Black & Decker CV6B Instruction Manual

SERVICE INFORMATION

All Black & Decker Service Centers are staffed with trained personnel to provide
customers with efficient and reliable power tool service. Whether you need technical
advice, repair, or genuine factory replacement parts, contact the Black & Decker
location nearest you. To find your local service location, refer to the yellow page
directory under "Tools—Electric" or call: 1-800-544-6986 or visit
www.blackanddecker.com.

FULL TWO-YEAR HOME USE WARRANTY

Black & Decker (U.S.) Inc. warrants this product for two years against any defects in
material or workmanship. The defective product will be replaced or repaired at no
charge in either of two ways.

The first, which will result in exchanges only, is to return the product to the retailer
from whom it was purchased (provided that the store is a participating retailer).
Returns should be made within the time period of the retailer’s policy for exchanges
(usually 30 to 90 days after the sale). Proof of purchase may be required. Please check
with the retailer for their specific return policy regarding returns that are beyond the
time set for exchanges.

The second option is to take or send the product (prepaid) to a Black & Decker owned
or authorized Service Center for repair or replacement at our option. Proof of purchase
may be required. Black & Decker owned and authorized Service Centers are listed
under "Tools-Electric" in the yellow pages of the phone directory and on our website
www.blackanddecker.com.

This warranty does not apply to accessories. This warranty gives you specific legal
rights and you may have other rights which vary from state to state or province to
province. Should you have any questions, contact the manager of your nearest Black &
Decker Service Center. This product is not intended for commercial use.

FREE WARNING LABEL REPLACEMENT:

If your warning labels become illegible or are
missing, call
1-800-544-6986 for a free replacement.

Imported by
Black & Decker (U.S.) Inc.,
701 E. Joppa Rd.
Towson, MD 21286 U.S.A. RD022708

OPERATING INSTRUCTIONS

To Use

• Connect converter's power cord to 120 volt AC outlet.

• Plug the 12 volt DC-powered device into the converter’s socket and operate normally.

To Disconnect

• Remove 12 volt DC plug from converter.

• Disconnect converter's power cord from 120 volt AC outlet.

• Allow converter to cool for at least 30 minutes before storing.

CARE AND MAINTENANCE

• Do not immerse converter in water.

• Wipe outside surface of the converter with a damp cloth. The use of any other
material may cause permanent damage and will void the warranty.

ACCESSORIES

Recommended accessories for use with your tool are available from your local dealer
or authorized service center. If you need assistance regarding accessories, please call:
1-800-544-6986.

WARNING:

The use of any accessory not recommended for use with this tool

could be hazardous.

TROUBLESHOOTING

Problem Explanation/Possible Solution

No output from converter • 12 volt DC plug not making good connection in socket

– rotate plug in socket.

• Dirty contacts in 12 volt DC socket – with power
disconnected, clean socket and reinsert plug.

AC power is not available Check AC outlet by plugging in another appliance. If

outlet has no power, check fuses, circuit breakers and
wall switches to restore power.

Fuse is blown (open) Return unit to manufacturer for repair. There are no

user servicable parts in this converter.

TRAVEL MATE

™

AC/DC CONVERTER

INSTRUCTION MANUAL

Thank you for choosing Black & Decker!

Go to www

.BlackandDecker.com/NewOwner

to register your new product

Catalog Number CV6B

BEFORE RETURNING THIS PRODUCT

FOR ANY REASON PLEASE CALL

1-800-544-6986

BEFORE YOU CALL, HAVE THE CATALOG No, AND DATE CODE

AVAILABLE. IN MOST CASES, A BLACK & DECKER

REPRESENTATIVE CAN RESOLVE THE PROBLEM OVER THE

PHONE. IF YOU HAVE A SUGGESTION OR COMMENT, GIVE

US A CALL. YOUR FEEDBACK IS VITAL TO BLACK & DECKER.

SAVE THIS MANUAL FOR FUTURE REFERENCE.

Cat. #CV6B Form #90534328
February 2008 Copyright © 2008 Black & Decker Printed in China

CV6B ManualEN 022708.qxp 2/27/2008 5:01 PM Page 1

See ‘Tools-Electric’

– Yellow Pages –

for Service & Sales

WARNING: This product or its power cord contains lead, a chemical known to the State
of California to cause cancer and birth defect or other reproductive harm. Wash hands
after handling.

WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK:

• NEVER immerse the unit in water or any other liquid, or use when wet.

• Do not insert foreign objects into the DC outlet.

WARNING: TO REDUCE THE RISK OF FIRE:

• Do not operate near flammable materials, fumes or gases.

• DO NOT expose to extreme heat or flames.

CAUTION: TO REDUCE THE RISK OF INJURY OR PROPERTY DAMAGE:

• Remove appliance plug from outlet before working on the appliance.

• ALWAYS turn the converter OFF by disconnecting it from the AC outlet when not in use.

• Do not open the converter — there are no user-serviceable parts inside.

• Do not use this converter with medical devices. It is not tested for medical
applications.

• Only use to operate 12 volt DC devices that are equipped with a power cord rated at a
minimum of #18 AWG copper.

• Make sure the12 volt DC appliance plug is wired correctly. The 12 volt DC socket is
wired so the center conductor is positive (+) and the shell conductor is negative (–).

