C
B
A
Step 2
G
D
E
F
H
K
J
I
L
Step 3
G
F
E
D
RECTANGLE COCKTAIL TABLE
1 pc
C
4 pcs
B
1 pc
A
e
Be sure to check all packing material carefully for small parts, which may have come loose inside the carton during shipment.
Step 1: Remove both drawers from the Table Top and lay them aside. Place the Table Top (A) upside down on a soft non-abrasive
surface.
Step 2: Attach the Legs (B) to the underneath side of the Table Top with the 5/16" x 2 " long Bolts (D), Spring Washers (E) and Flat
Washers (F). Do not fully install Bolts until after Shelf is assembled. Attach the Bottom Shelf (C) to the Legs with the same Bolts
and Washers as in previous Step. Tighten all Bolts using the Allen Wrench ( G).
Note: If the straight Wrenches (M & N) are used in a power driver, use care to prevent Bolts from being over tightened and possibly damaging
parts.
If the casters will be used: Attach the Wood Blocks (H) to the underneath side of the Bottom Shelf with the 1/4 " x 1-1/2 " long
Bolts ( I), Spring Washers ( J ) and Fla t Washers ( K). Tighten all Bolts using the Allen Wrench ( L ).
To prevent possible damage to some types of flooring, never roll casters on unprotected hardwood or vinyl flooring.
Step 3: Carefully set the Table upright and re install the drawer s back in to the Table Top.
Bottom Shelf
Legs
Table Top
Components and Hardware List
ff
Oc Tables
Page 1 of 1
12 pcs.
F
12 pcs.
E
5/16" Flat
Washer
5/16" Spring
Washer
M5/16" x 2"
Allen Head Bolt
12 pcs.
1 pc.
G
D
5mm Allen
Wrench
I
8pcs.
M1/4" x 1-1/2"
Allen Head Bolt
8 pcs.
J
1/4" Spring
Washer
8 pcs.
K
1/4" Flat
Washer
1 pc.
L
4mm Allen
Wrench
H
Wood Block with
Caster
4 pcs.
5mm x 4"
Wrench
1 pc.
M
4mm x 4"
Wrench
1 pc.
N
Loading...