Bissell 2303, 2305, 2306, 2328 Quick Start Guide
QUICK START GUIDE
CROSSWAVE® PET SERIES
Quick Start Usage Instructions
SMALL AREA CLEANING
click
LARGE AREA CLEANING
2303, 2305, 2306, 2328 SERIES
WARNING
Refer to the enclosed user guide for complete
instructions and important safety notices.
HARD FLOOR
BUTTON
1. First, insert the handle
at the top of the body
of the machine until
you hear a click.
161-3889 10/17 RevA
2. For small area cleaning (<350 sq ft), fill the
clean water tank with warm tap water to
the first water fill line. Then add formula to
the first formula fill line.
For large area cleaning (up to 700 sq ft),
fill the clean water tank with warm tap
water to the second water fill line. Then
add formula until you get to the second
formula fill line. Screw the cap back onto
the clean water tank.
3. On the back of the
machine, align clean
water tank with the
grooves and slide tank
into place until you
hear a click.
RUG
BUTTON
4. Turn machine on by
selecting the type
of floor you will be
cleaning. For hard
floors, choose the
HARD FLOOR button
and for area rugs push
the RUG button.
5. Each time you use the
product, hold the solution
trigger for 10 seconds to
prime the system with
cleaning solution before
you begin cleaning. When
you hold the trigger, LED
lights will illuminate.
When solution is flowing,
you will see bubbles
forming at the edges of
the brush roll window.
You are ready to start
cleaning with your
BISSELL® CrossWave® Pet!
QUICK START GUIDE
Getting the Best Clean from Your CrossWave® Pet
reference the User Guide or visit
For further instructions
www.BISSELL.com
For everyday Cleaning:
HARD FLOORS & RUGS
Choose the setting that matches the floor type you
will be cleaning. Prime the system first by holding the
solution spray trigger for 10 seconds. When you’re
ready to clean, hold the trigger on both the forward
and backward pass for great cleaning results.
10 Seconds
HARD FLOOR
RUG
Dirty Machine?
EASY CLEAN UP
For best results, flush the unit using the Rinse Tray. Then, rinse
the dirty water tank, strainer, brush roll and brush chamber. After
allowing your machine and components to dry completely,
reassemble everything, making sure the machine’s brush window is
securely in place before using your machine next time.
CLEAN UP
DRY
REASSEMBLE
Tips & Tricks
›› On hard floors, there is no need to
vacuum before using CrossWave®
Pet. This machine vacuums and
washes at the same time.
›› To dry floors faster, release the
trigger and run the machine over the
floor without dispensing solution.
›› When cleaning area rugs, remove any
excessive mud from your area rug prior
to using your CrossWave® Pet.
›› When cleaning excessively dirty or
muddy hard floors, or if the brush
roll looks dirty, use the Easy Clean
Storage Tray to rinse the brush roll
before cleaning your area rugs.
›› For overly challenging and stuck-
on messes on hard floors, activate
the RUG mode and hold your
CrossWave® Pet over the mess.
Using short passes while holding
the trigger allows the multi-surface
brush to go to work.
Loading...