Black & Decker Dc1005 Instruction Manual
www.blackanddecker.eu
DC1005
1
2
7
3
6
5 4
2
(Original instructions)
ENGLISH
Intended use
Your BLACK+DECKER DC1005 Travel Kettle has been
designed for boiling water as described in this manual. Do
not use this appliance for any other purpose. This product is
intended for household and similar locations such as:
u
Staff kitchen areas in shops, ofces and other working
environments;
u
Farm houses;
u
By clients in hotels, motels and other residential type
environments;
u
Bed and breakfast type environments.
Thank you for choosing BLACK+DECKER. We hope that you
will enjoy using this product for many years. For indoor
domestic use only.
Safety instructions
)
Warning! When using mains-powered appliances, basic
safety precautions, including the following, should always be
followed to reduce the risk of fire, electric shock and personal
injury and material damage.
u Read all of this manual carefully before using the appli-
ance.
u The intended use is described in this manual. The use of
any accessory or attachment or the performance of any
operation with this appliance other than those recommended in this instruction manual may present a risk of
personal injury.
u Retain this manual for future reference.
Using your appliance
u Do not touch hot surfaces. Keep your hands away from
the spout.
u Always take care when using the appliance.
u Never pull the power supply cord to disconnect the plug
from the socket. Keep the power supply cord away from
heat, oil and sharp edges. Do not allow the power supply
cord to hang over the edge of your work top or table.
u Always place the appliance on a level surface with
adequate free space on all sides.
u Do not place the appliance below a socket outlet. Do not
place the appliance on a wet or slippery surface. Do not
place the appliance on or near heat sources or in a heated
oven.
u Do not use the appliance near flammable or explosive
materials.
u Do not use the appliance outdoors.
u Always protect the appliance from water or excessive
humidity.
u Do not place any utensils in the appliance.
u Do not move the appliance when in use.
u Operate the appliance only with dry hands.
u Do not use the appliance if you have bare feet.
u If the power supply cord is damaged during use, discon-
nect the appliance from the power supply immediately.
Do not touch the power supply cord before disconnecting
from the power supply.
u Disconnect the appliance from the power supply when not
in use, before fitting or removing parts and before cleaning.
u Allow the appliance to cool before cleaning.
Safety of others
u This appliance can be used by children aged from 8 years
and above if they have been given supervision or instruction concerning use of the appliance in a safe way and if
they understand the hazards involved.
u Cleaning and user maintenance shall not be made by
children unless they are older than 8 and supervised.
Keep the appliance and its cord out of reach of children
aged less than 8 years.
After use
u Switch off and remove the plug from the socket before
leaving the appliance unattended and before changing,
cleaning or inspecting any parts of the appliance.
u When not in use, the appliance should be stored in a dry
place. Children should not have access to stored appliances.
Inspection and repairs
u Before use, check the appliance for damaged or defective
parts. Check for breakage of parts, damage to switches
and any other conditions that may affect its operation.
u Do not use the appliance if any part is damaged or defec-
tive.
u Have any damaged or defective parts repaired or replaced
by an authorised repair agent.
u Before use, check the power supply cord for signs of dam-
age, ageing and wear.
u Do not use the appliance if the power supply cord or
mains plug is damaged or defective.
u If the power supply cord or mains plug is damaged or
defective it must be repaired by an authorised repair agent
in order to avoid a hazard. Do not cut the power supply
cord and do not attempt to repair it yourself.
u Never attempt to remove or replace any parts other than
those specified in this manual.
Additional safety instructions for Travel Kettles
Warning! Do not place near a hot Gas or electric oven.
3
3
ENGLISH
(Original instructions)
u Do not use this Kettle to boil acid and alkaline foodstuff, or
for other purposes.
u Do not Immerse kettle, base, cord or plug in any
liquid.
u The outer surface of this kettle may become hot during
use.
u Steam may escape from the spout.
u Allow the appliance to cool before re-filling.
u This product is not intended for regular use.
Electrical safety
Before use, check that the mains voltage corresponds to the
voltage on the rating plate.
This product must be earthed. Always
check that the mains voltage corresponds
!
u Appliance plugs must match the outlet. Never modify the
to the voltage on the rating plate
plug in any way.
u Do not use any adapter plugs with earthed (Class 1) appli-
ances. Unmodied plugs and matching outlets will reduce
the risk of electric shock.
u To avoid the risk of electric shock, do not immerse the
cord, plug or motor unit in water or other liquid.
