Black & Decker 36070 User Manual

Cat. No. 36070

Sanding Frame

For the 4023 & 4024

WOODWORKING TOOLS BY

BUlCKaDECKER

ELU Belt Sanders
Instructions

1. Turn Off And Unplug Sander.

2. Remove the front pivot bar from the sanding frame and
remove the hex nut, flat washer, pivot crank and spring,
(see Figure 1)

3. Insert the pivot bar through the sender FROM THE

RIGHT SIDE as shown in Figure 2. Examine the figure

closely to determine the position of the spring and flat
washer.

4. With the threaded end of the pivot bar extending from the
left side of the sander, re-install the spring, flat washer,
pivot crank and hex nut.
pivot cranks are positioned the same way. Tighten the nut
securely and make sure the pivot bar is free to rotate.

NOTE: The pivot bar is designed to rotate 90 degrees

from straight down to straight back.

5. With the pivot cranks straight down, insert them into the
frame in the pockets where they were before step 2
above. Be sure they snap below the balls in the pockets.

6. Rotate the back end of the sander down so that the
bracket on the sander fits over the rear pivot bar (make
sure it snaps firmly) NOTE: It may be necessary to move
the rear pivot bar into alignment with the bracket on the
sander. Move the bar by rotating the adjustment knob on
the rear of the frame, as shown in Figure 3.

7. The sanding frame is now properly installed. Adjust by
rotating the adjustment knob.

NOTE: Make sure that both

Elil

WOODWORKING TOOLS BY

BIACK&DECKER

Black & Decker (U.S.) Inc., U.S. Power Tools Group, 10 North Park Drive, P.O. Box 798, Hunt Valley, MD 21030-0798 U.S.A.

157 04 00 05