1000 Park Drive • Lawrence, PA 15055-1018 • 724-746-5500 • Fax 724-746-0746
© Copyright 2004. Black Box Corporation. All rights reserved.
OCTOBER 2004
KV404A
KV405A
KV406A
ServSwitch Micro
with Audio
CUSTOMER SUPPORT INFORMATION
Order toll-free in the U.S.: Call 877-877-BBOX (outside U.S. call 724-746-5500)
FREE technical support 24 hours a day, 7 days a week: Call 724-746-5500 or fax 724-746-0746
Mailing address: Black Box Corporation, 1000 Park Drive, Lawrence, PA 15055-1018
Web site: www.blackbox.com • E-mail: info@blackbox.com
1
FCC AND IC RFI STATEMENTS
FEDERAL COMMUNICATIONS COMMISSION
AND
INDUSTRY CANADA
RADIO FREQUENCY INTERFERENCE STATEMENTS
This equipment generates, uses, and can radiate radiofrequency energy, and if not installed and used properly, that
is, in strict accordance with the manufacturer’s instructions,
may cause interference to radio communication. It has been
tested and found to comply with the limits for a Class A
computing device in accordance with the specifications in
Subpart B of Part 15 of FCC rules, which are designed to
provide reasonable protection against such interference when
the equipment is operated in a commercial environment.
Operation of this equipment in a residential area is likely to
cause interference, in which case the user at his own expense
will be required to take whatever measures may be necessary
to correct the interference.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment.
2
SERVSWITCH MICRO WITH AUDIO
This digital apparatus does not exceed the Class A limits for radio
noise emission from digital apparatus set out in the Radio Interference
Regulation of Industry Canada.
Le présent appareil numérique n’émet pas de bruits radioélectriques
dépassant les limites applicables aux appareils numériques de classe
A prescrites dans le Règlement sur le brouillage radioélectrique publié
par Industrie Canada.
TRADEMARKS USED IN THIS MANUAL
ServSwitch is a trademark of Black Box
Corporation.
PS/2 is a registered trademark of
International Business Machines
Corporation.
Linux is a registered trademark of Linus
Torvalds.
Windows and Windows NT are either
registered trademarks or trademarks of
Microsoft Corporation in the United States
and/or other countries.
Any other trademarks mentioned in this manual
are acknowledged to be the property of the
trademark owners.
3
CONTENTS
Contents
Chapter Page
1. Specifications . . . . . . . . . . . . . . . . . . . 4
2. Overview . . . . . . . . . . . . . . . . . . . . . . . 7
3. Installation . . . . . . . . . . . . . . . . . . . . . 8
4. Operation . . . . . . . . . . . . . . . . . . . . . 11
4.1 LED Indicators . . . . . . . . . . . . . 11
4.2 Hotkey Commands . . . . . . . . . . 11
5. Troubleshooting. . . . . . . . . . . . . . . . 13
4
SERVSWITCH MICRO WITH AUDIO
1. Specifications
Video Resolution: 1920 x 1440 DDC,
DDC2, and DDC2B
Scan Interval: 3, 8, 15, and 30 seconds
Cable Length to Computer: 6 ft. (1.8 m)
Software Requirements: Windows
®
95/98/Me/XP, Windows 2000, Windows
NT
®
, or Linux
®
Connectors: User end: KV404A–KV406A:
(1) HD15 for connection to shared
monitor, (2) 6-pin mini-DIN for
connection to shared keyboard and
mouse, (1) 2.5-mm female stereo
audio connector;
5
CHAPTER 1: Specifications
Connectors (continued): Computer end:
KV404A: (2) HD15 and (4) 6-pin mini-
DIN for connection to two PS/2
®
monitors, keyboards, and mice,
(2) 2.5-mm male stereo audio
connectors;
KV405A: (2) HD15 for monitor port,
(2) USB Type A for keyboard and
mouse ports, (2) 2.5-mm male stereo
audio connectors;
KV406A: (2) HD15 for monitor port,
(1) USB Type A for keyboard and
mouse ports, (2) 6-pin mini-DIN for
keyboard and mouse ports,
(2) 2.5-mm male stereo audio
connectors
Indicators: (2) Yellow status LEDs
6
SERVSWITCH MICRO WITH AUDIO
Temperature Tolerance: 41 to 104°F
(5 to 40°C)
Relative Humidity: Up to 80%
Power: From the interface
Size: 1.9"H x 2.4"W x 0.8"D
(4.8 x 6.1 x 2 cm)
Weight: 0.6 lb. (0.3 kg)
7
CHAPTER 2: Overview
2. Overview
Use the ServSwitch™ Micro to access two
computers from a single shared monitor,
keyboard, and mouse. Two high-quality,
6-ft. (1.8-m) integral coaxial cables provide
the connections to the two computers.
