
Standard on DL units. 14" x 10'
(356mm x 3.0m)
8" x 5' (203mm x 1.5m) flexible hose
increases exhaust distance. 8" x 5'
(203mm x1.5m) flexible steel hose
increases exhaust distance.
8” Flexible Hose P/N 791107
8” Flexible Steel Hose P/N 791106
Heavy duty spring axle trailer
designed for towing your DL. Allows
unit to be mounted for pickup from
rear.
DL35 Owner’s Manual
DL TRUCK LOADER VACUUM Owner's Manual
DL3500
Beginning Serial #: 100515001
Accessories
INTAKE EXHAUST TRAILER
Original Instructions
IMPORTANT- READ CAREFULLY BEFORE USE AND KEEP FOR FUTURE REFERENCE
Part No 792500 1 Form No F102015D

DL35 Owner’s Manual
SPECIFICATIONS AND SOUND/VIBRATION 3
INSTRUCTION LABELS 4
PACKING CHECKLIST 5
ASSEMBLY 6
OPERATION 7
MAINTENANCE 8-9
TROUBLESHOOTING 10
ILLUSTRATED PARTS & PARTS LIST 11-12
DECLARATION OF CONFORMITY 13-15
CONTENTS
Part No 792500 Form No F102015D

DL35 Owner’s Manual
Briggs and Stratton Vanguard
6 gal. (22.7 L) REMOTE TANK
Overall height with optional trailer
In compliance with 2000/14/EEC
standards
Sound at operators position
Vibration at operator position
General Conditions: Cloudy
Temperature: 79oF (26.1oC)
Wind Speed: 18 mph (29 kph)
Wind Direction: South
Humidity: 67%
Barometric Pressure: 29.8 Hg (756 mm Hg)
General Conditions: Sunny
Temperature: 86oF (17oC)
Wind Speed: 13 mph (20 kph)
Wind Direction: North
Humidity: 49%
Barometric Pressure: 29.8”Hg (756mm Hg)
SPECIFICATIONS
DL3500V
BATTERY NOT INCLUDED: REQUIRES 12 V BATTERY, 40 AH, 240 CCA MIN. U1 SERIES GROUP BATTERY FOR
PROPER FIT
SOUND
SOUND LEVEL 98 dB(a) at Operator Position
118 dB
Sound tests were conducted in accordance with 2000/14/EEC, and were performed on 6/18/07 under the conditions listed
below.
Sound power level listed is the highest value for any model covered in this manual. Please refer to serial plate on the unit for
the sound power level for your model.
VIBRATION DATA
VIBRATION LEVEL 0.11g
Vibration levels at the operator’s handles were measured in the vertical, lateral and longitudinal directions using calibrated
vibration test equipment. Tests were performed on 7-10-07 under the conditions listed below.
Part No 792500 Form No F102015D

DL35 Owner’s Manual
INSTRUCTION LABELS
The labels shown below were installed on your BILLY GOAT® DL Vacuum. If any labels are damaged or missing, replace them
before operating this equipment. For your convenience in ordering replacement labels, part numbers are included in the
Illustrated Parts List. The correct position for each label may be determined by referring to the Figure and Item numbers shown.
DANGER KEEP HANDS WARNING SECURE DANGER FLYING DEBRIS
AND FEET AWAY ITEM #39 P/N 790232 ITEM #36 P/N 810736
ITEM #37 P/N 400424
EXPLOSIVE FUEL WARNING LINER DL
ITEM 88 P/N 100330
WARNING ENGINE OVERHEAT SECURE NOZZLE DL INSTRUCT/WARN
ITEM #28 P/N 811215 ITEM #76 P/N 790232 ITEM #29 P/N 790142
ENGINE CONTROLS
Part No 792500 Form No F102015D

DL35 Owner’s Manual
READ all safety instructions before assembling unit.
TAKE CAUTION when removing the unit from the box.
PARTS BAG & LITERATURE ASSY
Warranty card P/N- 400972, Owner’s Manual P/N-792500, General Safety and Warnings manual-100294, Declaration of Conformity
P/N-791090.
Exhaust Elbow PN# 791114-S qty 1
Hose Boom Assembly PN# 791113 qty 1
Clamp T-bolt Overcenter 14” PN# 792219 qty 1
Band hose boom 14.50" PN# 792403 qty 1
Hose 14"x 10' DL PN# 792208 qty 1
Hose clamps 14" PN# 792224 Qty. 1
Nozzle intake 14” PN# 792402 qty 1
Handle Nozzle PN# 791116 qty 1
Parts Bag & Literature Assy P/N 791135
61
Screwcap 1/4-20 X 3"
ZP 8041014 qty. 1
Screwcap 5/16-18x 2
8041032 qty. 1
56
50
51
58
Washer 3/8" Flat
8171004 qty. 3
57
Eye bolt 791081 qty. 1
26
Bracket Battery DL
790230 qty. 1
77
60
59
Washer 5/16 Flat
8171003 qty. 1
Washer 5/16 Fender
8172020 qty. 2
48
27
Washer 1/4 SAE
8172007 qty. 3
Rod Battery Hold Down
790231 qty. 2
Nut Lock 5/16-18
8160002 qty. 1
Nut Lock 1/4-20
8160001 qty. 3
Nut Lock 3/8
8160003 qty. 1
NOTE: BATTERY IS NOT INCLUDED. REQUIRES
12 V BATTERY, 40 AH, 240 CCA MIN. U1 SERIES
GROUP BATTERY FOR PROPER FIT
PACKING CHECKLIST
Your Billy Goat is shipped from the factory in one carton and is completely assembled except for the exhaust elbow, nozzle,
handle loop for nozzle, hose booms, hose bands, hose coupler, hose clamps and related hardware.
PUT OIL IN ENGINE BEFORE STARTING
Part No 792500 Form No F102015D