INSTALLATION INSTRUCTIONS (FIG. B)
Fix the charging base within reach of an electrical outlet, using the screws supplied. Plug in
and place the product in position. Always mount in an upright (handle up) position.
NOTE: Avoid damaging the cord while fixing the base to the wall or when removing or
replacing the product from the base.
RECHARGING (FIG. C)
From new, the rechargeable cells of the product need a minimum charge time of 16 hours to
ensure full power. While charging the charge indicator light will be illuminated. The switch
must be in the off (“O”) position. The product will not charge if it is in any other position. While
charging, the product may get warm, this is perfectly normal and safe. It can remain on
charge indefinitely without damage or danger. It is not possible to “overcharge” the battery
cells with the charger provided.
THIS PRODUCT IS FOR DRY PICK-UP ONLY.
OPERATION (FIG. D)
To start, slide the On/Off switch forward (i.e. “O”= Off, “I” = On). To stop, slide the switch
back.
Always return the product to the charging base immediately after use so that it will be
ready and fully charged for the next use. Ensure that the product is fully engaged on the
charging base.
CLEANING THE PRODUCT (FIGS . E-I)
WARNING: Never use the Dustbuster without its filters.
NOTE: The filters are re-usable, do not confuse them with disposable dust bags, and do not
throw them away when the product is emptied. We recommend that you replace the filters
every 6-9 months depending on frequency of use. (Use Cat. No. VF100H filters)
FIG. E • Remove the dust bowl by pressing the dust bowl release button and pulling the
bowl down and out. To replace the bowl, place it back onto the handle and click
firmly into position.
Important: For best vacuum results, empty bowl after every use.
FIG. F • Empty the debris from the bowl and wash if necessary (see Fig. H).
FIG. G • To remove the filters twist the outer (plastic) filter in a clockwise direction. Shake or
lightly brush any loose dust off the outer filter. Remove the inner filter and shake,
tap or lightly brush outside surface to remove loose dust. Both filters can be rinsed
as shown in fig. (H).
WARNING: Filter must be dry before re-assembling.
Ensure both filters are in place before operating.
FIG. G1• If your unit is equipped with a filter cleaning wheel as shown in Fig. G1 you can
achieve more use between filter cleanings by first switching off the vac, and then
rotating the cleaning wheel up or down as shown. Make two full rotations of wheel
for best results.
FIG. H • Wash the filters using warm, soapy water and ensure that they are completely dry
before using it again. The cleaner the filters are, the better the product will perform.
It is very important that the filter is correctly in position before use. The dust bowl
can also be washed in warm soapy water. Ensure that it is dry before re-attaching.
WARNING: Filters must be dry before re-assembling.
IMPORTANT: Maximum dust collection will only be obtained with clean filters and an empty
dust bowl. If dust begins to fall back out of the product after it is switched off, this indicates
that the bowl is full and requires emptying.
FIG. I • The exhaust filter is removed by opening cover and pulling out filter as shown. For
best results wash filter regularly with soap and water.
FIG. J • Never immerse the product in water. A damp cloth and soapy water should be used
to clean the exterior of the motor section. Always ensure the product is completely
dry before re-use or storing.
ECONOMIC USAGE
• Your product is very economical to charge. While it is charging it uses less electricity than a
typical night light bulb.
• When fully charged and with a clean filter, the average effective usage times vary by
voltage.
15.6 volts and higher: 12 - 15 minutes
TROUBLE SHOOTING
If the product does not work, check the following:
• That the charge indicator light is on when unit is in base.
• The charger was correctly plugged in for recharge. ( It feels slightly warm to the touch.)
• The charger cord is not damaged and is correctly attached to the base.
• The charger is plugged into a working electrical outlet.
• That the switch is in the “OFF” position when charging.
ACCESSORIES
Accessories are stored on the product (FIG. K) and are fitted into the nose of the product for
use. Accessory use is shown in FIG. L.
Note: Replacement filters can be purchased from most local/national retailers that
sell vacuums. Look for VF100H filters.
BATTERY REMOVAL AND DISPOSAL
This product uses nickel-cadmium (Ni-Cd) rechargeable and recyclable batteries. When the
batteries no longer hold a charge, they should be removed from the Vac and recycled. They
must not be incinerated or composted.
The batteries can be taken for disposal to a Black & Decker, Company-Owned or Authorized
Service Center. Some local retailers are also participating in a national recycling program
(see “RBRCTMSeal”). Call your local retailer for details. If you bring the batteries to a Black
& Decker Company-Owned or Authorized Service Center, the Center will arrange to recycle
old batteries. Or, contact your local municipality for proper disposal instructions in your
city/town.