Three models are available. They vary only
in the number and type of connectors. All
three models have audio connectors. See
the Connectors specification in Chapter 1.
All models are plug and play and can be
computer selected for easy setup and
installation. They also have two status LEDs
and advanced video enhancement
technology for crisp, clear VGA quality up
to 1920 x 1440. Computer switching is
flawless, and PC startup is trouble-free.
8
SERVSWITCH MICRO WITH AUDIO
3. Installation
Figure 3-1 shows a typical application.
Follow the instructions on the next two
pages to install the ServSwitch Micro.
Figure 3-1. The ServSwitch Micro’s cable connections.
ServSwitch Micro
with Audio
(KV404A)
(1) HD15,
(2) 6-pin mini-DIN,
and (1) 2.5-mm
stereo audio
connectors
PS/2
Mouse
Monitor
Keyboard Audio
6-ft. (1.8-m)
pigtail cable
(1) HD15,
(2) 6-pin mini-DIN,
and (1) 2.5-mm
stereo audio
connectors
(1) HD15,
(2) 6-pin mini-DIN,
and (1) 2.5-mm
stereo audio
connectors
PS/2
9
CHAPTER 3: Installation
1. Power off both computers.
2. Connect, in order, the mouse
connector, keyboard connector, and
monitor connector to one computer’s respective ports. Start by
attaching the 6-pin mini-DIN
connectors to the computer’s
keyboard and mouse ports. (The
mini-DIN connectors are colorcoded; mate the connectors with the
same color. The purple connector
attaches to the keyboard and the
green connector attaches to the
mouse.)
Next, attach the adjoining HD15
connector to the computer’s HD15
video port.
10
SERVSWITCH MICRO WITH AUDIO
Then, connect the 2.5-mm stereo
audio connector to the computer’s
audio port.
3. Repeat step 2, only this time connect
the ServSwitch Micro to the second
computer.
4. Connect your keyboard, mouse, and
VGA monitor to the two 6-pin miniDIN connectors and one HD15
connector on the ServSwitch Micro’s
user end. Then connect the 2.5-mm
stereo audio connector to the user
computer’s audio connector.
11
CHAPTER 4: Operation
4. Operation
4.1 LED Indicators
Two LEDs indicate the ServSwitch Micro’s
status. When the LED is lit, the computer
connected to the associated port is active.
In AutoScan mode, the keyboard’s Scroll
Lock should be flashing.
4.2 Hotkey Commands
The ServSwitch Micro selects computers
using hotkey commands. These are
summarized in Table 4-1.
12
SERVSWITCH MICRO WITH AUDIO
Table 4-1. Hotkey command summary.
Key Sequence Function
left left Selects computer 1
left left Selects computer 2
left left Initiates AutoScan
left left Aborts AutoScan
left left Toggles computer selection
left left Toggles AutoScan intervals. To
select the AutoScan interval,
press and release the Ctrl key
twice, then press the F3 key
repeatedly to toggle through the
settings: 3, 8, 15, or 30 seconds.
left left Resyncs the mouse
F12
CTRLCTRL
F3
CTRLCTRL
F2
CTRLCTRL
CTRLCTRL
F1
CTRLCTRL
2
CTRLCTRL
1
CTRLCTRL
13
CHAPTER 5: Troubleshooting
5. Troubleshooting
Table 5-1. Problems/Causes/Solutions.
Problem Cause Solution
The mouse does Improper 1. Unplug the
not work. initialization. mouse, then plug
it back into the
ServSwitch Micro.
2. Press the left
Ctrl key twice,
followed by the F12
key to resync the
mouse.
The ServSwitch The ServSwitch You can still use
keeps switching is in AutoScan the selected
between compu- mode. computer during
ters. The Scroll AutoScan mode.
Lock LED is To abort AutoScan
flashing. mode, press the
left Ctrl key twice.
14
SERVSWITCH MICRO WITH AUDIO
Table 5-1 (continued). Problems/Causes/Solutions.
Problem Cause Solution
Both LEDs are Both computers Turn on at least
off. are off. one computer.
There is a Make sure that
bad connection. both connections
are secure.
One LED is on At least one This is not a
while both computer has problem. You can
computers are off. keyboard power- still use the compu-
up ability. ter’s keyboard
power-up feature.
AutoScan mode One or both Power on both
does not work. computers is (are) computers.
powered off.
The AutoScan AutoScan resets Use a hotkey
interval has to a default of command (see
changed since its three seconds Table 4-1) to set
last use. when both the interval to
computers are 8, 15, or 30
powered off. seconds.
I need to connect The ServSwitch You need to
my serial mouse. does not support upgrade your
a serial mouse. computer and
purchase a PS/2
mouse.
Loading...