Black Box JPM624A, JPM648A User Manual
1000 Park Drive • Lawrence, PA 15055-1018 • 724-746-5500 • Fax 724-746-0746
© Copyright 2008. Black Box Corporation. All rights reserved.
Figure 3. Terminating the wire conductors.
NOTE: For best performance, keep the untwisted part of the wire less than 0.5 inches (1.3 cm)
long.
Using a punchdown tool, terminate each wire. Push the 110 punchdown tool to the edge
of the 110 connector to trim the conductors. See Figure 3.
4. Optional: Place the stuffer caps on the terminated 110 blocks for added strain relief.
5. Finally, connect the patch cord. Plug the patch cord into the patch panel, then connect it
to the network equipment.
Installation is complete.
TRADEMARKS USED IN THIS MANUAL
Black Box and the Double Diamond logo are registered trademarks of BB Technologies,
Inc.
UL is a registered trademark of Underwriters Laboratories, Inc.
All other trademarks mentioned in this manual are acknowledged to be the property of the
trademark owners.
CUSTOMER
SUPPORT
INFORMATION
Order toll-free in the U.S.: Call 877-877-BBOX (outside U.S. call 724-746-5500)
FREE technical support 24 hours a day, 7 days a week: Call 724-746-5500 or fax 724-746-0746
Mailing address: Black Box Corporation, 1000 Park Drive, Lawrence, PA 15055-1018
Web site: www.blackbox.com • E-mail: info@blackbox.com
NOVEMBER 2008
JPM624A
JPM648A
CAT6 Patch Panels
Loading...