To remove the battery pack for disposal:
1. Remove accessories from the bottom of the unit.
2. Using a Phillips screwdriver remove the screws as shown in Fig "M". Then use the
screwdriver to push the lock tabs in the direction shown.
3. Pull the battery cover off as shown in Fig. N.
4. Remove the battery pack (Fig. O) and dispose as stated above.
To replace or obtain a new battery pack, contact your local Black & Decker, CompanyOwned or Authorized Service Center, or call 1-800-544-6986. Be prepared to provide the
Catalog No. of your DustBuster, found on the bottom housing under the crevice tool.
MAINTENANCE
Use only mild soap and damp cloth to clean the vac. Never let any liquid get inside the vac;
never immerse any part of the vac into a liquid.
NOTE: Make sure the vacuum is completely dry before using it.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this manual) should be performed by authorized
service centers or other qualified service organizations, always using identical replacement
parts.
THE RBRC
™ SEAL
The RBRC™ (Rechargeable Battery Recycling Corporation) Seal on the nickelcadmium battery (or battery pack) indicates that the costs to recycle the battery
(or battery pack) at the end of its useful life have already been paid by Black & Decker. In
some areas, it is illegal to place spent nickel-cadmium batteries in the trash or municipal
solid waste stream and the RBRC program provides an environmentally conscious
alternative.
RBRC in cooperation with Black & Decker and other battery users, has established
programs in the United States and Canada to facilitate the collection of spent nickelcadmium batteries. Help protect our environment and conserve natural resources by
returning the spent nickel-cadmium battery to an authorized Black & Decker service center
or to your local retailer for recycling. You may also contact your local recycling center for
information on where to drop off the spent battery, or call
1-800-8-BATTERY.
SERVICE INFORMATION
Black & Decker offers a full network of company-owned and authorized service locations
throughout North America. All Black & Decker Service Centers are staffed with trained
personnel to provide customers with efficient and reliable power tool service.
Whether you need technical advice, repair, or genuine factory replacement parts, contact
the Black & Decker location nearest you. To find your local service location, refer to the
yellow page directory under “Tools—Electric” or call: 1-800-54-HOW TO (544-6986).
FULL TWO-YEAR HOME USE WARRANTY
Black & Decker (U.S.) Inc. warrants this product for two years against any defects in
material or workmanship. The defective product will be replaced or repaired at no charge in
either of two ways.
The first, which will result in exchanges only, is to return the product to the retailer from
whom it was purchased (provided that the store is a participating retailer). Returns should be
made within the time period of the retailer’s policy for exchanges (usually 30 to 90 days after
the sale). Proof of purchase may be required. Please check with the retailer for their specific
return policy regarding returns that are beyond the time set for exchanges.
The second option is to take or send the product (prepaid) to a Black & Decker owned or
authorized Service Center for repair or replacement at our option. Proof of purchase may
be required. Black & Decker owned and authorized Service Centers are listed under
“Tools-Electric” in the yellow pages of the phone directory.
This warranty does not apply to accessories. This warranty gives you specific legal rights
and you may have other rights which vary from state to state. Should you have any
questions, contact the manager of your nearest Black & Decker Service Center.
This product is not intended for commercial use.
Lorsqu’on utilise un appareil électrique, il faut toujours respecter certaines règles de sécurité
fondamentales, notamment les suivantes.
LIRE ET COMPRENDRE TOUTES LES DIRECTIVES AVANT D’UTILISER L’APPAREIL.
LIGNES DIRECTRICES EN MATIÈRE DE SÉCURITÉ - DÉFINITIONS
Il est important que vous lisiez et compreniez ce mode d’emploi. Les informations qu’il
contient concernent VOTRE SÉCURITÉ et visent à ÉVITER TOUT PROBLÈME. Les
symboles ci-dessous servent à vous aider à reconnaître cette information.
DANGER : Indique une situation dangereuse imminente qui, si elle n’est
pas évitée, causera la mort ou des graves blessures.
AVERTISSEMENT : Indique une situation potentiellement
dangereuse qui, si elle n’est pas évitée, pourrait causer la mort ou de graves blessures.
MISE EN GARDE : Indique une situation potentiellement dangereuse
qui, si elle n’est pas évitée, pourrait causer des blessures mineures ou modérées.
MISE EN GARDE : Utilisé sans le symbole d’alerte à la sécurité,
indique une situation potentiellement dangereuse qui, si elle n’est pas évitée, peut résulter en
des dommages à la propriété.
AVERTISSEMENT : Certaines poussières domestiques
contiennent des produits chimiques reconnus par l’État de la Californie comme étant
cancérogènes et pouvant entraîner des anomalies congénitales et d’autres risques pour la
reproduction tels que l’amiante et le plomb contenu dans les peintures au plomb.
