Bitatek Glider Master, Glider Master Wwan User Manual
Bitatek Co. Ltd. has been acquired by iMotion Group in 2019.
Ownership of all pro ducts and trademarks of Bitatek Co.
Ltd. shall be assumed by iMotion Inc. and its subsidiaries unless
otherwise specified.
Glider Master
Please confirm if there is any item missing or broken in the package
when opening it.
Contact your supplier immediately if any.
Front View
Back View
1.
Logo and Indicator Area
2.
Android Function Key Area
(Back, Home, Menu key)
1.
Battery Pin
2.
SIM Card Slot
3.
Micro SD Card Slot
4.
Battery Cover lock Switch
5.
Hand Strap hook
6.
Speaker
7.
Flash LED
8.
Camera
1.
Ear Phone Connect
5.
Volume Down
2.
Power Button
6.
Scan Button
3.
Scan Button
7.
USB Connecter
4.
Volume Up
Top View
Bottom View
1. Scan Window
1. Cradle IO connect
1.
Enter
2.
Back Space
3.
→ Key
4.
↓ Key
5.
Scan Key
6.
↑ Key
7.
← Key
8.
Esc
9.
Tab
10.
Orange change
11.
Blue change
12.
＊ Key
13.
＃ Key
Alphanumeric Key
1. Battery Cover
2. Battery pack
3. Battery Slot
Glider Master WWAN
Rugged PDA
Quick Start Guide
General Safety Rules
Please read this Guide thoroughly and carefully before you start using this device.
Use only the components and accessories supplied by the manufacturer for Glider Master
Glider Master WWAN you are using.
Do not attempt to disassemble Glider Master /Glider Master WWAN, as it does not contain
parts that can be repaired by the user. Any tampering will void the warranty.
When replacing the battery pack or at the end of life of Glider Master /Glider Master WWAN,
disposal must be performed in compliance with the laws in force in your jurisdiction.
Do not submerge Glider Master /Glider Master WWAN in any liquid ( water, detergent, ---etc ).
Content in the Package
Glider Master /Glider Master WWAN (device)
USB Charge/Communication Cable & Quick Charge compliant Power Adapter
Battery Box (With Rechargeable Battery)
Hand Strap
Quick Start Guide
General View
Side View
Keypad View
Charging Instructions
Charging Time
Charging time required will vary depending on the actual application of Glider Master /Glider
Master WWAN and the condition of Glider Master battery pack.
Glider Master /Glider Master WWAN is shipped with Lithium-ion battery but not fully
charged. Please fully charge it before the 1st time use under the environmental temperature
of 0℃～45℃.
Battery Installation
Glider Master battery pack is not initially fully charged. After installing the battery pack,
please charge it via the USB cable or via the charging cradle.
As default, the battery pack is disconnected at the factory to avoid damage caused by
excessive draining.
Annual replacement of the battery pack can avoid possible risks or abnormalities and
ensures maximum performance.
Avoid storing batteries for long periods in a state of full charge or very low battery level
status
.
We recommend charging the spare battery pack every two to three months to keep its
charge at a moderate level to maximize battery life.
Please remove the hand strap first when opening the battery compartment.
Please push the battery Cover Lock Switch to Open position then remove the battery cover.
Charging via USB Cable
You can use the provided USB charge & communication cable together with the Quick
Charge compliant Power Adapter in the standard package to charge Glider Master /Glider
Master WWAN from a power outlet.
Charging via Charging Cradle
You can sit Glider Master /Glider Master WWAN on the cradle and the cradle plugged in
with the power adapter enclosed in the cradle package to charge Glider Master /Glider
Master WWAN from a power outlet.
SD / SIM Card installation
Please do not stock this device under conditions of high temperature
which will cause the battery to become hot, fire, or broken etc. leading to
failure and safety concerns.
When the charging time is noticed longer than standard required
( CHARGING LED , RED, is still ON ), please stop charging immediately.
Please charge this device in place without any water-spray or moisture.
If there is any dust on the plug of AC adapter, please wipe clean using
dry cloth to avoid fire accident.
Please do not drop this device with strong strike and impact.
Please do not put any heavy weight on top of this device as it might
cause device enclosure crack then lead to cutting injury.
Please do not use wet hand to pull out the AC adapter which might
cause electric shock.
Please do not use Glider Master AC adapter on any other different
devices.
Please do not put the device into water which may cause short-circuit or
fire.
Please do not put this device in place close to open fire.
If the power or USB cable is seriously twisted or broken, please stop
using immediately or it may cause electric shock, short-circuit, or fire.
Please stop using immediately when there is any unusual smell or
overheat during charging or operation.
Please stop using immediately when there is any liquid or dew on the
device.
Please do not use the AC adapter outdoor. Please do not wrap the
AC adapter with cloth which will block heat dissipation and will
cause electric shock or fire.
Except charging, please remove the AC adapter plug from the wall
AC outlet socket or it will cause fire accident.
To prevent possible hearing damage.
Do not listen at high volume levels for long periods.
