Bissell 2019 User Manual

POWERLIFTER
BAGGED
Vacuum
___________
USER GUIDE
2019 SERIES
www.BISSELL.com/ videos
www.BISSELL.com
2
IMPORTANT SAFETY INSTRUCTIONS
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY:
» Do not leave vacuum cleaner
when it is plugged in. Unplug from outlet when not in use and before servicing.
» Do not use outdoors or on
wet surfaces.
» Do not allow to be used as a toy.
Close attention is necessary when used by or near children.
» Do not use for any purpose other
than described in this User’s Guide. Use only manufacturer’s recommended attachments.
» Do not use with damaged cord or
plug. If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, have it repaired at an authorized service center.
» Do not pull or carry by cord, use
cord as a handle, close a door on
cord, or pull cord around sharp edges or corners. Do not run appliance over cord. Keep cord away from heated surfaces.
» Do not unplug by pulling on
cord. To unplug, grasp the plug, not the cord.
» Do not handle plug or vacuum
cleaner with wet hands.
» Do not put any object into
openings. Do not use with any opening blocked; keep openings free of dust, lint, hair, and anything that may reduce air flow.
» Keep hair, loose clothing, fingers,
and all parts of body away from openings and moving parts.
» Turn off all controls before
plugging or unplugging vacuum cleaner.
» Use extra care when cleaning
on stairs.
» Do not use to pick up flammable
or combustible materials (lighter fluid, gasoline, kerosene, etc.) or use in areas where they may
be present.
» Do not use vacuum cleaner in an
enclosed space filled with vapors given off by oil base paint, paint thinner, some moth proofing substances, flammable dust, or other explosive or toxic vapors.
» Do not use to pick up toxic
material (chlorine bleach, ammonia, drain cleaner, etc.).
» Do not pick up anything that is
burning or smoking, such as
cigarettes, matches, or hot ashes. » Do not use without filters in place. » Do not pick up hard or sharp
objects such as glass, nails, screws,
coins, etc. » Use only on dry, indoor surfaces. » Keep appliance on a level surface. » Do not carry the vacuum cleaner
while it is running. » Unplug before connecting or
disconnecting the TurboEraser®
Tool
READ ALL INSTRUCTIONS BEFORE USING YOUR UPRIGHT VACUUM.
Always connect to a polarized outlet (one slot is wider than the other). Unplug from outlet when not in use and before conducting maintenance. When using an electrical appliance, basic precautions should be observed, including the following:
This model is for household use only.
SAVE THESE INSTRUCTIONS
THIS APPLIANCE HAS A POLARIZED PLUG
To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install a proper outlet. Do not change the plug in any way.
Hot
Neutral
WARNING
›› Plastic film can be dangerous. To avoid danger of suocation, keep away from children.
›› Do not plug in your vacuum cleaner UNTIL you are familiar with all instructions and
operating procedures.
›› To reduce the risk of electrical shock, turn power switch o and disconnect polarized
plug from electrical outlet BEFORE performing maintenance or troubleshooting checks.
www.BISSELL.com
3
Crevice
Tool
User
Guide
Hose
Dusting
Brush
What’s in the Box?
Base Unit
Upper Handle
Extension
Wand
2 Screws
Thanks for buying a BISSELL vacuum!
We love to clean and we’re excited to share one of our innovative products with you. We want to make sure your vacuum works as well in one year as it does today, so this guide has tips on using (page 6-7), maintaining (pages 7-9), and if there is a problem, troubleshooting (page 10).
Safety Instructions...........2
Product View................4
Assembly ...................5
Operations ................6-7
Maintenance & Care .......7-9
Troubleshooting ............10
Warranty ....................11
Service ......................11
Product Registration........12
Parts & Supplies ............12
NOTE: Standard accessories may vary by model.To identify what should be included with
your purchase, please refer to the “Carton Contents” list located on the carton top flap.
Febreze®
Style 7 Bag
(2 included)
Pet Hair Eraser®
Tool
Pet TurboEraser®
Tool
www.BISSELL.com
4
3
4
12
Product View
1
5
13
14
15
8
16
17
18
11
7
6
9
10
1 Upper Handle 2 Pet TurboEraser® Tool 3 Carry Handle 4 Bag Door Release Button 5 Washable Pre-Motor Filter 6 Upper Quick Wrap Release™ Cord Wrap 7 Lower Cord Wrap 8 Power Cord 9 Cord Clip 10 Hose Clip
11 Crevice Tool (stored in Extension Wand) 12 Extension Wand 13 Dusting Brush 14 Hose Wand 15 Power Switch Pedal 16 Handle Recline Pedal 17 Foot Hose 18 Product Rating Label & Serial Number 19 Pet Hair Eraser® Tool
2
19
NOTICE: Two Febreze® Pet Odor Eliminator bags are included with your vacuum.
Febreze and related trademarks are owned by The Procter & Gamble Company, Cincinnati, Ohio, used under license by BISSELL Homecare, Inc.
www.BISSELL.com
5
1
Assembly
WARNING
Do not plug in your vacuum until you are familiar with all instructions and operating procedures.
