Bissell 2260 User Manual

POWERLIFTER® SWIVEL PET

___________

USER GUIDE

2260 SERIES

More of a video person? Look for this icon and go online for an instructional how-to video at

www.BISSELL.com

IMPORTANT SAFETY INSTRUCTIONS

READ ALL INSTRUCTIONS BEFORE USING YOUR UPRIGHT VACUUM.

Always connect to a polarized outlet (one slot is wider than the other). Unplug from outlet when not in use and before conducting maintenance. When using an electrical appliance, basic precautions should be observed, including the following:

WARNING

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY:

» Do not leave vacuum cleaner when it

is plugged in. Unplug from outlet when not in use and before servicing.

» Do not use outdoors or on

wet surfaces.

» Do not allow to be used as a toy.

Close attention is necessary when used by or near children.

» Do not use for any purpose other

than described in this User’s Guide. Use only manufacturer’s recommended attachments.

» Do not use with damaged cord or

plug. If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, have it repaired at an authorized service center.

» Do not pull or carry by cord, use

cord as a handle, close a door on cord, or pull cord around sharp edges or corners. Do not run appliance over cord. Keep cord away from heated surfaces.

» Do not unplug by pulling on

cord. To unplug, grasp the plug, not the cord.

» Do not handle plug or vacuum

cleaner with wet hands.

» Do not put any object into

openings. Do not use with any opening blocked; keep openings free of dust, lint, hair, and anything that may reduce air flow.

» Keep hair, loose clothing, fingers,

and all parts of body away from openings and moving parts.

» Turn off all controls before

plugging or unplugging vacuum cleaner.

» Use extra care when cleaning

on stairs.

» Do not use to pick up flammable or

combustible materials (lighter fluid, gasoline, kerosene, etc.) or use in areas where they may be present.

» Do not use vacuum cleaner in an

enclosed space filled with vapors given off by oil base paint, paint thinner, some moth-proofing substances, flammable dust, or other explosive or toxic vapors.

» Do not use to pick up toxic

material (chlorine bleach, ammonia, drain cleaner, etc.).

» Do not pick up anything that is

burning or smoking, such as

cigarettes, matches, or hot ashes. » Do not use without filters in place. » Do not pick up hard or sharp objects

such as glass, nails, screws, coins, etc. » Use only on dry, indoor surfaces. » Keep appliance on a level surface. » Do not carry the vacuum cleaner

while it is running. » Unplug before connecting or

disconnecting the Pet TurboEraser®

Tool.

SAVE THESE INSTRUCTIONS

This model is for household use only.

WARNING

››

Before using your vacuum, make sure the Dirt Tank is in locked position and that all ﬁlters,

both pre- and post-ﬁlters, are in place. DO NOT operate your vacuum without these ﬁlters. ›› Plastic ﬁlm can be dangerous. To avoid danger of suocation, keep away from children. ›› Do not plug in your vacuum UNTIL you are familiar with all instructions and operating

procedures. ›› To reduce the risk of electrical shock, turn power switch o and disconnect polarized

plug from electrical outlet BEFORE performing maintenance or troubleshooting checks.

THIS APPLIANCE HAS

Hot

A POLARIZED PLUG

To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install a proper outlet. Do not change the plug in any way.

www.BISSELL.com

Neutral

Thanks for buying a BISSELL vacuum!

We love to clean and we’re excited to share one of our innovative products with you. This guide has important instructions on how your new vacuum works, including using (page 6), maintaining (pages 7-9), and if there is a problem, troubleshooting (page 10).

In just a few simple assembly steps, you’ll be ready to vacuum. Flip to page 5 and let’s get started!

What’s In The Box?

6. 7. 8.

2. 3. 4.

Safety Instructions...........2

Product View ................4

Assembly ...................5

1. Vacuum Base

2. Handle

3. Hose

4. 2 Screws (taped to Handle)

10.

5. Lower Cord Wrap

6. Extension Wand

7. Crevice Tool (stored inside Extension Wand)

8. Pet TurboEraser® Tool

9. Pet Hair Eraser® Tool

10. Febreze® BISSELL® Style 1214 Filter

NOTE: Not all accessories come with every model. Be sure to check the carton for additional tools.

Troubleshooting ............10

Parts & Supplies ............10

Warranty ....................11

Operations ..................6

Maintenance & Care .......7-9

Service ......................11

Product Registration ........12

www.BISSELL.com

Product View

Adjustment

WARNING

Do not plug in your vacuum until you are familiar with all instructions and operating procedures.