Head: 0.328W/kg@ 10g (CE)
Body:1.6W/kg@ 10g (CE)
Head: 0.288W/kg@ 10g (CE)
Body:0.320W/kg@ 10g (CE))
Radio Type
Description
Frequency
Maximum Output
Bluetooth
Bluetooth BR+EDR
2400~2483.5 MHz
4dBm
Bluetooth 4.0-LE
2400~2483.5 MHz
4dBm
WLAN
2.4GHz
2400~2483.5 MHz
17dBm
5GHz
5150~5350 MHz
21dBm
5470~5725 MHz
22dBm
GSM
GSM 900
880~915 MHz
32dBm
GSM 1800
1710~1785 MHz
30.5dBm
WCDMA
WCDMA Band I
1920~1980 MHz
24dBm
WCDMA Band VIII
880~915 MHz
24dBm
LTE
LTE Band 1
1920~1980 MHz
23dBm
LTE Band 3
1710~1785 MHz
23dBm
LTE Band 7
2500~2570 MHz
23dBm
LTE Band 8
880~915 MHz
23dBm
LTE Band 20
832~862 MHz
23dBm
LTE Band 38
2570~2620 MHz
24dBm
LTE Band 40
2300~2400 MHz
23dBm
other
NFC
13.56 MHz
GPS
1575.42 MHz
Radio Type
Description
Frequency
Maximum Output
Bluetooth
Bluetooth BR+EDR
2400~2483.5 MHz
4dBm
Bluetooth 4.0-LE
2400~2483.5 MHz
4dBm
WLAN
2.4GHz
2400~2483.5 MHz
17dBm
5GHz
5150~5350 MHz
21dBm
5470~5725 MHz
22dBm
other
1. Turn off Glider Master /Glider Master WWAN or put it in Battery Swap Mode
2. Remove the battery cover
3. Remove the battery pack by pulling the tab on the end of the battery
4. Lift the retaining door
5. Please see the Back View
6. Insert the micro SD card into the left slot
7. Insert the SIM card into the right slot
8. Insert the battery pack into the battery compartment.
9. Restore the battery cover and lock the battery cover lock switch
Imager data capture
To scan a barcode label:
1. Point the scan window at the barcode.
2. Tap Scan on the screen or press one of the scan buttons on Glider Master /Glider Master
WWAN. The imager will project a laser aiming pattern. The aiming pattern is used to position
the barcode or object within the field of view of the imager.
3. Center the barcode in any orientation within the aiming pattern. Ensure the entire barcode is
within the rectangular area formed by the brackets in the aiming pattern, then either wait for
the timeout or release the scan key to capture the image. A red beam will illuminates the
barcode to capture and decode it.
Laser Safety
The following information applies to the Imager Aiming System. The laser light is visible to the
human eye and is emitted from the window indicated in the figure below.
LASER LIGHT - DO NOT STARE INTO BEAM CLASS 2 LASER PRODUCT MAX OUTPUT
RADIATION 1 mW COMPLIANT WITH EN 60825-1 (2007)
For Safe Use Concern, Please Pay Special Attention on the
Following Notices:
The manufacturer has taken safety as first priority during design stage. To avoid any potential
accident, please be cautious on the following alert points:
Important Notices When Using
Before replacing battery pack due to failure, shortened life, or any other unusual
behavior, please confirm if the device has been used correctly and there has no user
operation issue involved.
It is possible there will be some missed data or interference encountered during the
wireless transmission. It is not a situation can be controlled by the manufacturer.
Please do not use any alcohol, benzene, organic solvent, cleaner liquid, or steel-wool
on the surface of this device.
Please do not scratch the surface of Scan Window in any way as which will cause
problem on barcode scanning.
Bluetooth
This device is designed based on Bluetooth standard specifications but compatibility
problem might be encountered if trying to connect with other Bluetooth device.
Before using this device, please make sure there is no other wireless device been
operated in the same application area within short distance as that may cause wireless
signal interference.
Signal Interference From TV or Radio
Sometimes data transmission or receiving might be failed due to signal interference
from TV or radio nearby.
Audio Safety
European Union Regulatory Notes
1. Requirements in AT/BE/BG/CZ/DK/EE/FR/DE/IS/IE/IT/EL/ES/CY/LV /LI/LT/LU/HU
/MT/NL/NO/PL/PT/RO/SI/SK/TR/FI/SE/CH/UK/HR.5150MHz~5350MHz is for indoor
use only
2. Hereby, BitaTek CO., LTD declares that the radio equipment type Glider Master /Glider
Master WWAN is in compliance with Directive 2014/53/EU
The full text of the EU declaration of conformity is available at the following internet
address: www.bitatek.com.tw
Japan Note:
For more Regulatory information and compliance marks (E-labels) about MIC/VCCI,
please refer to your device via the following steps: Settings > About > Regulatory
Information.
SAR Compliance (For Glider Master WWAN model)
SAR Information (for European Union):
Body - worn Operation
This device was tested for typical body-worn operations. A minimum separation distance must
be maintained between the user’s body and the handset, including the antenna:
0.5 cm to comply with the RF exposure requirements in Europe Third-party belt-clips, holsters
and similar accessories used by this device should not contain any metallic components. Bodywarn accessories that do not meet these requirements may not comply with RF exposure
requirements and should be avoided.
Power and Frequency Ranges
For Glider Master WWAN model
For Glider Master model
This device is restricted to indoor use when operating to the 5150 to 5350 MHz frequency
range.
SAR Compliance (For Glider Master model)
SAR Information (for European Union):
This device is restricted to indoor use when operating to the 5150 to 5350 MHz frequency
range.
Loading...