Place the upper handle onto the base and push it down. Then attach the handle with the 2 screws that are taped to the handle in a plastic bag.
Wrap the power cord around the cord wrap clips and clip the end of the plug to the power cord.
Now wrap the hose through the hose clip and connect the hose wand to the foot hose down at the bottom of the vacuum.
Next, insert the end of the hose into the back of the vacuum and twist to lock it into place.
Put your accessory tools on the vacuum and you’re ready to go!
NOTE: The crevice tool can be found inside the extension wand. You can remove it to use it and put it back to store it neatly out of your way when you’re finished.
Dusting
Brush
Extension
Wand
4
5
3
2
To experience freshness as you vacuum, locate the Febreze® scent tag at the bottom of the vacuum bag. Carefully pull the tab along the perforated lines in the center of the scent tag.
The only tool you will need to assemble your vacuum is a Phillips screwdriver.
NOTE: The Pet Hair Eraser® Tool does not store on-board.
NOTE: Only a portion of the overwrap should be removed.
Pet
TurboEraser®
Tool
www.BISSELL.com
6
Power Switch
Height Adjustment
Press the recline pedal to lean your vacuum back for cleaning. To get even lower, press the recline pedal a second time. When you’re finished, lean it all the way back up to lock it into the upright position.
You can easily raise or lower your vacuum to adjust to different flooring types. Simply turn the knob towards the desired flooring type. If your vacuum becomes too difficult to push, just move to a higher setting.
Press the red power switch with your foot to turn on the unit.
Press it again to turn your vacuum off when you’ve finished cleaning.
NOTE: Some frieze and berber carpets have long delicate fibers or threads that may be damaged by rotating brush. Repeated strokes in the same area may enhance this condition.
WARNING
Before using you vacuum, make sure the bag and filter are in
place and the bag door is secure. DO NOT operate your vacuum without the bag and filter.
WARNING
The rotating floor brush continues to rotate while tools are in use. To reduce the risk of injury from moving parts, always move the cleaner with the carry handle at the front of the unit. Always place the cleaner on the floor with the handle in the upright position when using tools. Never place your fingers under the cleaner when it is running. Never place the powerfoot on furniture or uneven surfaces. Do not place vacuum cleaner close enough to objects to pull them into rotating brush.
1
2
NOTICE
The floor brush will continue to rotate while you use your vacuum for above floor cleaning. To prevent carpet damage, do not lean on the vacuum or let the powerfoot tilt forward.
www.BISSELL.com
7
Tools
Changing the Bag
Parts & Supplies
For Parts and Supplies, go to www.BISSELL.com and enter
your model number in the search field.
Remove the old bag by grabbing the dust bag collar and pull towards you to remove it from the vacuum. Then carefully throw it away.
As you use your PowerLifter Pet vacuum, eventually your bag will get full and need to be replaced. To check it, open the bag door and inspect the bag. If the bag is full, it is time to replace it.
Grab a new bag, grasp the collar and press it onto the connector tube. Tuck the bag into the bag compartment. If it’s a Febreze® bag, open the wrapper on the scent tag by pulling along the perforated line to release the Febreze® freshness. Put the bag door back on and you’re finished.
Your new PowerLifter™ Pet vacuum not only does a great job on your floors, it also comes with a complete set of accessory tools to make your above floor cleaning jobs easier. Just put your vacuum in the upright position, pick the accessory tool that best fits your needs and attach it to the end of your hose. You’re ready to clean base boards, curtains, upholstery and much more.
1
32
Febreze® and related trademarks are owned by The Procter & Gamble Company, Cincinnati, Ohio and used under license by BISSELL Homecare, Inc.
Crevice Tool
(store inside
extension wand)
Dusting
Brush
Extension
Wand
Pet Hair Eraser®
Tool
(does not store on unit)
Pet TurboEraser®
Tool
www.BISSELL.com
8
WARNING
To reduce the risk of electrical shock, turn power switch o and disconnect polarized plug from electrical outlet before performing maintenance or troubleshooting checks.
Cleaning the Pre-Motor Filter
Remove the bag door cover by pressing the latch down and pulling the door off.
Remove the pre-motor
filter. Clean it with warm
water. Once it’s clean and
dry, put it back into the
unit.
WARNING
Do not operate the vacuum with damp or wet filters, without the bag in place, or with the bag door missing. Allow components to dry before reassembling the unit.
Locate the filter on the left side at the bottom of the bag compartment. You may need to lift the bag out of the way to find it.
1
32
Helpful Tips
Easily carry the vacuum up and down stairs or from room to room using the vacuum carry handle. The vacuum carry handle is located on the front of the vacuum above the vacuum bag latch.
While vacuum is in use, fasten the power cord to the cord clip located on the back of the handle above the hose clip. This will help to keep the cord out of your way as you vacuum.
1
2
Loading...
+ 16 hidden pages