Black & Decker DK35 User Manual
www.blackanddecker.ae
DK35
ENGLISH
Parts Identification
1. Lid
2. On/Off button
3. Indicator light
4. Pouring spout
5. Handle
6. Power base
4
5
1
3
2
6
2
ENGLISH
Intended use
Your Black & Decker kettle has been designed
for boiling water as described in this manual. Do
not use this appliance for any other purpose.
This product is intended for household use only.
Read this entire manual carefully
before using the appliance.
Denotes the risk of electric shock.
Safety instructions
Warning! When using mains-powered
appliances, basic safety precautions, including
the following, should always be followed to
reduce the risk of fire, electric shock, personal
injury and material damage.
• The intended use is described in this manual.
The use of any accessory or attachment or
the performance of any operation with this
appliance other than those recommended in
this instruction manual may present a risk of
personal injury.
• Retain this manual for future reference.
• Always route the cord carefully to avoid a
tripping hazard.
• Never operate an appliance directly below
the socket-outlet it is connected to.
Using your appliance
• Never pull the power supply cord to
disconnect the plug from the socket. Keep the
power supply cord away from heat, oil and
sharp edges.
• Do not place the appliance on or near heat
sources or in a heated oven.
• Do not use the appliance near flammable or
explosive materials.
• Do not use the appliance outdoors.
• Operate the appliance only with dry hands.
• If the power supply cord is damaged during
use, disconnect the appliance from the power
supply immediately. Do not touch the power
supply cord before disconnecting from the
power supply.
• Disconnect the appliance from the power
supply when not in use, before fitting or
removing parts and before cleaning.
Safety of others
• This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless
they have been given supervision or
instruction concerning use of the appliance by
a person responsible for their safety.
• Children should be supervised to ensure that
they do not play with the appliance.
• The temperature of accessible surfaces may
be high when the appliance is operating.
• Do not touch hot surfaces.
• Always take care when using the appliance.
• Do not allow children or any person unfamiliar
with these instructions to use the appliance.
• Do not allow children or animals to come near
the work area or to touch the appliance or
power supply cord.
3
ENGLISH
• Close supervision is necessary when the
appliance is used near children.
After use
• Switch off and remove the plug from the
socket before leaving the appliance
unattended and before changing, cleaning or
inspecting any parts of the appliance.
• When not in use, the appliance should be
stored in a dry place. Children should not
have access to stored appliances.
Inspection and repairs
• Before use, check the appliance for
damaged or defective parts. Check for
breakage of parts, damage to switches and
any other conditions that may affect its
operation.
• Do not use the appliance if any part is
damaged or defective.
• Have any damaged or defective parts
repaired or replaced by an authorised repair
agent.
• Before use, check the power supply cord for
signs of damage, ageing and wear.
• Do not use the appliance if the power supply
cord or mains plug is damaged or defective.
• If the power supply cord or mains plug is
damaged or defective it must be repaired by
an authorised repair agent in order to avoid a
hazard. Do not cut the power supply cord
and do not attempt to repair it yourself.
• Never attempt to remove or replace any
parts other than those specified in this
manual.
• Do not attempt to repair the appliance. Take
it to your nearest Black & Decker-owned or
authorised Service Centre for repair.
Electrical safety
This product must be earthed. Always
check that the power supply corresponds
to the voltage on the rating plate.
• Power plugs must match the outlet. Never
modify the plug in any way. Do not use any
adapter plugs with earthed (Class 1)
appliances. Unmodified plugs and matching
outlets will reduce the risk of electric shock.
Extension cables & Class 1
product
• A 3-core cable must be used as your
appliance is earthed and of Class 1
construction.
• Up to 30m (100ft) can be used without loss of
power.
To avoid the risk of electric shock, do not
immerse the cord, plug or appliance in
water or other liquid.
• If the supply cord is damaged, it must be
replaced by the manufacturer or an
authorized Black & Decker Service Center in
order to avoid a hazard.
Mains plug replacement
If a new mains plug needs to be fitted:
• Safely dispose of the old plug
• Connect the brown lead to the live terminal of
the new plug
4
ENGLISH
• Connect the blue lead to the neutral terminal
• If the product is class I (earthed), connect the
green/yellow lead to the earth terminal.
Note: If your product is class II double insulated
(only 2 wires in the cord set), no connection is to
be made to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs
Any replacement fuse must be of the same
rating as the original fuse supplied with the
product.
Warning! The above section on mains plug
replacement is for authorized service centre
personals.
Before first use
• Remove all packaging from the appliance.
• Clean the appliance before first use.