Extension cables & class 1 product
u A 3 core cable must be used as your tool is earthed and of
class 1 construction.
u Up to 30m (100 ft) can be used without loss of power.
u If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Labels on Appliance
The following pictograms along with the date code are shown
on the tool:
Warning! Hot surface.
u Clean the appliance before rst use.
u Remove the lid (1) by turning it anti clockwise and lifting it
clear of the unit.
u Fill the kettle with cold water to the maximum fill mark. Do
not overfill as described below.
u Replace the lid (1) by aligning the open icon on the
lid (1) and pip on the kettle body then turn clockwise to
lock. The pip on the body and the close icon should be
aligned.
u Boil the water as described below.
u Discard the boiled water and repeat the procedure.
Use
Warning! Always place the appliance on a at, clean and non-
slip surface before operating it.
Warning! Always check the water level while using the appli-
ance. Never use the appliance without sufcient water.
Warning! The outer surfaces of the kettle may become hot
in use.
Warning! Do not remove the lid while the water is boiling.
Warning! Steam may escape from the spout.
Warning! Allow the Appliance to cool before re-lling
Boiling water
u Unplug the kettle and take it to a water outlet
u Remove the lid (1) as described above.
u Fill the kettle with cold water to the desired level. Do not
overll.
u To prevent dry boiling ll to at least 240ml (two cups)
u Do not ll the kettle beyond the maximum ll mark. If the
kettle is overlled, boiling water may be ejected from the
spout (6).
u Replace the lid (1) and ensure it is in the locked position
with the closed icon in line with the pip on the body.
u Insert the plug into a power socket. Press the on/off
switch (4). The on/off indicator light (5) will light.
u After a short period the water will begin to boil.
u The unit will continue to boil until turned off or the plug is
removed from the power socket. Do not open the lid (1)
when the water is boiling.
Features
1. Lid
2. Lid handle
3. Handle
4. On / Off switch
5. On / Off indicator light
6. Water level window
7. Spout
Before first use
u Remove all packaging from the appliance.
4
Approximate Boiling times
Approximately 6 minutes for 500mls (Maximum)
Pouring boiled water
u Make sure the unit is disconnected from the power socket.
u To avoid scalding, tilt the kettle slowly to pour the boiled
water.
Cleaning and maintenance
Warning! Before cleaning and maintenance, switch the appli-
ance off and remove the plug from the socket.
(Original instructions)
ENGLISH
Warning! Do not immerse the appliance or the cord set or the
plug in water or any other liquid.
u Wipe the exterior with a damp cloth.
u Do not use scouring pads.
u If necessary, use a mild detergent to remove spots. Do not
use any abrasive or solvent based cleaner.
Descaling the appliance
If the appliance is used in an area with hard water, it is
advised to descale the appliance from time to time
u Half ll the kettle with cold tap water.
u Add 30 ml of white vinegar.
u Boil the mixture and allow it to stand for 30 seconds.
u Repeat this procedure 2 or 3 times.
u Thoroughly rinse the kettle.
Mains plug replacement
If a new mains plug needs to be tted:
u Safely dispose of the old plug.
u Connect the brown lead to the live terminal of the new
plug.
u Connect the blue lead to the neutral terminal.
u If the product is class l (earthed), connect the green / yel-
low lead to the earth terminal.
Warning! If your product is class ll double insulated (only 2
wires in the cord set), no connection is to be made to the earth
terminal.
Follow the tting instructions supplied with good quality plugs.
Any replacement fuse must be of the same rating as the
original fuse supplied with the product.
BLACK+DECKER provides a facility for the collection and recycling of BLACK+DECKER products once they have reached
the end of their working life. To take advantage of this service
please return your product to any authorised repair agent who
will collect them on our behalf.
You can check the location of your nearest authorised repair
agent by contacting your local BLACK+DECKER office at the
address indicated in this manual. Alternatively, a list of authorised BLACK+DECKER repair agents and full details of our
after-sales service and contacts are available on the Internet
at: www.2helpU.com
Technical data
DC1005
Voltage
Capacity W 0.5
Power input
Weight (empty) kg 0.6
V
AC
W 1000
230
Protecting the environment
Separate collection. This product must not be
Z
disposed of with normal household waste.
Should you find one day that your BLACK+DECKER product
needs replacement, or if it is of no further use to you, do not
dispose of it with household waste. Make this product available for separate collection.
Separate collection of used products and packaging
z
allows materials to be recycled and used again.
Re-use of recycled materials helps prevent environmental pollution and reduces the demand for raw
materials.
Local regulations may provide for separate collection of electrical products from the household, at municipal waste sites or
by the retailer when you purchase a new product.
5
Loading...