Black Box LMC5111C-R3, LMC5027C-R3, LMC5114C-R3, LMC5110C-R3, LMC5116C-R3 User Manual
...
LMC5022C-R3 LMC5110C-R3 LMC5116C-R3 LMC5182C-R3
LMC5023C-R3 LMC5111C-R3 LMC5117C-R3
LMC5026C-R3 LMC5113C-R3 LMC5180C-R3
LMC5027C-R3 LMC5114C-R3 LMC5181C-R3
High-Density Media Converter System II Layer 2 Modules
True Layer 2 conversion enables
you to extend your network
up to 40 kilometers over duplex fiber.
FCC and IC RFI Statements
FCC and Industry Canada RF Interference Statements
Class B Digital Device. This equipment has been tested and found to comply with
the limits for a Class B computing device pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. However, there is no guarantee that
interference will not occur in a particular installation. This equipment generates,
uses, and can radiate radio frequency energy, and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. If this equipment does cause harmful interference to radio or
telephone reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult an experienced radio/TV technician for help.
CAUTION
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
To meet FCC requirements, shielded cables and power cords are required to
connect this device to a personal computer or other Class B certified device.
This digital apparatus does not exceed the Class B limits for radio noise
emission from digital apparatus set out in the Radio Interference Regulation of
Industry Canada.
Page 2 724-746-5500 | blackbox.com LMC5022C-R3
Certifications
Certifications
Class 1 Laser product, Luokan 1 Laserlaite,
Laser Klasse 1, Appareil A’Laser de Classe
European Directive 2002/96/EC (WEEE) requires that any equipment that
bears this symbol on product or packaging must not be disposed of with
unsorted municipal waste. This symbol indicates that the equipment should be
disposed of separately from regular household waste. It is the consumer’s
responsibility to dispose of this and all equipment so marked through
designated collection facilities appointed by government or local authorities.
Following these steps through proper disposal and recycling will help prevent
potential negative consequences to the environment and human health. For
more detailed information about proper disposal, please contact local
authorities, waste disposal services, or the point of purchase for this equipment.
LMC5022C-R3 724-746-5500 | blackbox.com Page 3
Table of Contents
Table of Contents
Part Numbers ..................................................................................................5
1. Specifications............................................................................................6
2. Overview: About the High-Density Media Converter System II Layer 2
Modules........................................................................................................... 7
3. Configuration............................................................................................. 8
4. Install the High-Density Media Converter System II Layer 2 Modules.....9
4.1 Managed Modules .................................................................................... 9
4.1.1 Configuration Control and SNMP Management.................................9
4.2 Unmanaged Modules..............................................................................10
4.3 FX LinkLoss, TX LinkLoss, Link Fault Pass-Through, Far End Fault and
FiberAlert....................................................................................................... 11
4.3.1 Link Integrity.....................................................................................11
4.3.2 FX LinkLoss (FXLL).......................................................................... 12
4.3.3 TX LinkLoss (TXLL).......................................................................... 12
4.3.4 Link Fault Pass-Through (LFPT)......................................................12
4.3.5 FiberAlert and Far End Fault............................................................ 13
4.4 Auto Negotiation on High-Density Media Converter System II Layer 2
Modules......................................................................................................... 15
4.5 AutoCross Feature for Twisted Pair Connection ....................................15
5. Operation................................................................................................16
5.1 LED Operation........................................................................................16
6. Troubleshooting......................................................................................17
7. Contacting Black Box..............................................................................18
8. Fiber Optic Cleaning Guidelines............................................................. 19
Electrostatic Discharge Precautions.............................................................. 19
Page 4 724-746-5500 | blackbox.com LMC5022C-R3
Part Numbers
Part Number Description
LMC5022C-R3 TX/FX-MM1300-ST
LMC5023C-R3 TX/FX-MM1300-SC
LMC5026C-R3 TX/FX-SM1310/PLUS-ST
LMC5027C-R3 TX/FX-SM1310/PLUS-SC
LMC5110C-R3 TX/FX-SM1310/LONG-SC
LMC5111C-R3 TX/FX-SM1310/LONG-ST
LMC5113C-R3 TX/SSFX-SM1310-SC (1310xmt/1550rcv)
LMC5114C-R3 TX/SSFX-SM1550-SC (1550xmt/1310rcv)
LMC5116C-R3 TX/SSFX-SM1310/PLUS-SC (1310xmt/1550rcv)
LMC5117C-R3 TX/SSFX-SM1550/PLUS-SC (1550xmt/1310rcv)
LMC5180C-R3 TX/FX-SM1550/LONG-SC
LMC5181C-R3 TX/FX-MM850-SC
LMC5182C-R3 TX/FX-MM850-ST
Part Numbers
LMC5022C-R3 724-746-5500 | blackbox.com Page 5
Chapter 1: Specifications
1. Specifications
DC Input L2 w/LFPT: 0.80 Amp @ 5V
Operating Temperature: +32° F to +122° F (0° C to +50° C)
Storage Temperature: 0° F to +122° F (-20° C to +70° C)
Humidity: 5 - 95% (non-condensing)
Fiber Optic Specifications For fiber optic specifications, please visit:
http://www.blackbox.com
Page 6 724-746-5500 | blackbox.com LMC5022C-R3
Loading...