. All Black & Decker
Service Centers are staffed with trained
personnel to provide customers with efficient
and reliable power tool service. Whether you
need technical advice, repair, or genuine factory
replacement parts, contact the Black & Decker
location nearest to you.
Notes
Black & Decker's policy is one of continuous
improvement to our products and, as such,
we reserve the right to change product
specifications without prior notice
Standard equipment and accessories may
vary by country
Product specifications may differ by country
Complete product range may not be
available in all countries
Contact your local Black & Decker dealers
for range availability
•
•
•
•
•
6. Turn the temperature control until it is in
front of the appropriate signal according to
the following:
· position for nylon and acetate
·· position for wool ,silk or mixtures
··· position for cotton or linen (steam).
NOTE:
Do not touch the soleplate while the iron is hot.
Do not leave the iron unattended while
connected to the electrical supply.
Never immerse the spray iron in water.
Loading...