Billionton Systems GBTIPOD Users Manual

IPod Audio Transmitter

Product shape

Quick Guide

Connecting my iPod Audio Transmitter

1. Turn on your Bluetooth Receiver device. The device which the iPod
transmitter is to connect. ie. Bluetooth Receiver or Stereo headset.

2. Plug the iPod transmitter into the headphone connector

3. Power on your iPod and press PLAY on the iPod. The iPod transmitter will
power on automatically. The iPod transmitter should enter pairing mode
indicated by the Red and Blue flashing alternately.

4. Enjoy!

*Note: This device will only work with Bluetooth receiver devices that

has “0000” or “1234” as PIN code.

iPod Audio Transmitter LED Indicator

Mode

LED

Indicator

Idle

None

Searching

last device

Red and Blue

steady

Pairing mode In connection

Red and Blue flash

alternately

Blue flash twice

every 3 seconds

Operating Procedures

1. Upon power on, the iPod transmitter will try and connect to the last paired
device for 10 seconds. If the last paired device is not found, then iPod
transmitter will automatically enter pairing mode.

2. Upon disconnection, the iPod transmitter will try to reconnect to the last
paired device. If the last paired device is not found, then iPod transmitter
will automatically enter idle mode. To power on the iPod transmitter,
please remove the iPod transmitter and plug into the iPod again.

3. During pairing mode, if devices are not found within 3 minutes, the iPod
transmitter enters idle mode. To power on the iPod transmitter, please
remove the iPod transmitter and plug into the iPod again.

Troubleshooting

IPod Transmitter is not powered on when plugged into the iPod.

z Remove the Transmitter and reinstall into the top of your iPod.
z Ensure your iPod is charged and powered on.

After connecting the Transmitter, there is no sound.

z Make sure your iPod is powered on and set to play

There is more than one Bluetooth Receiver device in the same room or
range.

z The Bluetooth iPod transmitter will pair with the Bluetooth receiver

that was turned on first or is the closet in proximity to the transmitter.
If you are paired with the incorrect receiver, turn off the power on the
receiver that will not be used