• Fill the kettle with cold water to the maximum
fill mark. Do not over fill as described below.
• Close the lid (1). Boil the water as described
below.
• Discard the boiled water and repeat the
procedure.
Use
Warning! Always place the appliance on a flat,
clean and non-slip surface before operating it.
Warning! Always allow the product and
contents to cool before opening the lid / re-filling.
Warning! Always open the lid so that any steam
will be directed away from you.
Warning! Always check the water level while
using the appliance. Never use the appliance
without sufficient water.
Warning! Steam may escape from the spout.
Warning! This Kettle must only be used with the
Kettle base provided.
• Place the kettle base (6) on a suitable
surface.
• Take the kettle to a water outlet. Remove the
lid (1).
• Fill the kettle with cold water to the desired
level.
• To prevent dry-boiling fill to at least 500 ml
(two cups).
• Do not fill the kettle beyond the maximum fill
mark. If the kettle is overfilled, boiling water
may be ejected from the pouring spout (4).
• Fit the lid (1) and make sure it snaps into
place.
• Place the kettle on the kettle base (6).
• Insert the plug into a suitable electrical outlet
and push the on/off switch (2) to the on
position (I).
• The power on indicator (3) will light.
• The water will start boiling, making a
rumbling noise. Do not open the lid when the
water is boiling.
• As soon as the water has boiled, the
appliance will switch off and the power on
indicator (3) will go out.
• Always ensure the Kettle has turned off
before lifting it from the Kettle base.
5
ENGLISH
• To switch the appliance off during boiling,
push the On / Off switch (2) the off position
(O).
• If you do not want to use the boiled water
immediately, the kettle may be left on the
base. If you want to bring the water back to
boil after a while, push the on / off switch (2)
to on again.
Pouring boiling water
• Make sure the appliance is switched off.
• Take the kettle off the base.
• To avoid scalding, tilt the kettle slowly to pour
the boiled water.
• After pouring, place the kettle back on the
base and remove the plug from the socket.
Cleaning and maintenance
Before cleaning and maintenance, remove the
plug from the socket and allow the appliance to
cool.
• Do not immerse the appliance in water or any
other liquid.
Technical data
DK35
Voltage 220 – 240 Volts
Supply 50/60 Hz
Power consumption 2500-3000W
Cable length 0.67 metres
Capacity 1.7 Litres
Weight 1.2 kg
Warning! Before cleaning and maintenance,
switch the appliance off, remove the plug from
the socket and allow the appliance to cool.
Warning!Do not immerse the appliance, the
base, the cord set or the plug in water or any
other liquid.
• Wipe the exterior with a damp cloth.
• Do not use scouring pads.
• If necessary, use a mild detergent to remove
spots.
• Do not use any abrasive or solvent based
cleaner.
6
ENGLISH
Protecting the environment
Separate collection. This product must not
be disposed of with normal household
waste.
Should you find one day that your Black &
Decker product needs replacement, or if it is of
no further use to you, do not dispose of it with
other household waste. Make this product
available for separate collection.
• Black & Decker provides a facility for
recycling Black & Decker products once they
have reached the end of their working life.
This service is provided free of charge. To
take advantage of this service please return
your product to any authorised repair agent
who will collect them on our behalf.
• You can check the location of your nearest
authorised repair agent by contacting your
local Black & Decker office at the address
indicated in this manual. Alternatively, a list of
authorized Black & Decker repair agents and
full details of our after-sales service and
contact are available on the Internet at:
www.2helpU.com.
Warranty
Black & Decker is confident of the quality of its
products and offers an outstanding warranty.
This warranty statement is in addition to and in
no way prejudices your statutory rights.
The warranty is valid within the territories of the
Member States of the European Union and the
European Free Trade Area.
If a Black & Decker product becomes defective
due to faulty materials, workmanship or lack of
conformity, within 24 months from the date of
purchase, Black & Decker warranty to replace
defective parts, repair products subjected to fair
wear and tear or replace such products to ensure
minimum inconvenience to the customer unless:
The product has been used for trade,
professional or hire purposes;
The product has been subjected to misuse
or neglect;
The product has sustained damage
through foreign objects, substances or
accidents;
Repairs have been attempted by persons
other than authorised repair agents or
Black & Decker service staff.
To claim on the warranty, you will need to submit
proof of purchase to the seller or an authorised
repair agent. You can check the location of your
nearest authorised repair agent by contacting
your local Black & Decker office at the address
indicated in this manual.
Alternatively, a list of authorised Black & Decker
repair agents and full details of our after-sales
service and contacts are available on the Internet
at: www.2helpU.com.
7
Loading...