BioChef KT-BL-BC-AS-AU-BZ, KT-BL-BC-AS-AU-GR User Manual

Astro Vacuum

Blender

MANUAL AND RECIPE BOOK

UNLOCK THE

GOODNESS

FEEL THE

GREATNESS

5

PLEASE READ AND SAVE THESE INSTRUCTIONS

1. Please read all the instructions before use.

2. Before plugging in the appliance, check that the electrical rating shown on the
rating plate corresponds with your household electricity supply.

3. Close supervision is necessary when the appliance is used near children or
incapacitated persons.

4. To avoid and protect against the risk of electrical shock, never immerse the
blender in water or other liquid. If there is water inside the unit base, please
contact your authorised service centre.

5. Unplug from outlet when not in use and before cleaning.

6. Do not leave your blender unattended when operating.

7. Do not operate the appliance with a damaged cord or plug or if the appliance
malfunctions, is dropped or damaged in any manner. If purchased outside
Australia, please contact your dealer.

8. Do not use outdoors. The unit is designed for indoor use only.

9. Do not let the cord hang over the edge of table or counter.

10. Keep hands and utensils out of the jug container. Only use the tamper provided
with the blender. A rubber scraper or spatula may be used but only when the
blender is not running.

VACUUM

SMOOTHIES

DIPS & DRESSINGS

NUTS AND

SEEDS

6

11. The use of attachments not authorised or sold by the manufacturer for use with
this blender may void warranty.

12. Always operate with the lid and lid plug/measuring cup firmly in place.

13. If in the event the motor overheats, the temperature monitoring system will
trigger and the motor will stop. Switch off and unplug the appliance and let the
motor cool down. The motor temperature monitoring system resets after the
blender is unplugged from wall socket for 45 minutes.

14. Blades are sharp. Use caution when handling the blade. Do not attempt to
disassemble blade and blade assembly.

15. Any servicing should be performed by Vitality 4 Life or an authorised service
representative. Do not attempt to disassemble, repair or modify the appliance.

NOTICE: FAILURE TO FOLLOW ANY OF THE IMPORTANT SAFETY PRECAUTIONS IS A

MISUSE OF YOUR BLENDER AND CAN CREATE THE RISK OF SERIOUS INJURY AND
VOID YOUR WARRANTY.

To prevent overheating, never allow the blender to run

for more than two minutes at a time, as it can cause

permanent damage to the motor.

DICE

GRIND COFFEE

BEANS

ICE

7

Lid opening and closing

Jug Lid

1lt capacity
borosilicate
glass jug

Japanese Stainless Steel
Blades - RPM 22000

Unlock valuable nutrients
inside the skin, seeds
and pulp to make
phytonutrients more
bio-available to you.

700ml Vacuum Jar

with Lid

Speed setting
from 1 to 9

8

Nonslip feet

Pre-programmed
Vacuum and
Blend mode

Vacuum only
for use with
Glass Jug
or 700ml
Vacuum Jar

High
Performance
Motor

1000W

Press for
any length
of time

Operating Instructions

1. Place ingredients in glass jug (not past maximum level) and secure jug lid with
wide rim side sitting directly over jug handle.

2. Place the jug into the main blender unit with the jug handle directly over the
control panel.

3. Close lid of main blender unit and you will hear the magnets engage. Now you
are ready to begin vacuum blending.

Vacuum Blend MODE

1. Plug cord into power socket. Lights will show on front of unit and the unit will
beep. Press the ON/OFF button to turn on.

2. Press the Vacuum Blender button and then the ON/OFF button again to start the
Vacuum Blend mode. The Vacuum Blend mode will begin by removing the air
from the jug and will then blend at varying speeds until programme is finished.

3. The blender will continue to beep until ON/OFF button is pressed.

4. When you have finished blending, turn blender unit off at power socket.

5. Unlock and open lid of main blender housing. Remove blender jug. Before
opening the jug lid, lift the red valve to release the vacuum pressure. Remove jug
lid and pour to enjoy.

6. To vacuum preserve the remainder of blender jug contents, transfer into the
vacuum jar and use Vacuum (Only) mode - instructions below.

Vacuum MODE

1. Unlock and open lid of main blender housing.

2. Place ingredients into vacuum jar and attach the lid.

3. Close lid of main blender housing.

4. Press the ON/OFF button to turn on. Press Vacuum button and press ON/OFF
button again to start the Vacuum mode.

5. Programme will end when air has been optimally removed from vacuum jar.

Use the vacuum jar to preserve sauces, raw fruits and vegetables and many more
ingredients

Manual Speed / Pulse / Clean MODE

Fill jug with ingredients and place into main unit. Press ON/OFF to activate the blender.

• Manual Speed: Press the + or - to select the speed from 1 to 9. Press ON/OFF button.
Blender will operate at selected speed until ON/OFF button is pressed again to stop.

• Pulse: Press and hold the Pulse/Clean button in bursts until you have blended to the
desired consistency. Pulse mode will always operate at maximum speed setting.

To prevent overheating, never allow the blender to run

for more than two minutes at a time, as it can cause

permanent damage to the motor.

9