Handle

Stretch

Hose

Release Button

Tank

Carry Handle

Pre-Motor

Filter

(not shown)

Dirt Tank

Swivel

Steering

Height

Suction Indicator

Extension

Wand

Pet Hair Eraser® Tool

Lifetime Post-Motor Filter

Recline

Pedal

Edge Bristles

NOTE: The Crevice Tool is stored inside the Extension Wand.

Power Pedal

www.BISSELL.com

Assembly

The only tool you will need to assemble your vacuum is a Phillips-head screwdriver.

Place the Upper Handle onto the base and push it down. Then attach the handle with the 2 screws taped to the handle in a plastic bag.

Wrap hose up and around the Hose Wrap on the handle. Slide end of hose into vacuum base.

Insert the Lower Cord Wrap and turn it to the right to lock in place.

To install the optional Febreze® Filter, press the tank release button and pull tank from vacuum. Lift tab to access and remove Foam Filter from lid.

Insert the Stretch Hose end into the back of the vacuum and twist right to lock in place.

click

Replace Foam Filter with Febreze® Filter. Close tank lid. Place tank back on vacuum and press firmly until you hear a “click.”

NOTE: The Powerfoot will not suction properly unless the hose is ﬁrmly attached.

Now, put your accessory tools on the vacuum and you’re ready to go!

Extension Wand

Pet TurboEraser® ToolPet Hair Eraser® Tool

(Crevice Tool stores inside)

Febreze and Febreze logo is a registered trademark of The Procter & Gamble Company, Cincinnati, Ohio used under license by BISSELL Homecare, Inc.

www.BISSELL.com

Power On & Settings

Press the red power button with your foot to turn the vacuum ON and once again to turn your vacuum OFF .

Turn the dial on the foot of the vacuum to the desired setting. If the dial is difficult to turn, tilt the vacuum back slightly to take the weight off the foot while turning.

Lowest setting – For low pile carpet or bare floors. To pick up debris, it may be necessary to move up one setting.

Medium setting – For medium pile carpet. Highest setting – For high pile and most shag carpet.

Press the Recline Pedal and pull handle back towards you.

TIP: For optimal carpet cleaning performance, adjust to the lowest practical setting. If your vacuum is difficult to push, adjust to the next higher setting.

WARNING

To reduce the risk of injury from moving parts while the vacuum is turned on, always move the vacuum via the rolling wheels by using the upper handle at the back of the vacuum. Do not carry the vacuum while it is running. Always place vacuum on ﬂoor with handle in upright position when using tools.

NOTE: Rotating ﬂoor brush continues to rotate while tools are in use. Never place ﬁngers under the vacuum when it is running. Never place Powerfoot on furniture or uneven surfaces. Do not place vacuum close enough to objects to pull into rotating brush.

NOTE: Certain carpets and low humidity conditions may generate small static discharges. Static discharges are harmless and are not associated in any way with the main power supply.

www.BISSELL.com

Empty the Dirt Tank

WARNING

To reduce the risk of electric shock, turn power switch o and disconnect polarized plug from electrical outlet before performing maintenance or troubleshooting checks.

Empty once tank is full.

Hold the Dirt Tank over a trash container. Press the bottom release button to empty. Once empty, close the lid.

Press the Tank Release Button and pull out to remove Dirt Tank.

Twist Cyclone left and pull down to remove from tank.

Clean Cyclone with warm water and mild detergent. Let Cyclone dry completely before replacing. To replace, fit into place and twist to the right.

NOTE: The Dirt Tank may be washed in warm water with a mild detergent. Make sure it is completely dry before replacing.

click

After emptied, place tank back on vacuum and press firmly until you hear “click.”

www.BISSELL.com

Clean the Pre-Motor Filter

WARNING

To reduce the risk of electric shock, turn power switch o and disconnect plug from electrical outlet before performing maintenance or troubleshooting checks.

WARNING

Do not operate vacuum with damp or wet ﬁlters or without all ﬁlters in place.

Press the Tank Release Button and pull out to remove Dirt Tank.

Allow filter to air dry completely before placing back into the tank lid.

Remove Foam Filter from lid. Hand wash in warm water and rinse well; mild detergent may be used if desired.

click

Return tank back on vacuum and press firmly until you hear “click.”

Maintain the Pet TurboEraser® Tool

Twist gray collar counter-clockwise, until slot appears, then separate faceplate.

www.BISSELL.com

Remove Brush Roll, Belt, and Paddle Wheel. Inspect for damages and replace if necessary.

To reassemble, align two clips on each end of Paddle Wheel with Belt on and pop back into place. Place Brush Roll with Belt back in. Faceplate will not close properly if all parts are not aligned correctly.

+ 16 hidden pages