Black & Decker 80-340 User Manual
BIACKSlDEGKER
Instructions
No. 80-340 Grass Catcher
For 18" Single Blade Lawn Mowers
SLEEVE
LOOPS
TM
THIRD LOOP
FLATTENED
ENDS OF
RODS
1
Unzip back pane! of bag. Slide rod "A” (the
one with the sleeve on the end) around
through the two bag loops as shown. Note
that bend in flattened end of rod should
point downward.
FLATTENED ENDS OF RODS
FLATTENED
TUBE
END
Slide flattened end of handle tube through
hole in bag as shown. Insert flattened ends
of rods INTO the flattened end of the
handle tube. Line up the holes and attach
the tube and rod ends with screw and nut
shown.
Slide rod "B” (witfiout sleeve on end)
around through third loop as shown. Push
round end of rod "B" into sleeve on end of
rod "A”.
STEP A -Stand bag on zip
pered end.
STEP B -
Pull garter over tube
side of chute.
STEP C Exert slight down
ward pressure on
the frame while pull
ing garter into chan
nel at bottom of
chute.
STEP D -
Position garter at
top and sides of the
chute, placing 4 gar
ter holes over 4
tangs on the chute.
Push gathered ma
terial and garter un
der each hook.
TANGS
Pull zippered end of bag up and over
support rods. Push bent, flattened ends of
rods through hole in top of bag.
BE SURE BAG
GARTER FITS
INTO CHANNEL
HERE.
Mount the grass bag assembly on the
mower by placing the holes in the chute
over posts.
WARNING: Fabric is subject to wear and deterioration under normal usage. Check bag frequently for wear.
Replace when worn with Replacement Bag No. 80-110 available from your dealer or B&D Service Center.
Form No. 688153-01
BLACK & DECKER (U.S.) INC.
10 North Park Drive, P.O. 798, Hunt Valley. MD 21030-0798
Printed in U.S.A.
Loading...