• Keep away from children. This is not a toy!

• Install and operate unit only as described in this Instruction Manual.

• Do not use this converter on a watercraft. It is not qualified for marine applications.

• Check unit periodically for wear and tear. Take to a qualified technician for
replacement of worn or defective parts immediately.

• Read And Understand This Instruction Manual Before Using This Unit.

SAVE THESE INSTRUCTIONS

WARNING: TO REDUCE THE RISK OF INJURY OR PROPERY DAMAGE:

Follow these instructions and those published by the manufacturer of any equipment
you intend to use with this unit. Review cautionary markings on these products.

INTRODUCTION

Thank you for purchasing the

Black & Decker®Traevl MateTMAC/DC Converter.

It is
useful for a wide variety of applications including: Operating and charging cell phones
and automotive accessories requiring less than 6 amps of 12 volt DC current. This
includes 12 volt DC operated thermoelectric cooler/warmers, spotlights to 70 watt bulb
rating, portable air ionizers, and charging jumpstarters.

• PROPER COOLING is essential when operating the converter. Do not place the unit

near a heat vent or in direct sunlight. Do not block ventilation slots.

• GROUND FAULT CIRCUIT INTERRUPTER (GFCI) protection should be provided on

the circuits or outlets to be used. Receptacles are available having built-in GFCI
protection and may be used for this measure of safety.

• USE OF ACCESSORIES AND ATTACHMENTS. The use of any accessory or
attachment not recommended for use with this appliance could be hazardous. Note:
Refer to the “Accessories” section of this manual for further details.

• CHECK DAMAGED PARTS. Before further use of the appliance, a guard or other part
that is damaged should be carefully checked to determine that it will operate properly
and perform its intended function. Check for alignment of moving parts, binding of
moving parts, breakage of parts, mounting, and any other conditions that may affect
its operation. A guard or other part that is damaged should be properly repaired or
replaced by an authorized service center unless otherwise indicated elsewhere in this
instruction manual. Have defective switches replaced by authorized service center. Do
not use tool if switch does not turn it ON and OFF.

• OUTDOOR USE EXTENSION CORDS. When tool is used outdoors, use only extension
cords intended for use outdoors and so marked.

• EXTENSION CORDS. Make sure your extension cord is in good condition. When
using an extension cord, be sure to use one heavy enough to carry the current your
product will draw. An undersized cord will cause a drop in line voltage resulting in
loss of power and overheating. The following table shows the correct size to use
depending on cord length and nameplate ampere rating. If in doubt, use the next
heavier gage. The smaller the gage number, the heavier the cord.

Minimum Gage for Cord Sets

Vol ts Total Length of Cord in Feet

120V 0-25 26-50 51-100 101-150

(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)

240V 0-50 51-100 101-200 201-300

(0-15,2m) (15,2-30,4m) (30,4-60,9m) (60,9-91,4m)

Ampere Rating

More Not more American Wire Gage
Than Than
0 - 6 18 16 16 14
6 - 10 18 16 14 12

10 - 12 16 16 14 12
12 - 16 14 12 Not Recommended

SAFETY GUIDELINES / DEFINITIONS

DANGER: Indicates an imminently hazardous situation which, if not avoided, will

result in death or serious injury.

WARNING: Indicates a potentially hazardous situation which, if not avoided, could

result in death or serious injury.

CAUTION: Indicates a potentially hazardous situation which, if not avoided, may

result in minor or moderate injury.
CAUTION: Used without the safety alert symbol indicates potentially hazardous

situation which, if not avoided, may result in property damage.
RISK OF UNSAFE OPERATION. When using tools or equipment, basic safety

precautions should always be followed to reduce the risk of personal injury. Improper
operation, maintenance or modification of tools or equipment could result in serious
injury and property damage. There are certain applications for which tools and
equipment are designed. Black & Decker strongly recommends that this product NOT
be modified and/or used for any application other than for which it was designed. Read
and understand all warnings and operating instructions before using any tool or
equipment.

IMPORTANT SAFETY INSTRUCTIONS

GENERAL SAFETY WARNINGS AND INSTRUCTIONS FOR ALL APPLIANCES

READ ALL INSTRUCTIONS

WARNING: Read all instructions before operating product. Failure to follow all

instructions listed below may result in electric shock, fire and/or serious injury.

• AVOID DANGEROUS ENVIRONMENTS. Don’t use appliances in damp or wet

locations. USE THE UNIT INDOORS ONLY.

• STORE IDLE APPLIANCES INDOORS. When not in use, appliances should be stored

indoors in dry, and high or locked-up place – out of reach of children.

• DON’T FORCE APPLIANCE. It will do the job better and with less likelihood of a risk

of injury at the rate for which it was designed.

• USE RIGHT APPLIANCE. Do not use the appliance for any job except that for which it

is intended.

• DON’T ABUSE CORD. Never carry appliance by cord or yank it to disconnect from

receptacle. Keep cord from heat, oil, and sharp edges.

• DISCONNECT APPLIANCES. Disconnect the appliance from the power supply when

not in use, before servicing, and when changing accessories such as blades and the
like.

CV6B ManualEN 022708.qxp 2/27/2008 5:01 PM Page 4