Bischoff & Bischoff GmbH | 08.08.2017
EN
1110
Rollator B / B XXL | Rollator Rollator | Rollator B / B XXL|
4. Assembly/adjustments
4.1. Fitting push handles
• Remove the marked protective sleeves from the tube (Fig 4).
• Insert the push handles into the handlholds and fix them using the
wing screw.
• Please observe the minimum insertion depth (knurled area)
(section 4.5).
4.2. Unfolding
• Position the rollator in the travel direction.
• Release the locking brakes (see sec. 4.5).
• Tip the B+B rollator towards yourself until the load is taken off the
steered wheels and press the handles downwards at the same time
with a gentle jolt.
• To lock the folding mechanism, now fold the seat plate tight to
your seat (Fig. 4). This locks the rollator.
4.3. Folding
• Position the rollator in the travel direction.
• Activate the locking brakes.
Note that the rollator may suddenly fold up when
the lever is activated.
• Hold the rollator firmly with both hands and tilt it by pulling it
towards you.
• For unlocking, take one hand off the handle and use it to activate
the lever of the auto-lock system (Fig. 7). Ensure that neither body
parts nor pieces of clothing become pinched during the folding
process.
• To fold the rollator up completely, pull the handles towards you.
4.4. Attach basket and tray
• The rollator is unfolded. Activate the locking brakes.
• Position yourself against the travel direction in front of the rollator.
• Simply hang the basket onto the hooks attached to the front frame
tubes (Fig. 8)
• To remove the basket, simply grasp the carrying handle and pull it
up and off.
• Place the tray onto the seat from above in such a way that the four
plastic pins of the tray fit into the holes of the seat (Fig. 9).
4.5. Adjusting the push handles
• The rollator is unfolded. Activate the locking brakes.
• Turn the plastic lever on the handholds until the handles move
freely (Fig. 10).
• Position yourself behind the B+B rollator and allow your arms to
hang loosely downwards.
• Now adjust the push handles so that they are located at the height
of your wrists. Select the nearest hole in the push tube.
• Retighten the plastic lever after the adjustment procedure. Observe
the minimum insertion depth. (knurled area)
• Repeat this procedure on the other side.
• Check to make sure that both the push handles are at the same
height.
4
5
7
6
8
9
10
11