AVERTISSEMENT : Afin de minimiser les risques
d’incendie, de secousses électriques ou de blessures.
• Exercer une étroite surveillance lorsqu’on utilise l’appareil près d’un enfant ou que
l’appareil est utilisé par ce dernier. Il ne s’agit pas d’un jouet.
• Afin d’éviter les risques de secousses électriques, ne pas immerger l’appareil ni son
chargeur.
• Ne pas se servir d’un aspirateur portatif Dustbustermdpour déchets secs afin d’aspirer
des liquides, des substances toxiques, des liquides inflammables ou combustibles (de
l’essence, par exemple), ni s’en servir dans un endroit renfermant de tels produits.
• Ne pas se servir de l’appareil en présence de vapeurs explosives ou inflammables.
• Ne pas utiliser un appareil dont le cordon ou le chargeur est endommagé, ni un appareil
qui ne fonctionne pas bien, qui est tombé, endommagé, resté à l’extérieur ou a été
immergé. Le confier à un centre de service autorisé.
• Ne pas utiliser un aspirateur portatif Dustbustermdpour déchets secs à l’extérieur ni sur
des surfaces mouillées.
• Manipuler le cordon avec soin. Ne jamais transporter le chargeur ni le socle par le cordon
ni tirer sur le cordon pour le débrancher. Saisir plutôt la fiche et tirer dessus. Éloigner le
cordon des surfaces chaudes. Ne pas tirer sur le cordon lorsqu’il est autour d’un coin ou
d’un rebord tranchant.
• Ne pas laisser pendre le cordon d’une table ou d’un comptoir, ni le laisser entrer en contact
avec une surface chaude. Placer ou installer l’appareil loin des éviers ou des surfaces
chaudes.
• Ne pas utiliser de cordon de rallonge. Brancher le chargeur directement dans une prise.
How To Use
Product Features (Fig. A)
1. On/Off slide switch 4. Wall mountable charging base 7. Filter cleaning wheel
2. Bowl release button 5. Charger
3. Dust bowl 6. Charge indicator light
ASSEMBLY
FITTING THE TUBES AND THE FLOOR HEAD (FIG. K1) (ONLY CHV1600)
• Fit the bowl connector on to the nose of the DustBuster.
• Fit the upper and lower tubes together and attach the floor head to one end of the tube.
• Attach the other end of the tube to the connector on the nose of the floor extension.
• Alternatively, to use as a hand-held cleaner with brush on stairs and furniture, attach the
floor head directly on to the connector.
ACTIVATING THE BRUSH
Use the switches on the floor head to lower or raise the bristles on the brush.
• Lower the bristles for cleaning carpets or rugs.
• Raise the bristles for cleaning hard floors, such as wood, tile or marble.
IMPORTANTES MISES EN GARDE
CONSERVER CE MODE D’EMPLOI POUR UN USAGE ULTÉRIEUR.
POUR UN USAGE DOMESTIQUE UNIQUEMENT.
Pour l´achat d´un filtre de rechange
composer le 1-888-678-7278.
MODE D’EMPLOI
AVANT DE RETOURNER CE PRODUIT POUR QUELQUE
RAISON QUE CE SOIT, COMPOSER LE
1-800-544-6986
AVANT D’APPELER, AYEZ EN MAIN LE N° DE CATALOGUE ET LE CODE DE DATE. DANS LA PLUPART DES
CAS, UN REPRÉSENTANT DE BLACK & DECKER PEUT RÉSOUDRE LE PROBLÈME PAR
TÉLÉPHONE. SI VOUS AVEZ UNE SUGGESTION OU UN COMMENTAIRE, APPELEZ-NOUS. VOS
IMPRESSIONS SONT CRUCIALES POUR BLACK & DECKER.
M
M
ERCI
ERCIDD
’
’
AAVOIR
VOIR
CHOISI
CHOISI
B
B
LACK
LACK
& D
& D
ECKER
ECKER
!
!
V
V
ISITEZ
ISITEZ
WWW
WWW
.B
.B
LACKAND
LACKAND
D
D
ECKER
ECKER
.
.
COM
COM
/N
/N
EW
EW
O
O
WNER
WNER
POUR
POUR
ENREGISTRER
ENREGISTRER
VOTRE
VOTRE
NOUVEAU
NOUVEAU
PRODUIT
PRODUIT
.
.
See ‘Tools-Electric’
– Yellow Pages –
for Service & Sales
Imported by
Black & Decker (U.S.) Inc.,
701 E. Joppa Rd.
Towson, MD 21286 U.S.A.