Binatone Electronics SH057 User Manual

Bluetooth headphone

Volume +

Volume -

MFB

Additional Operation

Power On

Hold MFB for 2 seconds from OFF status

Force Pairing

Hold MFB for 4 seconds from OFF status

Power Off

Hold MFB for 2 seconds from ON status

Receive incoming call and on-hold ongoing call

Single Press MFB

Receive second incoming call and end ongoing call

Triple Press MFB

Reject a call

Hold Vol- for 2 seconds

Voice Command (Siri/Google/Alexa)

Double Press MFB (Only available in standby
mode)

LED Indicator

Pairing

Red-blue flash

Standby

Blue flash

Charging

Red steady

Full charged

Blue steady

Battery low

Red flash

SH057

❶ Pairing:

1. Hold MFB for 4 seconds

2. Select "Escape 220" from the smartphone Bluetooth menu.

❷ Basic Operation:

❸ Charging

Fully charge before use

The device can be powered through a micro USB from any CE compliant power source that
implement the European interface as requested by EN 301 489-52.

FCC Warning Statement

Changes or modi

authority to operate the equipment. This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no guarantee that interference will not occur

in a particular installation. If this equipment does cause harmful interference to radi

which can be determined by turning the equipment off and

interference by one or more of the following measures:

ϋϋ Reorient or relocate the receiving antenna.

ϋϋ Increase the separation between the equipment and receiver.

ϋϋConnect the equipment into an outlet on a circuit different from that to which the receiver is connected.

ϋϋ Consult the dealer or an experienced radio/TV technician for help.

fications not expressly approved by the party responsible for compliance could void the user’s

o or television reception,

on, the user is encouraged to try to correct the

This device complies wit

two conditions: (1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired

operation.

h part 15 of the

FCC Rules. Operation is

subject to the following