Bissell 16N5F, 16N59 Quick Start Manual

Quick tips

Maximizing performance

1. Empty dirt container as dirt reaches "full" line

2. Check pre-motor and Airetight lter monthly; clean and replace as needed

HEPA

Quick Start

users guide

BISSELL is happy to be of service.

visit the website for helpful instructions at

www.bissell.com

PLEASE DO NOT RETURN THIS PRODUCT TO THE STORE

PLEASE KEEP FOR FUTURE REFERENCE

Rotating brush information

1. Brush will only activate when brush switch is on and vacuum is reclined

2. It is recommended to turn off brush switch when vacuuming frieze carpet

Telescoping extension Wand

1. Twist collar to "unlock" and extend wand, lock into place

2. To retract, twist to unlock

TurboBrush Tool

1. For maximum cleaning; avoid heavy pressure which could stop the rotating brush

16N5 SERIES

For complete users guide visit www.bissell.com

a. Vacuum base b. Handle

(with hardware packet)

c. Hose rack d. 14 ft Hose e. TurboBrush

a. d.

Tool

f. Combination Brush g. Telescoping Extension Wand

Crevice Tool

(inside Extension wand)

h. 2 Long Screws and 2 Short Screws

For additional tips and troubleshooting

Please refer to User's Guide

Earn BISSELL rewards! Register your product today!

Visit: www.bissell.com

BISSELL Homecare, Inc. P.O. Box 1888

110-4368

Grand Rapids, MI 49501

What’s needed for assembly: Phillips head screw driver

Assembly

Ready to vacuum

1. Slide handle onto vacuum base, tighten with longer screws

2. Attach hose rack to back of vacuum. Feed power cord through center opening

3. Tighten with shorter screws

4. Identify tabbed end of hose and lock into left opening

5. Feed opposite end of hose into holder on lower right, press down rmly to engage the white suction diverter

6. Slide crevice tool into extension wand and store in clip

7. Snap combination tool into storage clip

8. Attach TurboBrush Tool to handle

1. 1.

4. 4.

2. 2.

5. 5. 6.

3. 3.

1. Adjust height for carpet or bare oor

2. Plug into electrical outlet and turn power on by pushing the power button

3. Step on handle release to lower into cleaning position

4. Be sure to press rotating brush switch on located next to power button

5. Attach tool for above oor and stair cleaning

6. Empty dirt cup after each use

located on upper handle

7. 8.

Your assembly is now complete.

For complete users guide visit www.bissell.com